Surface leakage currents in SiN/sub x/ passivated AlGaN/GaN HFETs

A novel guarded surface leakage test structure is used to isolate the surface and bulk leakage contributions to gate current in AlGaN/GaN HFETs. Passivation with various recipes of SiN/sub x/ always resulted in the commonly observed increase in gate leakage, which was found to be dominated by bulk leakage through the AlGaN. However, high temperature deposited SiN/sub x/ recipes gave a 1-2 orders reduction in surface leakage, whereas low temperature deposition gave an increase. Gate lag measurements were found to correlate closely with the surface leakage component, giving direct evidence that the key device problem of current slump is associated with current flow at the AlGaN surface.     

高功率双工旋转场移相器

旋转场移相器具有移相精度高(均方根误差可小于1°)和温度稳定性好等特点,通过改进射频传输结构,可大大提高他的功率容量。利用旋转场移相器的互易特性和铁氧体圆极化器的非互易特性,设计出高功率双工旋转场移相器。其双工特性可将收/发信号分开,实现移相器和环行器的双重功能,用于天线的收发通道等场合时,可省去一个高功率环行器,结构紧凑。分析了双工旋转场移相器的工作原理,阐述了高功率应用下的设计方法,推导出了管状铁氧体的相移量计算公式,按此方法设计了实用的器件,并给出了试验数据。     

影响喷气燃料与橡胶相容性的因素

采用几种具有不同初始物理性能及不同丙烯腈含量、不同硫化剂和硫化程度的丁腈橡胶，考察了其配方和物理性能对采用不同工艺条件生产的喷气燃料的相容性。结果表明，喷气燃料与橡胶的相容性不仅与喷气燃料的加工工艺有关，而且与橡胶的组成及其制备工艺有关。采用非加氢工艺生产的喷气燃料与橡胶的相容性好于采用加氢工艺(特别是加氢裂化工艺)生产的喷气燃料。橡胶材料的初始力学性能的好坏并不完全决定其与喷气燃料相容性的好坏，橡胶材料的耐过氧化物侵蚀能力才是影响相容性好坏的主要因素。橡胶的组成和其制备工艺决定了橡胶在喷气燃料中萃取物的数量和组成，不同萃取物的综合作用给相容性带来不同程度的影响。用硫作硫化剂的橡胶虽然原始强度低于用过氧化物作硫化剂的橡胶，但前者与喷气燃料的相容性却远好于后者。     

Study of miscibility enhancement in poly(styrene‐co‐4‐vinylphenol)/poly(ethylene oxide) blends by the spin labelling method

The electron spin resonance (ESR) spectra of end‐group spin labelled poly(ethylene oxide) (SLPEO) using 2,2,6,6‐tetramethyl‐piperdine‐1‐oxyl nitroxide and its blends with poly(styrene‐co‐4‐vinylphenol) (STVPhs) of different hydroxyl contents were recorded over a wide temperature range. For a blend of SLPEO and pure polystyrene (PS), the ESR spectrum was composed of a single motion component, indicating that PS was immiscible with PEO. For blends composed of SLPEO and different‐hydroxyl‐content STVPhs, two spectral components with different motion rates were observed over a certain temperature range. The difference between the motion rates should be attributed to micro‐heterogeneity in the blends, with the faster rate corresponding to a nitroxide radical motion trapped in the PEO‐rich domain and the slower rate corresponding to a nitroxide radical motion trapped in the STVPh‐rich domain. Variations in the values of a number of the ESR parameters (T_a, T_d and T_50G) and the apparent activation energy (E_a) with hydroxyl content in the blends indicated that the miscibility of the blends increased with increasing hydrogen‐bonding density due to specific interactions between the hydroxyl groups in STVPh and the ether oxygens in PEO. Copyright © 2004 Society of Chemical Industry     

Bandwidth renegotiation for VBR video over ATM networks

A scheme for delivery or variable bit-rate (VBR) video over asynchronous transfer mode (ATM) networks where bandwidth can be renegotiated during the duration of a call between the video source and the network is considered. Renegotiation can be initiated by either the video source or the network. The video bandwidth requirement is characterized by a usage parameter control (UPC) consisting, in general, of peak rate, burst length, and sustained rate. A baseline design is outlined where rate-control adjusts the source's rate while a new UPC is requested from the network. When granted, the new UPC allows the source to maintain its target quantization and delay requirements. Rate control epochs may be extended when the network blocks UPC requests or sets a lower UPC value to temporally deal with congestion. Simulation results are presented for VBR MPEG video. The results show that with a moderate renegotiation rate the scheme tracks the bandwidth requirements of the source. As a result, the video quality and bandwidth efficiency can be maintained     

An isolated ZVS/ZCS flyback converter using the leakage inductanceof the coupled inductor

This paper describes a simple and effective way to modify an existing hard-switched flyback power converter into a circuit with zero-voltage switching (ZVS) and zero-current switching (ZCS). The key improvement is to turn the unattractive features of the coupled inductor leakage inductance and snubber capacitor into attractive ones. The coupled inductor leakage inductance and snubber are used to form a quasi-resonant circuit to facilitate ZVS/ZCS of all power devices. The operating principles of the power converter and experimental results are presented     

CFCA与各商业银行建立"网银反欺诈联动机制"

近日,“网上银行反欺诈联动机制”联合声明暨“2007放心安全用网银联合宣传年”启动新闻发布会在北京召开,此次会议由“放心安全用网银联合宣传年”活动组委会主办。“放心安全用网银联合宣传年”活动是     

Random discrete PWM method for DC-DC power converters

A random discrete pulse-width modulation (RDPWM) scheme is examined and compared with the randomised pulse-position modulation (RPPM) method for DC-DC power conversion. The RDPWM method has no switching harmonics while the RPPM method has significant switching harmonics. Power spectral characteristics of the two methods are presented and discussed