Radiation tolerance of type IIa synthetic diamond detector for 14 MeV neutrons

Radiation tolerance of a type IIa synthetic diamond detector was examined from irradiation of mono-energetic 14 MeV neutrons. Measurements of I–V (current–voltage) characteristics and energy spectrum for 5.486 MeV alpha particles were performed after neutron irradiation. In the I–V characteristics measurement, enhancement of rectification was observed after neutron irradiation of up to 2.0 × 10¹² n/cm². Concurrently with the enhancement of rectification, significant decrease in signal amplitude was observed in energy spectrum measurement for alpha particles. It is considered that these changes were due to increase in the concentration of defects acting as shallow energy levels in the forbidden band. For neutron irradiation of higher than 1.6 × 10¹³ n/cm², weakening of the rectification characteristics and recovery of the signal amplitude were observed. These changes imply that deep energy levels, which were also considered to be introduced by defects, were dominant and weakened the effects of the shallow energy levels. Increase in the concentration of the deep trapping levels resulted in gradual decrease of the signal amplitude and degradation in the energy resolution. The peak for the alpha particles was obtained up to 5.5 × 10¹³ n/cm².     

Multiobjective dynamic load-dispatching method for optimal operation of power systems

A new practical method is proposed which gives a quasi-optimal solution of the dynamic load-dispatching problem formulated by a multiconstraint multiobjective optimization problem. Here, the multiple constraints are rate reserve constraints and power flow ones, and the multiple objectives are fuel cost and CO₂ emission. The proposed method is an integration of the following three techniques: (1) “Group Dispatch Scheme,” which is developed by the authors, is used to satisfy a violated constraint easily. This scheme consists of three steps. The first step is to classify all generators into two groups. One is the group which should be more loaded to satisfy the violated constraint, and the other is the should-be less loaded group. The second step is to add some load to the former group, and to subtract the same load from the latter. The third step is to dispatch each group load to each groups generators, respectively; (2) the dynamic load-dispatching algorithm is used which provides, in practical time, quasi-optimal generation trajectories; (3) the conventional weighting parametric method is used to obtain a Pareto optimal solution of multiobjective problems. The effectiveness of the method is clarified by a computer simulation on the actual power system of Kansai Electric Power Company.     

Effects of electrode arrangement and pressure on synthesis of diamond films by arc discharge plasma jet chemical vapor deposition

The setup and deposition conditions of electrode arrangement and pressure have been studied to synthesize diamond films at high growth rate on wide area efficiently by arc discharge plasma jet chemical vapor deposition. An apparatus has been used in which four plasma torches, one is used for cathode and the others for divided anodes, are arranged and the positions of these torches are changeable. Growth rate, deposition area and thickness of diamond films have increased with changing the electrode arrangements without improvement of thickness variation. Maximum growth rate of our apparatus has occurred at the pressure of 6.7 kPa and diamond films that have less variations of quality and surface roughness have been synthesized at lower pressure during deposition. Moreover, a high conversion rate, which is the ratio of carbon atoms that form diamond in supplied methane gas, of 16% has been obtained at the pressure of 6.7 kPa and methane concentration of 2%.     

Isolation identification and quantitative culture of Helicobacter pylori from gastric mucosa

The biopsy specimens were homogenized and diluted ten-fold serially in Hank's solution. Each dilution samples were streaked on Skirrow's selective medium. The plates were incubated at 37 degrees C 5 to 7 days under micro-aerobic condition and counting the viable cell of H. pylori. The positive rate of specimens with H. pylori in active gastric ulcer tissue (62.0%) was higher than that in scarred tissue (51.9%). Number of H. pylori viable cells in active ulcer tissue was significantly larger than in scarred tissue. The positive correlation between Raw's gastritis score of specimens from patients with erosive gastritis and number of H. pylori viable cells was clearly noticed.     

Decrease in alkaline triglyceride lipase in primary cultured hepatocytes from mice with sarcoma 180

Primary cultured hepatocytes from normal mice and mice with Sarcoma 180 were characterized. The viability of freshly isolated heptocytes from both sources was over 90% and the cells had a relatively stable population of DNA for a minimum of three days. After incubation with (³H)leucine, the syntheses and secretions of (³H)labeled trichloracetic acid-insoluble materials by hepatocytes from both normal and tumor-bearing mice increased similarly. However, the alkaline triglyceride lipase activity of a homogenate of freshly isolated hepatocytes from tumor-bearing mice was one-third that of cells from normal mice. the activity of hepatocytes from tumor-bearing mice inceeased less during culture than did the activity of cells isolated from normal mice.     

Inhibition of liver metastasis of human pancreatic carcinoma by angiogenesis inhibitor TNP-470 in combination with cisplatin

The anti-tumor and anti-metastatic effects of O-(chloroacetyl-carbamoyl) fumagillol (TNP-470), an angiogenesis inhibitor, and cisplatin (CDDP), an anti-neoplastic agent, were investigated using our established liver-metastasizing pancreatic carcinoma line, HPC-3H4. HPC-3H4 was injected into the spleens of nude mice. Mice were randomly divided into 5 groups; a control group given saline solution, a group receiving 45 mg/kg TNP-470, a group receiving 90 mg/kg TNP-470, a group receiving 90 mg/kg TNP-470 in combination with 0.25 mg/kg CDDP, and a group receiving 0.25 mg/kg CDDP. In the control group, liver metastasis developed in 14 of 15 mice (93.3%). Liver metastasis developed in 9 of 11 mice (81.8%) receiving 0.25 mg/kg CDDP. It developed in 11 of 15 mice (73.3%) receiving 45 mg/kg TNP-470, in 17 of 18 mice (94.4%) receiving 90 mg/kg TNP-470, and in 4 of 10 mice (40%) receiving 90 mg/kg TNP-470 in combination with 0.25 mg/kg CDDP. TNP-470 in combination with CDDP displayed a significant inhibitory effect on liver metastasis compared to the control. Although TNP-470 alone and CDDP alone had no effect on the tumor growth in vivo, 90 mg/kg TNP-470 in combination with 0.25 mg/kg CDDP had a significant effect. In vitro examinations demonstrated that the growth of HPC-3H4 cells was only mildly inhibited by TNP-470, but the production of vascular endothelial growth factor (VEGF) by HPC-3H4 was clearly inhibited by TNP-470. The inhibitory effect on the production of VEGF was not strong with CDDP treatment. These results indicate that the angiogenesis inhibitor TNP-470 in combination with low-dose CDDP has inhibitory activity against liver metastasis of human pancreatic carcinoma.     

Preparation of TiB2 sintered compacts by hot pressing

A sintered compact of titanium diboride (TiB₂) was prepared by hot pressing of the synthesized TiB₂ powder, which was obtained by a solid-state reaction between TiN and amorphous boron. Densification of the sintered compact occurred at 20 MPa and 1800° C for 5 to 60 min with the aid of a reaction sintering, including the TiB₂ formation reaction between excess 20 at % amorphous boron in the as-synthesized powder (TiB₂ + 0.2B) and intentionally added 10 at % titanium metal. A homogeneous sintered compact of a single phase of TiB₂, which was prepared by hot pressing for 30 min from the starting powder composition [(TiB₂ + 0.2B) + 0.1 Ti], had a fine-grained microstructure composed of TiB₂ grains with diameters of 2 to 3 m. The bulk density was 4.47 g cm^–3, i.e. 98% of the theoretical density. The microhardness, transverse rupture strength and fracture toughness of the TiB₂ sintered compact were 2850 kg mm^–2, 48 kg mm^–2 and 2.4 MN m^–3/2, respectively. The thermal expansion coefficient increased with increasing temperature up to 400° C and had a constant value of 8.8 x 10^–6 deg^–1 above 500° C.     

Effect of grain size on creep of Ti-53.4mol%Al intermetallics at 1100 K

Constant stress creep under compression stress, 100 to 316 MPa, at 1100 K was investigated on single-phase TiAl intermetallics. The material was ingot-cast, isothermally forged, and then annealed to produce stable equi-axed grain structures, whose average grain diameters were 25, 42 and 70m. Creep curves were very similar among the three specimens with different grain diameters and the creep rates at a given strain, as well as the minimum creep rates, depended little on grain size. Two regimes were observed on the stress dependence of the minimum creep rate. The stress exponent under high stresses was about 4.5, independent of grain size. Under stresses lower than about 150 MPa it became about 8.     

Development of a dual‐lamp projector with higher brightness

Stationary projectors mainly used in system applications have recently gained a wider application range, including general presentations in halls and large conference rooms and being used, for example, in digital signage and for monitoring purposes. Consequently, they are required to meet new market demands for durability, reliability, and flexibility in installation in addition to their conventional basic performance such as especially high brightness. To achieve especially high brightness, a new optical system with two lamps is proposed; the profile of the cover glass that prevents the glass from scattering is made aspherical, the profile of the beam‐combining mirror is improved with its position optimized, and the size of the incident plane of the integrator rod is made larger (1.1 times). These measures resulted in an optical system of an even higher efficiency with 7000 lm, which is the highest in its class (according to a June 2010 investigation). Also, the arrangement of two parallel lamps completely eliminated the effect of heat passing from one lamp to the other, which helped secure durability, reliability, and flexibility in installation. Furthermore, the combined use of the unique non‐telecentric optical system, adopted from the conventional single‐lamp model, helps maintain the class‐highest contrast ratio.^1,2