Deformation-induced martensitic transformation behavior in cold-rolled and cold-drawn type 316 stainless steels

We investigate deformation-induced martensitic transformation behavior in cold-rolled and cold-drawn specimens of type 316 stainless steel. Deformation-induced martensite preferentially nucleates at the twin boundary between the austenite matrix and a deformation twin. In the cold-rolled specimen, martensite formed at the twin boundary has a Kurdjumov–Sachs (K–S) relationship with both the austenite matrix and the deformation twin (“double K–S relationship”). In the cold-drawn specimen, two kinds of deformation twins with different twin planes are typically formed, and therefore deformation-induced martensites are formed where the deformation twin boundaries intersect: martensite thus has an imperfect “triple K–S relationship” with the austenite matrix and the two deformation twins. The complicated crystallographic orientation relationship between austenite and martensite grains strongly restricts the formation of some variants of deformation-induced martensites. Because of the difference in number of nucleation sites in the cold-drawn and cold-rolled specimens, martensitic transformation is more enhanced in the former than in the latter.     

Development of Ultra Low Field Nuclear Magnetic Resonance Imaging System Using HTS rf SQUID

We constructed and studied an ultra low-field nuclear magnetic resonance imaging system using a HTS rf SQUID and room-temperature coils. We recorded the free induction decay signals of ¹H by employing a measuring field, B _m, of 44.8???T and a polarizing field, B _p, of 36.8?mT; in the presence of ? B _Z /? z and ? B _Z /? y gradients of the order of 0.8???T/m, we were able to obtain a quasi two-dimensional 4-pixels image of a simple water phantom.     

Multiscale modeling in rodent ventricular myocytes

This paper indicates that in ventricular myocytes when the SR (sarcoplasmic reticulum) is pharmacologically inhibited, the intracellular Ca²⁺concentration rapidly increases during Ca²⁺ entrance (0-70 ms), whereas the decay of Ca²⁺ is slow; in the absence of fluorescent dye, large Ca²⁺ concentration gradients might develop near the cell membrane; intracellular Ca²⁺ distribution is tightly regulated by the localization of Ca²⁺transporter proteins along the sarcolemma and strongly relays on the presence of mobile and stationary Ca²⁺ buffers. These studies also imply that in ventricular cells with intact and functional SR, the Ca²⁺ signal most likely would spread faster along the t-tubular system, surface membrane than to the cell interior and that in the absence of Ca²⁺ dye high Ca²⁺ gradients under the surface membrane and more uniform Ca²⁺ distribution in the cell interior might be expected.     

Magnetic and EPR studies of edge-localized spin paramagnetism in multi-shell nanographites derived from nanodiamonds

Prolonged (up to 2 h) heat treatment at 1600 °C of nanodiamond particles (5 nm) leads to their conversion to the mixture of quasi-spherical carbon onions and multi-shell polyhedral nanographites. Structural and magnetic properties of two (A and B) series of nanographite samples obtained at various annealing intervals were studied. XRD data show that both multi-shell nanographite samples have practically the same crystalline structures. HRTEM evidences that the most of particles obtained by short time (7 min) annealing have a spherical like shape whereas the long time (~ 2 h) annealing leads to the majority of particles having a polyhedral shape with a hollow inside. Electronic and magnetic properties of these nanocarbons were investigated by magnetic susceptibility and EPR. Annealing results in entire transformation of the EPR signal of nanodiamond to new EPR signals of various line shapes and widths. These signals are extremely sensitive to ambient oxygen. Concentrations for all EPR active spins vary from ~ 1 × 10¹⁹ spins/g (7 min) to ~ 2 × 10¹⁹ spins/g (2 h). Temperature dependences of EPR spectra' parameters were obtained for vacuum-processed samples within the range 4?600 K. Intensity vs. T plots may be well-fitted by the combination of Curie–Weiss and temperature-independent Pauli susceptibility contributions. The latter one increases on heat treatment. Significant extension of electron spin-lattice relaxation time on decreasing temperature was found.     

<Superscript>31</Superscript>P NMR quantification and monophasic solvent purification of human and bovine lens phospholipids

Most lipid extraction procedures [Folch, J., Lees, M., and Sloane-Stanley, G.H., (1957) A Simple Method for the Isolation and Purification of Total Lipids from Animal Tissues, J. Biol. Chem. 226, 497–509; Bligh, E.G., and Dyer, W.J. (1959) A Rapid Method of Total Lipid Extraction and Purification, Can. J. Biochem. Physiol. 37, 911–917] employ biphasic solvent mixtures designed to dissolve the lipids in an organic phase and remove impurities in an aqueous phase. However, when applying these protocols to biological matrices such as that of the ocular lens, the formation of an emulsion layer between the organic and aqueous phases causes poor reproducibility in extraction yields and gives only a small amount of the lipid-containing chloroform phase. In this study, we quantified phospholipids at each step of the Folch et al. extraction protocol and compared the yield of human and bovine lens phospholipids obtained by the Folch-based approach and a novel monophasic methanol extraction method designed to circumvent the problems associated with biphasic extraction protocols. A monophasic methanol extraction coupled with ³¹P NMR spectroscopy was found to be the simplest, quickest, and most effective method for quantifying the phospholipid content of the lens.     

Surface modification of an organosilane self-assembled monolayer on silicon substrates using atomic force microscopy: scanning probe electrochemistry toward nanolithography

Organosilane self-assembled monolayers (SAMs) have been applied to resist materials for nanolithography based on scanning probe microscopy. An organosilane SAM was prepared on Si substrates from a precursor, that is octadecyltrimethoxysilane. Using an atomic force microscope with a conductive probe, current was injected from the probe into the SAM-covered Si substrate so that the SAM was locally degraded at the probe-contacting point. Nanoscale patterns drawn on the SAM was clearly imaged by lateral force microscopy. The patterning could be conducted in air while, in vacuum at the order of 10(-6) Torr, no detectable patterns were fabricated. The presence of adsorbed water at the probe/sample junction was confirmed to be crucial for the patterning of the SAM/Si. Its mechanism was, thus, ascribed to electrochemical reactions of both the SAM and Si with adsorbed water.     

An investigation of the pH-activity relationships of Cex, a family 10 xylanase from Cellulomonas fimi: xylan inhibition and the influence of nitro-substituted aryl-beta-D-xylobiosides on xylanase activity

The kinetic parameters of Cex, a family 10 xylanase from Cellulomonas fimi, were determined at various pH levels using soluble birchwood xylan (BWX) as a natural polymeric substrate along with three other synthetic aryl-beta-D-xylobioside substrates. Using BWX, a high level of substrate inhibition was observed which increased with decreasing pH. In contrast, typical Michaelis-Menten-type profiles were obtained using the three aryl-beta-D-xylobiosides as substrates. The k(cat) values determined using o-nitrophenyl-beta-D-xylobioside did not change as the pH increased, whereas the k(cat) values obtained with BWX, phenyl-beta-D-xylobioside and p-nitrophenyl-beta-D-xylobioside decreased, suggesting that the presence of an ortho nitro group affects the activity displayed by Cex. These differences were not observed with XynB from Clostridium stercorarium F9, a member of the same family of xylanases as Cex. These results indicate that a careful evaluation is required when employing substituted aryl-beta-D-xylobiosides in the characterization of xylanases.     

Mathematics based on incremental learning—Excluded middle and inductive inference

Learning theoretic aspects of mathematics and logic have been studied by many authors. They study how mathematical and logical objects are algorithmically “learned” (inferred) from finite data. Although they study mathematical objects, the objective of the studies is learning. In this paper, a mathematics whose foundation itself is learning theoretic will be introduced. It is called Limit-Computable Mathematics. It was originally introduced as a means for “Proof Animation”, which is expected to make interactive formal proof development easier. Although the original objective was not learning theoretic at all, learning theory is indispensable for our research. It suggests that logic and learning theory are related in a still unknown but deep new way.     

ELECTRON GUN FOR LARGE ORBIT GYROTRON (LOG) WITH DECREASED INFLUENCE OF CATHODE PLASMA ON ELECTRON BEAM PROPERTIES

High power Large Orbit Gyrotron (LOG) [1] is now under development at FIR FU. First version of this device was recently manufactured and then assembled with power supply ETIGO-IV [2]. Results of preliminary tests of electron-optic system are presented. The conditions when stable flat form of current pulse realized are discussed. Analytical estimations of cathode-anode distance to achieve small influence of cathode plasma during high voltage (HV) pulse are performed. Two new electron gun versions with decreased influence of the cathode plasma on its impedance and pulse form are suggested and optimized. New optimal magnetic field distributions are found. First gun has quiasi-flat cathode configuration near the anode diaphragm and provides operating current about 60 A. Second one uses blade cathode with operating current about 30 A. Beam quality for both guns is suitable for LOG operation.