Refrigerant Distribution in a Minichannel Evaporator Having Vertical Headers

Refrigerant R-410a flow distribution is experimentally studied in a test section simulating a minichannel heat exchanger having vertical headers with two pass configuration. Tubes are heated to yield a test section outlet superheat of 5°C with inlet quality of 0.3. Mass flux is varied from 60 kg/m²-s to 70 kg/m²-s. Effects of outlet locations are investigated in a search for an optimum configuration. The effect of varying the number of tubes of each pass is also investigated. Results show that significant liquid flows through bottom channels, and less liquid is supplied to top channels. For the outlet location, a bottom outlet is better than a middle or top outlet. In addition, assigning a lower number of tubes to inlet pass yields better flow distribution. Correlations are developed for the fraction of liquid or gas taken off by the downstream channel as a function of header gas Reynolds number immediately upstream. The correlations may be used to predict the liquid or gas distribution in a parallel-flow heat exchanger havin vertical headers.     

Monomer concentration effect on the phase behavior of poly(propyl acrylate) and poly(propyl methacrylate) with supercritical CO2 and C2H4

Experimental cloud-point data to temperature of 186 °C and pressure of ~2,500 bar are presented for ternary mixtures of poly(propyl acrylate)(PPA)-CO₂-propyl acrylate (PA) PPA-C₂H₄-PA and poly(propyl methacrylate) (PPMA)-CO₂-propyl methacrylate (PMA) systems. Cloud-point pressures of PPA-CO₂-PA system were measured in the temperature range of 32 °C to 175 dgC and to pressures as high as 2,070 bar with PA concentrations of 0.0, 5.0, 11.7 and 30.4 wt%. Adding 34.1 wt% PA to the PPA-CO₂ mixture significantly changes the phase behavior. This system changes the pressure-temperature slope of the phase behavior curves from U-LCST region to LCST region as the PA concentration increases. Cloud-point data to 170 °C and 1,400 bar are presented for PPA-C₂H₄-PA mixtures and with PA concentration of 0.0, 5.7, 15.5 and 22.2 wt%. The cloud-point curve of PPA-C₂H₄ system shows relatively flat at 730 bar for temperatures between 41 and 150 °C. With 15.5 and 22.2 wt% PA the cloud-point curve exhibits a positive slope that extends to 35 °C and ~180 bar. Also, the ternary PPMA-CO2-PMA system was measured below 186 °C and 2,484 bar, and with cosolvent of 5.2-20.1 wt%. PPMA does not dissolve in pure CO₂ to 233 °C and 2,500 bar. Also, when 41.5 wt% PMA is added to the PPMA-CO₂ solution, the cloud-point curve shows the typical appearance of a lower critical solution temperature (LCST) boundary.     

Effect of angiotensin I converting enzyme inhibitory peptide purified from skate skin hydrolysate

Our objective was to evaluate the angiotensin I converting enzyme (ACE) inhibitory activity of skate skin protein hydrolysates and its corresponding fractions. The skate skin hydrolysates were obtained by enzymatic hydrolysis using alcalase, α-chymotrypsin, neutrase, pepsin, papain, and trypsin. Amongst the six hydrolysates, the α-chymotrypsin hydrolysate had the highest ACE inhibitory activity compared to other hydrolysates. The amino acid sequences of the purified peptides were identified to be Pro–Gly–Pro–Leu–Gly–Leu–Thr–Gly–Pro (975.38 Da), and Gln–Leu–Gly–Phe–Leu–Gly–Pro–Arg (874.45 Da). The purified peptides from skate skin had an IC₅₀ value of 95 μM and 148 μM, respectively, and the Lineweaver–Burk plots suggest that they act as a non-competitive inhibitor against ACE. Our study suggested that novel ACE inhibitory peptides derived from skate skin protein may be beneficial as anti-hypertension compounds in functional foods.     

Double S-Shaped Polarization – Voltage Curve and Negative Capacitance from Al2O3-Hf0.5Zr0.5O2-Al2O3 Triple-Layer Structure

The negative capacitance (NC) effect, recently discovered in a fluorite-based ferroelectric thin film, has attracted great attention as a rescue to overcome the scaling limitations of the conventional memory and logic devices of highly integrated circuits. The NC effect manifesting an S-shaped polarization–voltage (P–V) curve is initially interpreted by a 1-dimensional Landau Ginzburg Devonshire (LGD) model. However, a series of recent studies have found that this effect can also be explained by the inhomogeneous stray field energy (ISE) model. In this study, by extending the ISE model in the ferroelectric (FE)-dielectric (DE) layered structure, an analytical model that considers the influence of the interfacial screening charge distribution is presented. This model showed that the NC effect in the FE-DE heterostructure can be manifested in various forms other than a single S-shaped P–V curve. In particular, a double S-shaped P–V curve is expected from the fully compensated anti-parallel domain structure, confirmed experimentally in the actual Al₂O₃/(Hf_0.5Zr_0.5)O₂/Al₂O₃ triple-layer structure. Furthermore, to reveal the origin of the double S-shaped P–V curve, a multidomain LGD model is presented. It is confirmed that this phenomenon is attributed to the evolution of inhomogeneous stray field energy.     

High temperature fracture characteristics of a nanostructured ferritic alloy (NFA)

The nanostructured ferritic alloys (NFAs) have been developed to improve high temperature strength and radiation resistance by refining grains and including nanoclusters. Among the key properties of NFAs needed to be assessed for advanced reactor applications the cracking resistance at high temperatures has not been well known. In this work, therefore, the high temperature fracture behavior has been investigated for the latest nanostructured ferritic alloy 14YWT (SM10). The fracture toughness of the alloy was above 140 MPa √m at low temperatures, room temperature (RT) and 200 °C, but decreased to a low fracture toughness range of 52-82 MPa √m at higher temperatures up to 700 °C. This behavior was explained by the fractography results indicating that the unique nanostructure of 14YWT alloy produced shallow plasticity layers at high temperatures and a low-ductility grain boundary debonding occurred at 700 °C. The discussion also proposes methods to improve resistance to cracking.     

Hydrogenation of carbon monoxide to methane over mesoporous nickel-M-alumina (M = Fe,Ni, Co,Ce, and La) xerogel catalysts

Mesoporous nickel(30 wt%)-M(10 wt%)-alumina xerogel (30Ni10MAX) catalysts with different second metal (M = Fe, Ni, Co, Ce, and La) were prepared by a single-step sol–gel method for use in the methane production from carbon monoxide and hydrogen. In the methanation reaction, yield for CH₄ decreased in the order of 30Ni10FeAX > 30Ni10NiAX > 30Ni10CoAX > 30Ni10CeAX > 30Ni10LaAX. Experimental results revealed that CO dissociation energy of the catalyst and H₂ adsorption ability of the catalyst played a key role in determining the catalytic performance of 30Ni10MAX catalyst in the methanation reaction. Optimal CO dissociation energy of the catalyst and large H₂ adsorption ability of the catalyst were favorable for methane production. Among the catalysts tested, 30Ni10FeAX catalyst with the most optimal CO dissociation energy and the largest H₂ adsorption ability exhibited the best catalytic performance in terms of conversion of CO and yield for CH₄ in the methanation reaction. The enhanced catalytic performance of 30Ni10FeAX was also due to a formation of nickel–iron alloy and a facile reduction.     

Effect of pH on non-enzymatic browning reaction during γ-irradiation processing using sugar and sugar–glycine solutions

Effects of pH on the non-enzymatic browning reaction caused by γ-irradiation processing were investigated. The brown colour development of irradiated sugar–glycine solutions was greater in a buffer system than in deionized distilled water (DDW) with higher pH. Although browning of irradiated sugar solution without glycine was highly increased was in alkaline buffer, no browning was developed in DDW. The maximum browning of the solutions of sugar and sugar–glycine were observed at pH 10 and pH 8, respectively. The browning intensity was in the following order: sucrose ? fructose > glucose. Non-constant pH was observed in DDW (dropped pH between 1.58 and 2.03 units); however, the use of buffers was partially effective in keeping pH constant (pH dropped between 0.03 and 0.56 units). When the irradiated solutions of sugar with and without glycine were analyzed using reverse phase high performance liquid chromatography with diode-array detection (HPLC-DAD), three peaks were separated at 3.37 ± 0.04, 4.60 ± 0.02, and 2.53 ± 0.26 min, and the λ_max values of these peaks were the range 259–288 nm. The sum of the areas of these peaks at 260 nm increased with increasing pH. The results of this study indicated that conditions of the system, such as pH and media, can influence the non-enzymatic browning reaction during γ-irradiation.     

An assessment of the science and technology of carbon nanotube-based fibers and composites

This paper examines the recent advancements in the science and technology of carbon nanotube (CNT)-based fibers and composites. The assessment is made according to the hierarchical structural levels of CNTs used in composites, ranging from 1-D to 2-D to 3-D. At the 1-D level, fibers composed of pure CNTs or CNTs embedded in a polymeric matrix produced by various techniques are reviewed. At the 2-D level, the focuses are on CNT-modified advanced fibers, CNT-modified interlaminar surfaces and highly oriented CNTs in planar form. At the 3-D level, we examine the mechanical and physical properties CNT/polymer composites, CNT-based damage sensing, and textile assemblies of CNTs. The opportunities and challenges in basic research at these hierarchical levels have been discussed.     

TCP-friendly congestion control for streaming real-time applications over wireless networks

Congestion control for streaming real-time applications, which need smoothness of the transmission rate, should be transmission control protocol (TCP)-friendly. Moreover, in wireless networks, TCP-friendly congestion control should be based on differentiation of packet losses due to congestion and wireless link error to improve network utilisation. The authors propose a TCP-friendly congestion control algorithm based on explicit congestion notification over the wireless networks. The simulation results show that the proposed algorithm utilises the link bandwidth efficiently, providing smoothness of the transmission rate.