Data retention characteristics of sub-100 nm NAND flash memory cells

In contrast to the conventional theories, we have revealed that the most distinguished mechanism in the data retention phenomenon after Fowler-Nordheim (FN) stress in sub-100 nm NAND Flash memory cells is the annihilation of interface states. Interface state generation rate increases rapidly as the channel width of NAND flash cell decreases. Comparison of interface states and stress-induced leakage current (SILC) component during retention mode shows that the annihilation of interface states strongly affects data retention characteristics of the programmed cells.     

Presenting information on the small-screen interface: effects of table formatting

This study explored strengths and limitations of table formatting choices by engaging twenty-eight participants in information searches in online tables, presented on a small-screen interface (Palm IIIc). Table length across conditions was held constant at three screens long (24 rows total) but varied from one to three screens wide (approximately 35, 70, and 105 characters per line). Target information was positioned in either the upper left, lower left, upper right, or lower right quadrants. Data collected were time on task, error rate, and level of participants' confidence in their answers. Experimenters found that increased horizontal scrolling imposed the heaviest burden on information search. This study supports restricting table widths to one screen on handheld computers. If necessary, however, tables can go to two screens wide without critical detriment to usability. While ruled line formatting is slightly better than interface character in providing visual support for the burden of horizontal scrolling, neither formatting option adequately compensates for the added burden.     

Origin of the threshold voltage instability in SiO/sub 2//HfO/sub 2/ dual layer gate dielectrics

The magnitude of the V/sub T/ instability in conventional MOSFETs and MOS capacitors with SiO/sub 2//HfO/sub 2/ dual-layer gate dielectrics is shown to depend strongly on the details of the measurement sequence used. By applying time-resolved measurements (capacitance-time traces and charge-pumping measurements), it is demonstrated that this behavior is caused by the fast charging and discharging of preexisting defects near the SiO/sub 2//HfO/sub 2/ interface and in the bulk of the HfO/sub 2/ layer. Based on these results, a simple defect model is proposed that can explain the complex behavior of the V/sub T/ instability in terms of structural defects as follows. 1) A defect band in the HfO/sub 2/ layer is located in energy above the Si conduction band edge. 2) The defect band shifts rapidly in energy with respect to the Fermi level in the Si substrate as the gate bias is varied. 3) The rapid energy shifts allows for efficient charging and discharging of the defects near the SiO/sub 2//HfO/sub 2/ interface by tunneling.     

Effect of exponentially graded base doping on the performance ofGaAs/AlGaAs heterojunction bipolar transistors

The authors have fabricated n-p-n GaAs/AlGaAs heterojunction bipolar transistors (HBTs) with base doping graded exponentially from 5×10¹⁹ cm^-3 at the emitter edge to 5×10¹⁸ cm^-3 at the collector edge. The built-in field due to the exponentially graded doping profile significantly reduces base transit time, despite bandgap narrowing associated with high base doping. Compared to devices with the same base thickness and uniform base doping of 1×10¹⁹ cm^-3 , the cutoff frequency is increased from 22 to 31 GHz and maximum frequency of oscillation is increased from 40 to 58 GHz. Exponentially graded base doping also results ill consistently higher common-emitter current gain than uniform base doping, even though the Gummel number is twice as high and the base resistance is reduced by 40%     

89-GHz fT room-temperature silicon MOSFETs

The authors report the implementation of deep-submicrometer Si MOSFETs that at room temperature have a unity-current-gain cutoff frequency (f_T) of 89 GHz, for a drain-to-source bias of 1.5 V, a gate-to-source bias of 1 V, a gate oxide thickness of 40 Å, and a channel length of 0.15 μm. The fabrication procedure is mostly conventional, except for the e-beam defined gates. The speed performance is achieved through an intrinsic transit time of only 1.8 ps across the active device region     

Synthesis and characterization of poly(siloxane-urethane)s

A series of polyurethane block copolymers based on hydroxy-terminated polydimethylsiloxane and poly(propylene glycol) soft segments of molecular weights 1818 and 2000, respectively, were synthesized. The hard segments consisted of 4,4′-diphenylnethane diisocyanate and 1,4-butanediol as the chain extender. Samples with different molar ratios were prepared. We tried to synthesize polydimethylsiloxane-based polyurethanes (PDMS-PU) containing a hard block as major fraction and a soft block as minor fraction for preparing toughened rigid systems. After a study of the pure polydimethylsiloxane-based polyurethane and poly(propylene glycol)-based polyurethane (PPG-PU), (mixed polyol)-based block copolymers and blends of PDMS-PU and PPG-PU were synthesized, and characterized by means of differential scanning calorimetry, tensile testing and scanning electron microscopy. In (mixed polyol)-based copolymers and lower hard-segment content blends, macro-phase separation occurred, but blends with higher hard-segment contents showed significant reduction in amounts of phase separation.     

Differential K+ channel clustering activity of PSD-95 and SAP97, two related membrane-associated putative guanylate kinases

The molecular mechanisms underlying the clustering and localization of K+ channels in specific microdomains on the neuronal surface are largely unknown. The Shaker subclass of voltage-gated K+ channel alpha-subunits interact through their cytoplasmic C-terminus with a family of membrane-associated putative guanylate kinases, including PSD-95 and SAP97. We show here that heterologous coexpression of either sap97 or PSD-95 with various Shaker-type subunits results in the coclustering of these proteins with the K+ channels. Mutation of the C-terminal sequence (-ETDV) of the Shaker subunit Kv1.4 abolishes its binding to, and prevents its clustering with, SAP97 and PSD-95. Whereas PSD-95 induces plaque-like clusters of K+ channels at the cell surface; however, SAP97 coexpression results in the formation of large round intracellular aggregates into which both SAP97 and the K+ channel proteins are colocalized. The efficiency of surface clustering by PSD-95 varies with different Shaker subunits: striking Kv1.4 clustering occurs in > 60% of cotransfected cells, whereas Kv1.1 and Kv1.2 form convincing clusters with PSD-95 only in approximately 10% of cells.     

Mixing in processing of thermoplastics by extrusion

Translated from Khimicheskoe i Neftyanoe Mashinostroenie, No. 8, pp. 9–11, August, 1993.     

Reduction of loading effect by tungsten etchback in a magneticallyenhanced reactive ion etcher

The plug loading effect occurring during the etchback of tungsten was investigated in a magnetically enhanced reactive ion etcher using SF ₆/Ar mixtures. It was found that while the plug loading effect is independent of varying SF₆/Ar flow rate ratio and magnetic field intensity, it is reduced under the condition of high selectivity of tungsten relative to TiN which was achieved at high chamber pressure and low RF power. It is proposed that when TiN is used as a glue layer, the W etch rate enhancement in the plug is mainly controlled by a local loading effect. Under the optimized etchback conditions the plug loss was successfully controlled without the tungsten residue left on severe topology