�¸�������в������Ȼ�����꾮�ٶȵ�;��

本文针对天然气井提高钻井速度问题,总结分析了盆地中部井身结构,水力、机械参数,聚合物钻井液,正注反挤固井等工艺技术对该地区钻速的影响。指出提高天然气井钻井速度,必须搞好系统工程,形成配套技术。     

^60Coγ射线对刚地弓形虫缓殖子感染性的影响

应用不同剂量的~(60)Coγ射线照射含NT株弓形虫包囊的鼠脑匀浆后,以0.4％胰蛋白酶液消化,使弓形虫缓殖子从包囊中释放出来,并用生理盐水作连续10倍稀释,使成为含不同数量缓殖子的悬液,将此悬液接种小鼠,用生物检测方法确定其感染性。另设未经照射处理的缓殖子悬液感染小鼠的对照组。结果表明,γ射线0.55kGy剂量为控制鼠脑中NT株弓形虫感染性的最小有效剂量。γ射线0.1kGy剂量对弓形虫缓殖子感染性无明显影响,而0.45kGy照射后,其感染性较前者下降了10~4倍。     

Minimal communication cost software construction in the Internet environment

This paper investigates the issue of building software in the Internet environment, where local area network (LAN) based systems are interconnected by links with different bandwidth and do not share file systems. The software is modeled as a directed acyclic graph. Each node in the graph represents a logical step in processing the software while the edges describe the order of execution. The problem is to construct the software at a particular LAN with minimum Internet communication cost. An optimal polynomial algorithm, SOFTCON, with time complexity is presented, where and are the number of nodes and edges in the graph describing the software respectively, is the number of LANs in the Internet environment, and is the time complexity of the network flow algorithm on the flow network with nodes and edges transformed from the directed acyclic graph of the software. Received: 6 December 1995 / 1 May 1996     

On solving constrained optimization problems with neural networks:a penalty method approach

Deals with the use of neural networks to solve linear and nonlinear programming problems. The dynamics of these networks are analyzed. In particular, the dynamics of the canonical nonlinear programming circuit are analyzed. The circuit is shown to be a gradient system that seeks to minimize an unconstrained energy function that can be viewed as a penalty method approximation of the original problem. Next, the implementations that correspond to the dynamical canonical nonlinear programming circuit are examined. It is shown that the energy function that the system seeks to minimize is different than that of the canonical circuit, due to the saturation limits of op-amps in the circuit. It is also noted that this difference can cause the circuit to converge to a different state than the dynamical canonical circuit. To remedy this problem, a new circuit implementation is proposed.     

垂直平行束状孔爆破模型试验与分析

垂直平行密集束状孔落矿有底柱崩落法是一种新的采矿方法。通过爆破模型试验，测试爆破应力，观察分析爆破效果，探求最佳布孔形式，选择最优爆破孔网参数。试验结果表明：用平行束状孔取代扇形落矿，改善了爆破效果，简化了采场结构，减少了采切工程量。     

Influences of artificial pre-stressing on ply stresses and tensile properties of Vinylon fibre-reinforced aluminium laminates (VIRALL)

A simple micromechanical model based primarily upon the rule-of-mixtures is developed which allows prediction of the effects of fibre preload on the ply stresses (i.e., the initial residual stresses of fibre, adhesive and matrix) induced within VIRALL laminates, and the tensile stress-strain curves and mechanical properties of VIRALL laminates. The analysis of the ply stresses of VIRALL laminates indicates that pre-stressing will dramatically influence the ply stresses. The predicted tensile stress-strain curves of VIRALL laminates are in good agreement with the experimental curves and the results show that the stress-strain curves of VIRALL laminates move upwards when the prestress increases. The predicted tensile mechanical properties of VIRALL laminates at room temperature show good agreement with those obtained experimentally; both show that prestress can improve the tensile properties (i.e., elastic limit strength, 0.2% yield strength and failure strength) of VIRALL laminates.     

The application of transmission-line modelling to the simulation ofan induction motor drive

The simulation of a complete induction motor drive is presented. The entire network is modelled using the transmission-line modelling (TLM) technique. The network is split into three sections which are solved independently and are joined together by link transmission-line models. Advantages of this approach are the explicit nature of the algorithm which remains unaltered irrespective of the network topology, unconditional stability, and straightforward modelling of switching elements. Results are presented for a complete drive which illustrate the capabilities and flexibility of the simulation technique     

电子型／离子型导电高分子共混物

用苯胺在酸性水溶液中的进行化学氧化聚合合成了能溶于Ｎ－甲基吡咯烷酮的高分子量聚苯胺（ＰＡｎ），并用这种ＰＡｎ与一种高分子固态离子导体－－聚乙二醇聚醚氨酯脲（ＰＥＵＵ）和ＬｉＣｌＯ４的复合物（ＰＥＵＵ－ＬｉＣｌＯ４）进行溶液共混制得了具有电子型／离子型两种导电功能的新型高分子共混物。用差示扫描量热法、动态粘弹仪、应力－应变试验、四探针法和交流阻抗谱对这种高分子共混物进行研究。实验结果表明，上述ＰＡｎ     

析出物对IF钢性能的影响

一种阻性的晶闸管控制制动器被用于阻尼向串联补偿传输供电的热电发电机中的瞬态扭。重点放在开发适用的控制算，并通过多种不同的运行方式验证算法。作为一种制动器最优控制的可能方法，本文研究了离散等级一般化预先控制（ＧＰＣ），讨论了系统上ＧＰＣ执行过程中存在一些问题。用Ｐｒｏｎｇ分析来辩识系统传递函数，此传递函数与控制方案的考虑及强度特性有关。