Sensitivity of an anadically oxidized aluminium film on a surface acoustic wave sensor to humidity

The sensitivity, transient response and sensitivity mechanism of a surface acoustic wave humidity sensor using porous anodically oxidized aluminium (alumina) films as mechanical interfaces have been studied theoretically and experimentally. It is found that the sensitivity of alumina films of 1.0 μm thickness is -0.034 m/(s %RH) and is the same order as that of polyimide films. The transient response of alumina films to humidity is about one order faster than that of polyimide films. For the sensitivity mechanism, the phase-velocity change is attributed to the mechanical perturbation caused by the absorption of water molecules. The equivalent density change of alumina films between 0 and 100%RH is about 0.7%. In addition, the actual stiffness constants of alumina films are two orders less than those of bulk alumina.     

Laser spectroscopic measurement of quenching and doublet mixing rates of the Na(3P(3/2, 1/2)) doublet in a propane-air flame

We have measured the quenching rate of the Na 3P level and the doublet mixing rates of the Na 3P(3/2) and 3P(1/2) levels in a propane-air flame at atmospheric pressure. To obtain these rates, subnanosecond time-resolved fluorescence measurements were made using a mode-locked dye laser and the time-correlated single-photon counting method. Our results are 1.4 x 10(9) s(-1) for the quenching rate and 3.0 x 10(9) s(-1) for the 3P(3/2) --> 3P(1/2) mixing rate.     

Properties of aqueous solutions of several salts of α,ω-alkanediol disulfates

Several salts of α,ω-sulfates, MO₃SO(CH₂)_n OSO₃M(n=12, 14, 16, 18, and M=Li, Na, and K) were prepared from the corresponding α,ω-alkane diols. The Krafft points of these α,ω-sulfates with common counterion as estimated by electroconductivity measurements increased with the increase of the hydrocarbon chain length, and the effect of the counterions on the Krafft points of the α,ω-sulfates with the same hydrocarbon chain length was in the order : Li<Na<K. Solutions of the α,ω-sulfates, except disodium dodecanediol disulfate, showed two break points corresponding to the first and second critical micelle concentration in each plot of the electroconductivity as a function of the concentration. The existence of the second break point suggested that another aggregation of rearrangement of the existing aggregates occurs in α,ω-sulfate solutions in addition to the usual micelle formation. The first and second break points of α,ω-sulfates with sodium counterion decreased logarithmically with increasing total number of methylene groups. The relationships were given as follows: log(first break point)=−0.138Nc−0.095; log(second break point)=−0.104Nc−0.251. The effect of the counterions upon the break points of α,ω-sulfates with the same hydrocarbon chain length was in accordance with their positions in the lyotropic series.     

Studies on the nuclear magnetic resonance spectra of olefinic protons of conjugated fatty acid methyl esters

The NMR spectra of olefinic protons in the four representative conjugated fatty acid methyl esters, methylcis-9,trans-11-octadecadienoate, methyltrans-9,trans-11-octadecadienoate, methyl α eleostearate, and methyl β eleostearate, were studied. The chemical shift of each olefinic proton in these compounds was determined by considering their intramolecular environment. Coupling constants were also obtained as the results of spectral analysis.     

A novel agglomeration granulating system utilizing a centrifugal-fluidizing drive

Necessary conditions were studied for the optimum operation of agglomeration granulation. The mechanisms that would realize these conditions were investigated by several experiments.On the basis of the results obtained, a novel granulating system involving a surface wetness control mechanism has been developed.The present paper describes the mixing and dispersing characteristics of the coating vessel, the detection method for wetness control, the particular spraying units, and the operating conditions thereof, together with the characteristics of this newly developed powder coating granulation system.This system has been shown to provide an easy and reproducible granulating technique even when products below 1 mm in size are required.     

The role of pressure on thin amorphous carbon films deposited using microwave surface wave plasma CVD

We report the effects of gas composition pressure (GCP) on the optical, structural and electrical properties of thin amorphous carbon (a-C) films grown on p-type silicon and quartz substrates by microwave surface wave plasma chemical vapor deposition (MW SWP CVD). The films, deposited at various GCPs ranging from 50 to 110 Pa, were studied by UV/VIS/NIR spectroscopy, atomic force microscopy, Raman spectroscopy, X-ray photoelectron spectroscopy and current–voltage characteristics. The optical band gap of the a-C film was tailored to a relatively high range, 2.3–2.6 eV by manipulating GCPs from 50 to 110 Pa. Also, spin density strongly depended on the band gap of the a-C films. Raman spectra showed qualitative structured changes due to sp³/sp² carbon bonding network. The surfaces of the films are found to be very smooth and uniform (RMS roughness < 0.5 nm). The photovoltaic measurements under light illumination (AM 1.5, 100 mW/cm²) show that short-circuit current density, open-circuit voltage, fill factor and photo-conversion efficiency of the film deposited at 50 Pa were 6.4 μA/cm², 126 mV, 0.164 and 1.4 × 10^− 4% respectively.     

Calibration Curve for Quantitative Analysis of the Monoclinic-Tetragonal ZrO2 System by X-Ray Diffraction

A nonlinear calibration curve for volume fraction vs integrated intensity ratio was obtained for the monoclinic-tetragonal ZrO² system by using X-ray powder pattern-fitting and pattern-decomposition techniques. The empirical equation agrees well with the theoretical one. By using this equation, the deviation from linearity (6.8% maximum) resulting from the intensity difference of corresponding reflections of the two phases can be estimated quite accurately.     

Gelation of poly(vinyl alcohol)/phenol/water solutions and gel spinning

The light transmittance of the gels of poly(vinyl alcohol) (PVA)/phenol/water solutions was examined for the entire range of phenol/water content. Excellent transparency was found for the gels with phenol contents of 70–95 vol %. In full consideration of the results for the transparency and melting temperature of the gels and the viscosity and gelation ability of solutions, the PVA solutions of 75 vol % phenol content were selected for the gel spinning. The maximum dynamic moduli of drawn filaments at 25°C (room temperature) were 42 GPa (15x) for atactic PVA and 45 GPa (14x) for syndiotacticity-rich PVA. © 1995 John Wiley & Sons, Inc.     

The European,Japanese and US protective helmet,gloves and boots for firefighters: thermoregulatory and psychological evaluations

The purpose of this study was to investigate the physiological and subjective responses of the European, Japanese (JPN) and US firefighters' helmet, gloves and boots for international standardisation. Three experimental conditions were evaluated (clothing mass: 9.4, 8.2 and 10.1 kg for the three conditions, respectively) at the air temperature of 32°C and 60% relative humidity. The results showed that there was no significant difference among the three conditions in oxygen consumption, heart rate, total sweat rate, rectal temperature and mean skin temperature, whereas peripheral temperatures and subjective perceptions were lower in the JPN condition than in the other conditions (P < 0.05). These results indicate that a 0.5-kg reduction in helmet mass and a 1.1-kg reduction in boot mass during exercise resulted in a significant decrease in head and leg temperatures and subjective perceptions, while a 1.9-kg reduction in total clothing mass had insignificant influences on the metabolic burden and overall body temperature.