Easy,Green and Safe Carbonylation Reactions through Zeolite‐Catalyzed Carbon Monoxide Production from Formic Acid

Zeolites with the right shape and acid site density and strength, such as certain ZSM‐5 forms, were able to cleanly decompose formic acid to carbon monoxide (CO), and the latter could be directly used in palladium‐catalyzed carbonylation reactions. A simple two‐reactor system was designed to produce CO conveniently and then further react this gas in a safe way. The two‐reactor system is particularly cheap, easy to set up and use. In addition, the carbonylation conditions without pressure allowed for very efficient CO incorporation, with only 1% of palladium(II) chloride (PdCl₂) and Xantphos.

     

Synthesis of α‐cellulose/polypyrrole composite for the removal of reactive red dye from aqueous solution: Kinetics and equilibrium modeling

In this work, a composite from α‐cellulose coated with conducting polypyrrole by in situ polymerization using potassium persulfate as oxidant was obtained. The composite was characterized by fourier transform infrared (FTIR) spectroscopy, cyclic voltammetry, UV/Vis spectroscopy, and scanning electron microscopy (SEM) analysis showed homogeneous coating of α‐cellulose with polypyrrole (PPy) to produce a composite with a conductivity of 3.5 × 10⁻⁵ S/m. Batch aqueous adsorption experiments of the reactive red 120 (RR120) dye onto the synthesized material were conducted. The results showed that this composite is an efficient adsorbent for RR120 dye removal. For the adsorption experiments set to an initial pH of 3.9, the adsorption capacity was 15.6 mg of dye/g of composite for an equilibrium concentration (in the liquid) of RR120 dye equal to 1,000 mg/L, whereas a value of 96.1 mg of dye/g of composite was obtained when the solution pH was set to 2.0 for the same equilibrium concentration. When performing adsorption experiments using pure α‐cellulose, dye adsorption was insignificant at any pH value. Adsorption isotherm for RR120 was described by a typical Freundlich model. The transient adsorption of RR120 on the synthesized composite was described by a general three‐resistance model that includes the transport on the film that surrounds the composite particles, diffusion inside the particles, and adsorption on the surface of the particles. A fitting of the uptake curves was performed allowing the estimation of values for the effective diffusivity, D₀, and the adsorption rate coefficient, k₁. For the adsorption experiments with an initial pH value set to 3.9, D₀ was estimated as 1.05 × 10⁻¹⁰ m²/s, whereas k₁ was 1.65 × 10⁻⁴ Lⁿ/g mg^{n − 1} s; the corresponding values of k₁ at pH = 2 and 9.0 were 3.18 × 10⁻⁴ and 5.16 × 10⁻⁵, respectively. POLYM. COMPOS., 36:312–321, 2015. © 2014 Society of Plastics Engineers     

Strengthening effects of sprayed fiber reinforced polymers on concrete

The objectives of this study were twofold. The first was to investigate the compressive and flexural behaviors of small‐sized concrete specimens strengthened with sprayed fiber reinforced polymer (SFRP), considering various fiber lengths, fiber volumes, and concrete strengths. The second was to evaluate the strengthening effects of SFRP on the flexural behaviors of large‐sized reinforced concrete beams. U‐shaped strips and shear keys were applied to the test specimens to improve the interfacial bond resistance between the concrete surface and SFRP. POLYM. COMPOS., 36:722–730, 2015. © 2014 Society of Plastics Engineers     

Photoluminescence and electroluminescence imaging of perovskite solar cells

Fast camera‐based luminescence‐imaging measurements on perovskite solar cells are presented. The fundamental correlation between the luminescence intensity and the open circuit voltage predicted by the generalised Planck law is confirmed, enabling various quantitative methods for the detection of efficiency‐limiting defects to be applied to this new cell structure. Interstinegly, it is found that this fundamental correlation is valid only for light‐soaked devices. Copyright © 2015 John Wiley & Sons, Ltd.     

Impact of oxygen concentration during the deposition of window layers on lowering the metastability effects in Cu(In,Ga)Se2/CBD Zn(S,O) based solar cell

The purpose of the present paper is to focus on the impact of oxygen gas partial pressure during the sputtering of i‐ZnO and ZnMgO on the transient behavior of Cu(In,Ga)Se₂ (CIGSe) based solar cells parameters when a CBD‐Zn(S,O) buffer layer is used. Based on electrical characterization of cells, it is observed that the effect of light soaking is different on J–V characteristics depending on whether oxygen is or is not present during the first deposition time of the i‐ZnO or ZnMgO layers. In fact, when cells are prepared with standard i‐ZnO, the efficiencies are very low and a pronounced transient behavior is observed. However, when the first 10 nm of i‐ZnO or ZnMgO is formed by sputtered layer without adding oxygen during the process, depending on the thickness of the buffer layer, the transient effects strongly decreases. It is then possible to get stable cells reaching efficiencies quite similar to the CdS reference cells, especially with ZnMgO, without any post‐treatments. Copyright © 2015 John Wiley & Sons, Ltd.     

Electrochemical Performance of Nd1.95NiO4+δ Cathode supported Microtubular Solid Oxide Fuel Cells

Nd_1.95NiO_4+δ (NNO) cathode supported microtubular cells were fabricated and characterized. This material presents superior oxygen transport properties in comparison with other commonly used cathode materials. The supporting tubes were fabricated by cold isostatic pressing (CIP) using NNO powders and corn starch as pore former. The electrolyte (GDC, gadolinia doped ceria based) was deposited by wet powder spraying (WPS) on top of pre‐sintered tubes and then co‐sintered. Finally, a NiO/GDC suspension was dip‐coated and sintered as the anode. Optimization of the cell fabrication process is shown. Power densities at 750 °C of ∼40 mWcm⁻² at 0.5V were achieved. These results are the first electrochemical measurements reported using NNO cathode‐supported microtubular cells. Further developments of the fabrication process are needed for this type of cells in order to compete with the standard microtubular solid oxide fuel cells (SOFC).     

Effect of Oral and Parenteral N Nutrition vs N-Free Nutrition on the Endogenous Amino Acid Flow at the Ileum of the Pig*

Two methods were tested for suppressing the depressive effect of N-free diets on the digestive secretions in pigs: the blood perfusion of amino acids (AA) or the peptide alimentation method. In the latter, enzymically hydrolysed casein (EHC), composed of oligopeptides and free AA, was used as the source of nitrogen. The unabsorbed dietary N molecules were discarded from the ileal digesta by ultrafiltration or gel filtration, assuming that the endogenous fraction did not contain significant amounts of small molecules. The AA supply by blood perfusion had no effect on the ileal endogenous AA losses (8·0 g AA kg⁻¹ DM intake) in growing pigs (±50 kg), compared with the N-free diet alone (8·3 g), whereas the EHC supplementation significantly increased them (18·0 g). The increase was due to both endogenous and dietary N. The presence of unabsorbed dietary AA in the ileal digesta was confirmed by the AA profile of the soluble molecules with a very low molecular mass (<3 kDa), which was close to that of EHC. Both ultrafiltration (cut-offs of 3 or 10 kDa) and gel filtration methods, utilised to discard the remaining dietary molecules, also eliminated a significant proportion of endogenous AA.     

Retrogradation Kinetics of Eight Starches

Retrogradation rate and extent were determined by differential scanning calorimetry and rheology measurements on 40% dry matter gels made from pea, modified waxy maize, rice, waxy rice, wheat, manioc, potato and microwaved irradiated potato starches. As a result, each starch retrogrades differently, depending also on the measurement technique. Nevertheless, potato and pea starches seem to be the most sensitive and the waxy and modified waxy types are the least sensitive to retrogradation.     

Antioxidant properties,radical scavenging activity and biomolecule protection capacity of flavonoid naringenin and its glycoside naringin: a comparative study

BACKGROUND: This study was designed to evaluate and compare antioxidant capacity and radical scavenging activity of naringin and its aglycone by different in vitro assays. The effects of flavanones on lipid peroxidation, glutathione (GSH) oxidation and DNA cleavage were also assessed. RESULTS: The results showed that naringenin exhibited higher antioxidant capacity and hydroxyl and superoxide radical scavenger efficiency than naringin. Our results evidenced that glycosylation attenuated the efficiency in inhibiting the enzyme xanthine oxidase and the aglycone could act like a more active chelator of metallic ions than the glycoside. Additionally, naringenin showed a greater effectiveness in the protection against oxidative damage to lipids in a dose‐dependent manner. Both flavanones were equally effective in reducing DNA damage. However, they show no protective effect on oxidation of GSH. CONCLUSION: The data obtained support the importance of characterizing the ratio naringin/naringenin in foods when they are evaluated for their health benefits. Copyright © 2010 Society of Chemical Industry