Photo-induced radicals in glucose and cellobiose

Photo-induced radicals in glucose and cellobiose, the model compounds of cellulose molecule, were studied by ESR spectrometry. Very poor formation of radicals in glucose as compared to those in cellobiose was observed. However, a spectrum showing a singlet line was easily produced by the use of light involving shorter wavelengths. It was estimated to be due to the radical formed at the reducing C₁ position of glucose molecule. By paper chromatography, the photo-irradiated cellobiose was confirmed to split into glucose through scission of glucosidic bonds in the molecule. The ESR spectrum of the acid-hydrolyzed cellulose similar to that of the unhydrolyzed sample was a seven-line spectrum, but the relative signal intensity was here markedly low. This phenomenon seems to be caused by the reduction of amorphous portion in the samples due to acid hydrolysis. It was concluded that the glucosidic bonds in cellobiose and cellulose molecules are very active toward light and play an important role in the radical formation in photo-irradiated samples.     

Distinction of Leu and Ile Using a Ruthenium(II) complex by MALDI-LIFT-TOF/TOF-MS analysis

The novel N-terminal labeling method using a ruthenium(II) complex derivative characteristically indicated a(n) and d(n) (N-terminal) fragment ions in high sensitivity by MS/MS analysis (MALDI-LIFT or ESI-CID). Although these fragment ions depended on a fragmentation process by MS/MS analytical methods to some degree, each case indicated similar side-chain cleavage patterns. The labeling method allows accurate distinction of amino acid residues by MS/MS analysis even if the residues are structural isomers such as leucine and isoleucine. The method was applied to long-chain peptides and provided easy and rapid N-terminal sequencing.     

Development of an advanced biological treatment system applied to the removal of nitrogen and phosphorus using the sludge ceramics

To develop a method of forming lake sediment into sludge ceramics with porosity and good biological adhesion for use as a medium for microorganisms in wastewater treatment, a study of the effects of forming conditions was conducted by adjusting the water content of sludge and compounding some additives. By adjusting the water content of the raw material at the kneading/pelletizing step to 40–42% and adding 3% waste glass to the raw materials to make up for the lack of flux, a sludge ceramic with a density in terms of specific gravity of saturated surface dry aggregate of about 1400 kg m⁻³ was formed. In addition, to develop a small-scale wastewater treatment system capable of removing nitrogen and phosphorus, a sludge ceramic was applied as a medium for biological filtration. The results indicated that the BOD removal nitrification rate were superior to those of conventional ceramic media, reached at 95.3% and 87.4%, respectively. The introduction of iron electrolysis resulted in high treatment performance achieving BOD levels of 10 mg L⁻¹ or less, T-N of 10 mg L⁻¹ or less and T-P of 1 mg L⁻¹ or less.     

Permeation, diffusion and dissolution of hydrogen isotopes, methane and inert gases through/in a tetrafluoroethylene film

Tetrafluoroethylene (TFE) is widely used for conventional tritium handling systems such as vacuum seals, tubing and so on. We measured the permeation of the three hydrogen isotopes, methane and the inert gases through a TFE film at room temperature by means of the time-lag method in order to establish the physicochemical properties which determine the solubility and diffusivity of those gases. It was found that the diffusion constant of the inert gases changed exponentially with the heat of vaporization and the solubility was an exponential function of the Lennard-Jones force constant of the gases. On the other hand, hydrogen isotopes and methane deviated from these relations. It is concluded that chemical interactions between the solute and the solvent play an important role for the dissolution and the diffusion of these gases in TFE.     

Performance characteristics of energy separation in a steam-operated vortex tube

Energy separation performance of a steam-operated vortex tube is experimentally investigated, and some reasonable criteria and expressions to estimate the energy separation performance are also introduced. The performance characteristics defined by the above expressions are the same as those of ideal gas in the high superheated region, and are well expressed independently of the degree of superheat, total mass flow rate and discharge resistance. When steam is in the wet region at the nozzle outlet, the performance considerably decreases because of the energy waste from moisture vaporization. And no energy is separated when the dryness fraction is less than approximately 0.98. Some technical data including the optimum operating conditions are also offered.     

Low Temperature Phase Transition in C70 and Solvation Effects

The heat capacity of C₇₀ has been measured by adiabatic calorimetry between 14 and 320 K. The orientational phase transition is observed as a broad hump in the heat capacity curve, which is strongly influenced by small amount of solvent remaining in the sample.     

A dislocation model of the plastic deformation of single crystals of ice

A new dislocation model is constructed on the basis of various characteristics of dislocations revealed by X-ray diffraction topography, for interpreting plastic deformation behaviour of ice single crystals in basal glide. The model of a pair of screw dislocation arrays of opposite sign exhibits resistance for the movement, which depends upon both the configuration and the stress. Orowan's relation between the macroscopic strain rate and characteristic of dislocations in the crystal (density and velocity) is rewritten in a dynamical style taking into account the resisting stress and the empirically established linear relationship between the dislocation velocity and the stress. In this formulation, a new concept of fractional dislocation density is introduced.Examples of fractional density as a function of maximum stress are obtained from our stress relaxation experiments. Assuming that the initial fractional density profile for a fresh ice single crystal is similar to those obtained above, stress-strain curves are calculated numerically for various crosshead speeds of the test machine. Computed results coincide well with the characteristic stress-strain curves previously obtained experimentally.     

Molecular dynamics simulations of elastohydrodynamic lubrication oil film

This paper reviews recent research in molecular dynamics studies of the traction properties of hydrocarbon fluids under elastohydrodynamic lubrication, focusing on the technical problems that arise on making predictions of the traction properties of an oil film with a submicron thickness at the actual sliding contacts of the machine elements by at a nanoscale molecular simulation. The effect of the oil film thickness and shear rate are examined including the result of a submicron thickness simulation of the oil film using a tera‐flops computer. The mechanism of the phase transition of the fluids under high pressure, the boundary slip, and the momentum transfer related to the molecular structure of the fluids are also presented. Copyright © 2010 John Wiley & Sons, Ltd.     

DNA microarray analysis suggests that zinc pyrithione causes iron starvation to the yeast Saccharomyces cerevisiae

Zinc pyrithione has been used in anti-dandruff shampoos and in anti-fouling paint on ships. However, little is known of its mode of action. We characterized the effects of sub-lethal concentrations of zinc pyrithione (Zpt) on Saccharomyces cerevisiae using DNA microarrays. The majority of the strongly upregulated genes are related to iron transport, and many of the strongly downregulated genes are related to the biosynthesis of cytochrome (heme). These data suggest that Zpt induces severe iron starvation. To confirm the DNA microarray data, we supplemented cultures containing Zpt with iron, and the growth of the yeast was restored significantly. From these results, we propose that the principal toxicity of zinc pyrithione arises from iron starvation.