一种常见电梯鼓式制动器的性能改进及其检验

制动器是电梯重要的安全部件,一旦失效,可能造成轿厢蹴底、冲顶、开门运行以致人员受到剪切伤害等严重后果。所以,电梯的制动系统除了电气制动外,还应有一个机一电式摩擦型的制动器,其兼备了驻车制动和行车紧急制动的功能。     

透明硅烷改性聚醚密封胶的研制

以硅烷改性聚醚树脂(MS树脂)为基料,加入增塑剂、气相二氧化硅、偶联剂、自制催化剂等助剂,制备了一种透明硅烷改性聚醚密封胶(MS密封胶)。该密封胶固化后拉伸强度为2.93 MPa,断裂伸长率为258%,1 mm厚胶片的透光率达92%,综合性能较优,能够满足相关标准的要求。     

浅谈村镇规划中存在的问题

一、前言当前,国家把解决“三农”问题作为工作的重中之重,要求跳出农业抓农业。2003年6月,浙江省政府召开专题会议,启动“千村示范、万村整治”工程,提出以中心村建设为重点,推动城市基础设施向农村延伸,推动城市公共服务事业向农村覆盖,推动城市文明向农村辐射。实施“千村示范、万村整治”工程,加大村庄环境整治的力度,完善农村基础设施,加强农村基层组织和民主建设,加快农村社会发展,使农村面貌有一个明显改变。为加快实现农业和农村现代化,为保证农民物质文明、精神文明上一个新台阶打下扎实的基础。在这个政策的指引下,近几年全国各地…     

Tribological Characteristics of Aqueous Graphene Oxide,Graphitic Carbon Nitride,and Their Mixed Suspensions

The tribological performance of graphene oxide (GO), graphitic carbon nitride (g-C₃N₄), and their mixed (g-C₃N₄/GO) aqueous suspensions was investigated. The 0.06 wt% GO, 0.06 wt% g-C₃N₄, and 0.06 wt% 1:1 g-C₃N₄/GO suspensions reduced the coefficient of friction (COF) by 37, 26 and 37% and wear mark radius by 19.1, 16.0 and 19.6%, respectively, in comparison with water. Pure g-C₃N₄ and GO suspensions showed unstable lubrication in the tests with relatively high loads and speeds, while the g-C₃N₄/GO mixed suspension had superior tribological performance in all tested conditions. This is because in the mixed suspension g-C₃N₄ agglomerates became smaller, and GO nanosheets exhibited fewer wrinkles and less stacking, which enabled the formation of a layer of tribo-composite film. As a result, the friction, wear and tribo-corrosion were reduced during sliding.     

Rapid Bonding of Ti3SiC2 and Ti3AlC2 by Pulsed Electrical Current Heating

Inspired by pressure resistance welding of metallic materials, herein we describe how two MAX phases—Ti₃SiC₂ and Ti₃AlC₂—were successfully joined by a rapid electric current heating method in a pulsed electric current sintering furnace. No welding agent was employed and the total processing time was less than 6 min. When the bulk temperature of the joint couple exceeded 1070°C, good joints, with shear strength above 50 MPa, were achieved in both homo‐ and heterojunction joints.     

Tuning of dielectric and ferroelectric properties in single phase BiFeO3 ceramics with controlled Fe/Fe ratio

Single phase multiferroic BiFeO₃ (BFO) ceramics were synthesized with controllable amount of Fe²⁺ and oxygen vacancies in a very wide concentration range. Double ferroelectric hysteresis loops are observed in fresh BFO ceramics at room temperature without any aging processes. Detailed study shows that this is due to the defect dipoles which have preferential orientations antiparallel to the direction of spontaneous polarization, providing a driving force for domain back-switching. The dielectric constant of BFO could be enormously enhanced by 100 times by increasing the Fe²⁺ content, employing a polaronic relaxation process.     

A Moisture Transfer Model for Isothermal Drying of Plant Cellular Materials Based on the Pore Network Approach

Plant materials with cellular structure, like fruits and vegetables, are often viewed as porous media in terms of model building of the drying process, on the basis of a hypothesis that all of the moisture of a plant tissue is trapped in a continuous and connected pore network system. However, most of the moisture in the plant tissue is contained naturally in enclosed cells. In the course of drying, the trapped moisture has to cross the cell membranes and then migrates in the extracellular space. Based on this concept, a pore network model for isothermal drying of plant materials was developed in which two stages of moisture movement—transmembrane transfer and extracellular transfer in the pore network—were considered. Finally, the isothermal convective air-drying processes of a potato slice were simulated. The calculated results were validated by the experiments conducted under the simulation conditions.     

One-Pot Synthesis,Crystal Structure,and Thermal Decomposition Behavior of 1,1ʹ-Diamino-4,4ʹ,5,5ʹ-Tetranitro-2,2ʹ-Biimidazole

1,1?-Diamino-4,4?,5,5?-tetranitro-2,2?-biimidazole (DATNBI) was synthesized, by employing one-pot facile method, from 4,4?,5,5?-tetranitro-2,2?-biimidazole. The crystal structure was determined by X-ray diffraction for the first time. DATNBI crystallized in monoclinic system P2₁/c, with a crystal density of 1.934 g cm^?3 at 293(2) K and 2.019 g cm^?3 at 130(2) K, respectively. Its crystal parameters at 293 K are a = 4.8833(15) Å, b = 6.960(2) Å, c = 6.928(4) Å, α = γ = 90°, β = 93.418(6)°, V = 591.1(3) ?³, Z = 2, μ = 0.178 mm^?1, and F(000) = 348. The thermal stability and non-isothermal kinetics of DATNBI were studied by differential scanning calorimeter (DSC) with heating rates of 5, 10, 15, and 20 K min^?1. The apparent activation energy (E_a) at the first decomposition peak calculated by Kissinger, Ozawa, and Starink equations were 85.50, 89.67, and 86.10 kJ mol^?1, respectively. For the second peak, these were 116.49, 119.82, and 117.45 kJ mol^?1, respectively, with individual pre-exponential factors lnA = 18.40 s^?1 and lnA = 25.11 s^?1. The thermogravimetry-Fourier transform infrared spectroscopy (TG-FTIR) analysis of thermal decomposition products reveals that the main decomposition gas products are H₂O, N₂O, CO₂, and NO₂. Based on the new crystalline densities, the detonation velocity and pressure predicted by EXPLO5 are 9062 m s^?1 and 36.4 GPa, respectively.     

Properties and carbonization behavior of asphalt modified with the THF-soluble fraction of a coal liquefaction residue

This study focuses on the effects of the tetrahydrofuran-soluble fraction of direct coal liquefaction residue as a modifier to modify asphalt with formaldehyde. The properties and carbonization behavior of matrix asphalt and the modified asphalts were studied. The results indicate that the ductility properties of modified asphalts have been effectively improved. The morphology of modified asphalts without the addition of formaldehyde is a set of uniform distribution point, and it is converted from linear distribution to clustered distribution observed in fluorescence microscope images with the increase of the adding amount of formaldehyde.     

Palladium and Copper Cocatalyzed Intermolecular Cyclization Reaction: Synthesis of 5‐Aminopyrazole Derivatives

A novel and efficient palladium and copper co‐catalyzed intermolecular cyclization of acetonitriles with hydrazones has been developed for the synthesis of 5‐aminopyrazoles through C C and C N bond formation. The reaction has the advantages of easily available starting materials, simple manipulation and mild reaction conditions. The reaction involving various substituted acetonitriles and hydrazones proceeds smoothly and 5‐aminopyrazoles are synthesized in good yields. In contrast to the aliphatic and heteroaromatic substrates, the aromatic substrates tend to have a higher degree of reactivity.