Pd-catalyzed hydrosilylation polymerization of a dihydrosilane with diyne/triyne mixed systems affording crosslinked silylene-divinylene polymers and their properties

Treatment of a dihydrosilane (methylphenylsilane, 1) with mixtures of a diyne (p- or m-diethynylbenzene, 2a or 2b) and a triyne (1,3,5-triethynylbenzene, 3a or B,B′,B″-triethynyl-N,N′,N″-trimethylborazine, 3b; 1:2:3=100:95:5, 100:90:10, 100:80:20) in the presence of Pd-PCy₃ (Cy=cyclohexyl) catalyst gave new crosslinked silylenedivinylene polycarbosilanes. In TGA the resulting crosslinked polymers tended to show higher Td₅ values and higher char yields than the corresponding linear polymers. On the other hand, UV/vis absorption spectra of the crosslinked polymers obtained in the reactions of 2a or 2b with 3a exhibited increased broad peaks around 390 nm for 2a or 360 nm for 2b. Coincidently, their fluorescence spectra showed significant increase of the emission peaks in 400-550 nm. The crosslinked polymer derived from 2a and 3b, however, showed decrease of the absorption peak around 390 nm and profound depression of fluorescence peaks in 400-550 nm.     

Hydrogen-bond-assisted isotactic-specific radical polymerization of N-isopropylacrylamide with pyridine N-oxide

Radical polymerization of N-isopropylacrylamide (NIPAAm) in CHCl₃ at low temperatures in the presence of pyridine N-oxide (PNO) was investigated. An isotactic poly(NIPAAm) with meso diad content of 61% was successfully prepared at −60 °C in the presence of a two-fold amount of PNO. Thermodynamic analysis suggested that the isotactic-specificity was entropically induced, probably due to conformational fixation near the propagating chain-end through coordination by PNO.     

Radiation tolerance of type IIa synthetic diamond detector for 14 MeV neutrons

Radiation tolerance of a type IIa synthetic diamond detector was examined from irradiation of mono-energetic 14 MeV neutrons. Measurements of I–V (current–voltage) characteristics and energy spectrum for 5.486 MeV alpha particles were performed after neutron irradiation. In the I–V characteristics measurement, enhancement of rectification was observed after neutron irradiation of up to 2.0 × 10¹² n/cm². Concurrently with the enhancement of rectification, significant decrease in signal amplitude was observed in energy spectrum measurement for alpha particles. It is considered that these changes were due to increase in the concentration of defects acting as shallow energy levels in the forbidden band. For neutron irradiation of higher than 1.6 × 10¹³ n/cm², weakening of the rectification characteristics and recovery of the signal amplitude were observed. These changes imply that deep energy levels, which were also considered to be introduced by defects, were dominant and weakened the effects of the shallow energy levels. Increase in the concentration of the deep trapping levels resulted in gradual decrease of the signal amplitude and degradation in the energy resolution. The peak for the alpha particles was obtained up to 5.5 × 10¹³ n/cm².     

Synthesis and electrode performance of layered nickel dioxide containing alkaline ions

Several polymorphs of layered nickel dioxide were prepared by using the chemical insertion of alkaline ions into Li_0.10NiO₂. We used aqueous AOH (A = Li, Na, K) solutions as reducing agents. Sodium and potassium insertion resulted in hydrated layered compounds that can be classified as γ-NiOOH with high crystallinity, while lithium insertion occurred without hydration. We discuss the coordination environment around the A⁺ ions for these inserted compounds. The thermal behavior, analyzed using high temperature (HT) X-ray diffraction (XRD) and thermogravimetric (TG) measurements, indicated that heating the hydrate at 150 °C yielded its dehydrate. The electrode performance of the nickelate was studied in lithium cells. We discuss the effect of interlayer water on cell rechargeability and the similarity between these nickelate and hydrated manganese dioxide (birnessite).     

2-Arachidonoyl glycerol suppresses gastric emptying via the cannabinoid receptor 1-cholecystokinin signaling pathway in mice

2-Monoacylglycerol (2-MAG) is one of the digestion products of dietary lipids. We recently demonstrated that a 2-MAG, 2-arachidonoyl glycerol (2-AG) potently stimulated cholecystokinin (CCK) secretion via cannabinoid receptor 1 (CB1) in a murine CCK-producing cell line, STC-1. CCK plays a crucial role in suppressing postprandial gastric emptying. To examine the effect of 2-AG on gastric emptying, we performed acetaminophen and phenol red recovery tests under oral or intraperitoneal administration of 2-AG in mice. Orally administered 2-AG (25 mg/kg) suppressed the gastric emptying rate in mice, as determined by the acetaminophen absorption test and phenol red recovery test. Intraperitoneal administration of a cholecystokinin A receptor antagonist (0.5 mg/kg) attenuated the gastric inhibitory emptying effect. In addition, both oral (10 mg/kg) and intraperitoneal (0.5 mg/kg) administration of a CB1 antagonist counteracted the 2-AG-induced gastric inhibitory effect. Furthermore, intraperitoneal 2-AG (25 mg/kg) suppressed gastric emptying. These results indicate that 2-AG exhibits an inhibitory effect on gastric emptying in mice, possibly mediated by stimulating both CCK secretion via CB1 expressed in CCK-producing cells and acting on CB1 expressed in the peripheral nerves. Our findings provide novel insights into the 2-MAG-sensing mechanism in enteroendocrine cells and the physiological role of 2-MAG.     

Correlations of Hepatic Hemodynamics,Liver Function,and Fibrosis Markers in Nonalcoholic Fatty Liver Disease: Comparison with Chronic Hepatitis Related to Hepatitis C Virus

The progression of chronic liver disease differs by etiology. The aim of this study was to elucidate the difference in disease progression between chronic hepatitis C (CHC) and nonalcoholic fatty liver disease (NAFLD) by means of fibrosis markers, liver function, and hepatic tissue blood flow (TBF). Xenon computed tomography (Xe-CT) was performed in 139 patients with NAFLD and 152 patients with CHC (including liver cirrhosis (LC)). The cutoff values for fibrosis markers were compared between NAFLD and CHC, and correlations between hepatic TBF and liver function tests were examined at each fibrosis stage. The cutoff values for detection of the advanced fibrosis stage were lower in NAFLD than in CHC. Although portal venous TBF (PVTBF) correlated with liver function tests, PVTBF in initial LC caused by nonalcoholic steatohepatitis (NASH-LC) was significantly lower than that in hepatitis C virus (C-LC) (p = 0.014). Conversely, the liver function tests in NASH-LC were higher than those in C-LC (p < 0.05). It is important to recognize the difference between NAFLD and CHC. We concluded that changes in hepatic blood flow occurred during the earliest stage of hepatic fibrosis in patients with NAFLD; therefore, patients with NAFLD need to be followed carefully.     

Hyperbranched poly(arylene ether phosphine oxide)s

Summary New AB₂ and A₂B monomers, bis(4-fluorophenyl)-4'-hydroxyphenylphosphine oxide and bis(4-hydroxyphenyl)-4'-fluorophenyl-phosphine oxide were prepared and converted to corresponding hyperbranched poly(arylene ether phosphineoxide)s with hydroxyphenyl and fluorophenyl end functional groups. While the dihydroxy monomer gave a low molecular weight polymer, the difluoro monomer produced a high molecular weight hyperbranched polymer. The glass transition temperature of the obtained polymers was 266°C and 230°C, and 5% weight loss temperature was 491 °C and 391 °C, respectively. The fluorophenyl-terminated hyperbranched polymer was soluble in CHCl₃, but the hydroxyphenyl-terminated polymer was not soluble in CHCl3 even though it has lower molecular weight than the fluorophenyl-terminated polymer, indicating that properties of the hyperbranched polymers markedly depend on end functional groups as well as their molecular weight. Received: 23 August 2000/Revised version: 19 October 2000/Accepted: 31 October 2000     

The initial step of the thermal unfolding of 3-isopropylmalate dehydrogenase detected by the temperature-jump Laue method

A temperature-jump (T-jump) time-resolved X-ray crystallographictechnique using the Laue method was developed to detect small,localized structural changes of proteins in crystals exposedto a temperature increase induced by laser irradiation. In achimeric protein between thermophilic and mesophilic 3-isopropylmalatedehydrogenases (2T2M6T), the initial structural change uponT-jump to a denaturing temperature (~90°C) was found tobe localized at a region which includes a ß-turn and aloop located between the two domains of the enzyme. A mutant,2T2M6T-E110P/S111G/S113E, having amino acid replacements inthis ß-turn region with the corresponding residues ofthe thermophilic enzyme, showed greater stability than the originalchimera (increase of T_m by ~10°C) and no T-jump-inducedstructural change in this region was detected by our method.These results indicate that thermal unfolding of the originalchimeric enzyme, 2T2M6T, is triggered in this ß-turn region.     

Synthesis of Dense Lead Titanate Ceramics with Submicrometer Grains by Spark Plasma Sintering

Dense PbTiO₃ ceramics consisting of submicrometer-sized grains were prepared using the spark-plasma-sintering (SPS) method. Hydrothermally prepared PbTiO₃ (0.1 μm) was used as a starting powder. The powder was densified to ≳98% of the theoretical X-ray density by the SPS process. The average grain size of the spark-plasma-sintered ceramics (SPS ceramics) was ≲1 μm, even after sintering at 900°–1100°C, because of the short sintering period (1–3 min). The measured permittivity of the SPS ceramics showed almost no frequency dependence over the range 10¹–10⁶ Hz, mainly because pores were absent from the ceramics. The coercive field of the SPS ceramics was somewhat higher than that of conventionally sintered ceramics, which could be attributed to the small-grained microstructures of the SPS ceramics.     

Polystyrene with half-titanocene/MAO catalysts: Influence of 2,6-diisopropylphenol

Styrene polymerization was carried out by a simple half-titanocene complex [cyclopentadienyltitanium trichloride] (CpTiCl₃) and pentamethyl [cyclopentadienyltitanium trichloride] (Cp*TiCl₃) combined with methylaluminoxane (MAO) as a cocatalyst. The effects of addition of 2,6-diisopropylphenol on the catalytic activity of the above catalytic systems and the microstructure of the resulting polymer were investigated. The results of the above experiments showed that the addition of the 2,6-diisopropylphenol changed the catalytic performance of the above catalytic systems, in terms of catalytic activity of the metal complexes and microstructure, molecular weight and molecular weight distribution of polystyrene synthesized. The yields of polystyrene of the above polymerization reactions indicated that the 2,6-diisopropylphenol enhanced the catalytic activity of both the CpTiCl₃/MAO and Cp*TiCl₃/MAO catalyst systems. Further Soxhlet extraction of the polymer was conducted by boiling acetone for 6 h to get pure syndiotactic polystyrene. The microstructure of polystyrene obtained by the above polymerization reactions was investigated by ¹³C NMR, GPC and DSC. Results indicated the formation of syndiotactic polystyrene in the absence of phenol and in low concentration of phenol. On the other hand, in the presence of excess phenol, the polystyrene produced was found to be completely atactic in nature. The appearance of monomodal peaks and narrow polydispersity in the GPC results of polystyrenes obtained in all the above polymerizations indicated that the polymerization was only coordination in nature.