Effect of lamellar spacing on microstructural instability and creep behavior of a lamellar TiAl alloy

Finer lamellar spacing in the lamellar structure of a Ti–45Al–2Nb–2Mn + 0.8 vol.%TiB₂ (45XD) alloy does improve the primary creep resistance. However, the unstable nature of the fine plate contributes largely to the degradation of the lamellar structure and a rapid increase in the tertiary creep rate, indicating that a fine lamellar structure has a detrimental effect on the long-term creep.     

Shape memorizing properties of a hydrogel of poly(vinyl alcohol)

Hydrogel prepared by repetitive freezing and thawing of poly(vinyl alcohol) aqueous solution was chemically crosslinked with glutaraldehyde. The chemically crosslinked hydrogel hardly changed its physical appearance, and showed good elasticity and strength as original gel. However, after treating in boiling water, it swelled a little, depending on the condition of the chemical treatment. The melted gel thus obtained showed shape memorizing property, that is, it could firmly hold nearly 200% of strain, keeping its original high elasticity. The strain could be released very quickly (< 1 s) in boiling water, and the gel was suggested to be applied to a new type of gel actuator. X-ray diffraction study revealed that the melted gel does not necessarily reform the physical crosslinks in exactly the same manner as the original gel in the process of shape restoring, but the distribution of the physical crosslinks can be restored as they were. It was suggested that the chemical crosslinks which remember the distribution of the physical crosslinks plays a critical roll in the shape restoring process.     

Interfacial Reactions between Sapphire and Silver—Copper—Titanium Thin Film Filler Metal

Wetting and brazing studies of sputtering-deposited, submicrometer thin film filler metal in an Ag—Cu—Ti/Al₂O₃ system were performed. The interfacial reaction layer between the filler metal and Al₂O₃ was investigated. It is possible to make a brazing joint even with a reaction layer of less than 100 nm thickness. Different types of interfacial reaction layers were observed when the Ti content in the filler metal was varied. The Cu—Ti—O system compounds were observed in the samples with high wetting capabilities, but not in the sample with low wetting characteristics. It was found that these compounds are substances that promote effective brazing.     

Antitumor activity of synthetic alkylphospholipids with or without PAF activity

1-O-Octadecyl-2-O-methyl-sn-glycero-3-phosphocholine (ET-18-OMe) has been reported to possess definite antitumor activity in vivo. Twenty-two alkyl lysophospholipid analogs were chemically synthesized, and their antitumor activity against mouse experimental tumors (Sarcoma 180, MM46, P388) was examined. Among them, 1-O-octadecyl-2-O-acetoacetyl-rac-glycerol-3-phosphocholine was found to show antitumor activity similar to ET-18-OMe with less acute toxicity. Intravenous injection of the ET-18-OMe withsn-3 configuration retarded the subcutaneous growth of Sarcoma 180 cells effectively, while the growth inhibition by thesn-1 isomer was much less effective. This stereospecificity was similar to that observed in their activities as platelet-activating factor (PAF) agonists. The acetoacetyl compound, another PAF agonist, showed similar stereospecific antitumor action in vivo. These findings suggest that some alkyl lysophospholipids may activate host cells to a cytostatic stage against tumor cells in vivo through binding to a PAF receptor. Our preliminary results indicated that the responsible cells under these conditions might be primarily immature macrophages present in the bone marrow. No appreciable or even adverse stereospecificity was observed in the different sets of experiments where the activity of ET-18-OMe against MM46 tumor cells in vivo or the direct cytotoxicity against human promyelocytic leukemia HL-60 cells in vitro was examined. Under, some conditions, the antitumor activity of ET-18-OMe in vivo may be revealed through direct cytotoxicity and/or modulation of the host defense system by “nonspecific” mechanisms. Some alkylphospholipids without PAF activity may also show antitumor activity through similar, “nonspecific” mechanisms.     

Polymerization of 2-dibutylamino-1,3,5-triazine-4,6-dithiol on wire during friction process

2-Dibutylamino-1,3,5-triazine-4,6-dithiol (DB) and a mixture of DB and triallylisocyanurate (TAIC) were used as a lubricant during steel wire drawing due to a dry process. DB gave a polymer film with 180 nm in thickness to wire surfaces during the wire drawing. The polymer film had a disulfide structure on the backbone and contained a small amount of DB monomer and olygomer. Molecular weight and polymer weight increased with the drawing rate. The mixture of DB and TAIC gave mainly a three-dimensional polymer film with 225 nm in thickness to wire surfaces during drawing. The polymer film insoluble in THF had mono and disulfide structures and contained a small amount of linear polymer, DB, and TAIC. Such tribological polymerizations are estimated as follows: DB produces dithiyl radicals on a nascent surface formed during drawing and in the presence of oxygen and heat. The dithiyl radicals were polymerized by coupling with each other to give disulfide bonds or added to allyl groups in TAIC to give monosulfide bonds. It is concluded that this technique should be possible to use for unifying metal processing and surface treatment. © 1995 John Wiley & Sons, Inc.     

Influence of activated carbon pore structure on oxygen reduction at catalyst layers supported on rotating disk electrodes

Carbon materials are often used as catalyst supports, and for catalysts in electrodes of a polymer electrolyte fuel cell, carbon black has been used. Recently, it was found, however, that activated carbon could replace carbon black and besides, significantly improve the activity of the electrode catalyst layer for oxygen reduction. In the present study, to optimize the pore structure of activated carbon for further activity improvement, the influence of the pore structure on the activity was investigated using activated carbon of various specific surface areas and mean pore diameters. A catalyst layer was formed from activated carbon loaded with platinum and a polymer electrolyte. The activity of the layer was measured in an oxygen-saturated perchloric acid solution, supporting the layer on a rotating glassy carbon disk electrode. We found that increases in the specific surface area and mean pore diameter increased the activity and that the latter was more effective than the former mainly due to the enhanced mass-transfer in the pores; the catalyst layer formed from activated carbon with the largest mean pore diameter was the most active. Unless pores excessively develop and lose connections between particles, a large pore diameter is therefore desired for the fuel cell electrodes.     

Balanced corpus of contemporary written Japanese

The balanced corpus of contemporary written Japanese (BCCWJ) is Japan’s first 100 million words balanced corpus. It consists of three subcorpora (publication subcorpus, library subcorpus, and special-purpose subcorpus) and covers a wide range of text registers including books in general, magazines, newspapers, governmental white papers, best-selling books, an internet bulletin-board, a blog, school textbooks, minutes of the national diet, publicity newsletters of local governments, laws, and poetry verses. A random sampling technique is utilized whenever possible in order to maximize the representativeness of the corpus. The corpus is annotated in terms of dual POS analysis, document structure, and bibliographical information. The BCCWJ is currently accessible in three different ways including Chunagon a web-based interface to the dual POS analysis data. Lastly, results of some pilot evaluation of the corpus with respect to the textual diversity are reported. The analyses include POS distribution, word-class distribution, entropy of orthography, sentence length, and variation of the adjective predicate. High textual diversity is observed in all these analyses.     

High oleic acid oil suppresses lung tumorigenesis in mice through the modulation of extracellular signal-regulated kinase cascade

This study was undertaken to estimate the effect of dietary high oleic acid oil (OA) on 4-(methylnitrosamino)-1-(3-pyridyl)-1-butanone (NNK)-induced lung tumorigenesis in mice. Diet containing 10% oil was fed to mice through experimental periods. On day 30 after NNK injection (100 mg/kg body weight, i.p.), the treatment increased the level of prostaglandin E₂ (PGE₂) as well as proliferating cell nuclear antigen, a marker of cell proliferation in a high linoleic acid oil (LA)-fed group but not in an OA-fed group. The NNK treatment also induced the activation of an extracellular signal-regulated kinase (Erk) cascade (Erk, Mek and Raf-1) in an LA-fed group. On the other hand, OA feeding abolished the NNK-induced activation of the Erk cascade. In conjugation with these events, OA feeding reduced lung tumor incidence and tumor multiplicity (percentage of mice with tumors) in mice compared with LA feeding at the 20th experimental week. These results suggest that OA suppresses lung tumorigenesis and that this suppression is correlated with the inhibition of PGE₂ production and inactivation of the Erk cascade.     

Guinea pig bone marrow cells treated with platelet-activating factor generate factor(s) which affects their DNA synthesis and microbicidal activity

We have previously reported that platelet-activating factor (PAF) induces proliferation and microbicidal activity of guinea pig bone marrow cells. In the present study, we have found that the conditioned medium of PAF- or nonmetabolizable PAF agonist-treated guinea pig bone marrow cells augmented DNA synthesis and induced microbicial activity of bone marrow cells. A PAF specific antagonist, CV-6209, inhibited generation of the active conditioned medium by PAF. Addition of the PAF antagonist only partially suppressed the augmentative effect of the active conditioned medium on DNA synthesis; this is consistent with the fact that, because of the rapid breakdown, no appreciable amount of PAF remained in the conditioned medium of PAF-treated cells. Although mouse bone marrow cells did not respond to PAF unlike guinea pig cells, their DNA synthesis was significantly enhanced by the conditioned medium of PAF-treated guinea pig bone marrow cells. Thus, some newly generated factor(s) distinct from the originally inoculated PAF seemed to modulate the bioactions of PAF on bone marrow cells. An appreciable amount of PAF was produced by calcium ionophore-treated guinea pig bone marrow cells. These findings indicate that PAF synthesized in guinea pig bone marrow cells induces generation in the cells of some factor(s) which affects proliferation or microbicidal activity. Presented at The Third International Conference on Platelet-Activating Factor and Structurally Related Ether Lipids, Tokyo, Japan, May 1989.     

Preparation of plasma-polymerized membranes from I-(trimethylsilyl)-I-propyne and gas permeability through the membranes

Summary Plasma-polymerized membranes for gas separation were prepared from 1-(trimethylsilyl)-1-propyne. The permeation data of He, H₂ 0₂, N₂, CO₂, and CH₄ through the membranes showed plasma-polymerized 1-(trimethylsilyl)-1-propyne had high permselectivity but low permeability compared with poly[l-(trimethylsilyl)-1-propyne]. This behavior is considered to be due to the crosslinking structure of the plasma-polymerized membrane. The correlation between plasma polymerization conditions and the membrane performance was studied. The optimum condition at which the deposition rate of the plasma polymer is maximized agreed with the optimum value to yield maximum separation factor of gases through the membrane.