Analysis of an interferometric optical fibre detection technique applied to silicon vibrating sensors

A simple and accurate analysis of a single-mode optical fibre interferometric displacement detection technique is resented. This analysis is in good agreement with experimental measurements, and shows that angular alignment between the fibre and the sensor is the most critical parameter.     

Ghana

A strategic task for building research in the Ghanaian context should be to give new life to well-tried methods and to develop the local resources of labour and materials, writes the director of the Building and Road Research Institute at Kumasi. The reasons are not only economic - saving scarce foreign exchange - but social, by creating viable local industries. This article concentrates on the housing-related studies and reports a few projects which have tried to apply the concepts in a practical way.     

Survival of rotavirus SA-11 on vegetables

Survival of rotavirus on lettuce, radishes, and carrots was studied to evaluate the potential of rotavirus transmission by vegetables irrigated with wastewater. The vegetables were contaminated with rotavirus SA-11 and stored at 4°C and room temperature in covered and uncovered containers to simulate post harvest conditions. Virus decay rates were greater on radishes and carrots than lettuce. Decay rates of rotavirus on lettuce, radish, and carrot ranged from ?0·057 to ?0·479 (log₁₀ pfu/day). Rotavirus SA-11 survived on lettuce, radish, and carrot for 25 to 30 days at 4°C but at room temperature survival was very different for the various vegetables varying from 5 to 25 days. Greatest survival was always observed on the lettuce. These data suggest that rotaviruses can survive long enough on contaminated vegetables as to be transmitted by this vehicle.     

The impact of multiple failure modes on estimating product field reliability

A difficulty in reliability modeling is how to capture the impact of all of the various reliability defect types. The general approach to optimizing burn-in that we describe in this article addresses a multiple-defect environment. The approach has four main parts: (i) modeling the product's failure rate distribution, (ii) establishing the Pareto distribution of reliability defects, (iii) assessing the kinetic information of each reliability defect, and (iv) estimating the DPPM under product use conditions. This article compares and contrasts the acceleration effects of various extrinsic defects found in 130- and 90-nm CMOS technology products.     

Analytical approaches to characterising fish tainting potential of oil sands process waters.

A three-stage study has been carried out with rainbow trout (Oncorhyncus mykiss) to develop analytical approaches which can provide a fingerprint for tainting by oil sands chemicals from process-affected waters and natural sources. The objective was to find a simpler alternative to sensory evaluation. In the first stage, a set of seven test compounds was added to fish tissue which was analysed by headspace and solvent (dichloromethane, DCM) extraction followed by gas chromatography-mass spectrometry (GC-MS). In the second stage, fingerlings (5-20 g) were exposed for 96 hours to the test compound mixture at 1.0 and 0.5 times the estimated tainting threshold concentrations. In the final stage, fingerlings were exposed for 96 hours to an oil sands process water at 5, 10, 20 and 50% concentrations in clean water. None of the test compounds was identified in DCM extracts of tissue from exposed fish. Two long-chain aldehydes, hexadecanal and 9-octadecenal, were tentatively identified in these extracts by matching of mass spectra with library spectra.     

The possibility of evolving a theory for predicting the service life of reinforced concrete structures

The development in recent years with increasing air pollution, increasing need of energy saving and last not least the growing number of damage in old structures leads to a raising demand to calculate the durability of structures, too. The paper has been prepared by request of the RILEM Technical Committee 45-LTO to show that, in principle, it is possible to evolve a theory for predicting the service life of r.c. structures and to sketch a way how that could be achieved. A lot of necessary basic data can be found scattered in the literature. To collect these data will be the first step to take.     

Ultrasound as a pre-oxidation for biological landfill leachate treatment.

In this study, the effects of low energy ultrasound irradiation on landfill leachate treatment by means of sequencing bath reactor were investigated. The aim of this work was to estimate the influence of leachate irradiation time on aerobic treatment efficiency. The sonification of the leachate was carried out in static conditions using the disintegrator UD-20. The field frequency of 22 kHz (the power output equals to 180 W) and amplitude of 12 microm was applied. The sonification time was changed in the range of 30-140 s. It was found that ultrasonic pretreatment enhances the subsequent aerobic digestion resulting in a better degradation of landfill leachate. The sonification of raw leachate leads to enhancement of COD and ammonia removal as compare to experiment without ultrasound.     

Aqua-Biomant: integrated biological and electrochemical oxidation for industrial wastewater treatment.

An innovative technology for industrial wastewater treatment has been developed. The main focus of the new system is a transformation of persistent organic compounds (biorecalcitrant COD) into a biodegradable fraction, followed by high efficient biological elimination using specialised bacteria's. To fulfill these targets the Aqua-Biomant process integrates two treatment steps: an aerated biological upflow filter and a electrochemical oxidation technique using boron doped-diamond electrodes. The advantages of the process are high efficient COD removal with reduced energy consumption combined with low total residence time.