P(VDF–HFP)/BST纳米复合薄膜的制备及介电、储能性能

采用溶液铸造法,以聚(偏氟乙烯–六氟丙烯)[P(VDF–HFP)]为基体、钛酸钡锶(BST)为填料制备了纳米薄膜材料。对薄膜的物相组成和微观形貌进行了表征,研究了BST含量对薄膜介电性能和储能性能的影响。结果表明,随着BST含量的增大,薄膜的介电常数显著上升,介电损耗在中、高频区域有所下降,击穿强度逐渐减小,薄膜的充电能量密度显著增大;介电常数的实测值与Maxwell-Wagner理论模型计算值基本吻合,表明填料和基体结合良好,薄膜材料内部组织均匀,无明显缺陷。此外,从实际应用的角度讲,外加电场强度低于800 kV/cm或介于800~2100 kV/cm时,为了获得最大的放电能量密度,应分别选用BST体积分数为30%或20%的P(VDF–HFP)/BST复合薄膜材料。     

Determination of twisting angle of electrospun nanofiber bundle for continuous electrospinning system

Electrospinning continuously produced twisted nanofibers with a convergence coil and a rotating ring collector. The positively charged nozzle was used in the electrospinning process to deposit electrospun fibers of polyacrylonitrile onto a rotating ring collector. By withdrawing the electrospun fibers from the rotating ring collector, it was possible to spin the electrospun fibers yarn. In this study, theoretical approaches and numerical simulations were used to determine the twisting angle of the yarn. Using the equations developed in this study, we performed numerical simulations and compared the experimental results with the numerical simulation results. Mechanical properties of the fiber bundle were analyzed for twisting angle. It was confirmed the relationship among the winding drum, the ring collector, and flux of the fibers mass per time during electrospinning in the developed system. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2017 , 134, 45528.     

Blue‐light‐emitting poly(arylene ethynylenes) containing alternating sequences of biphenylene or fluorenediyl and p‐phenylene moieties linked through triple bonds

Two new poly(arylene ethynylenes) were synthesized by the reaction of 1,4‐diethynyl‐2.5‐dioctylbenzene either with 4,4′‐diiodo‐3,3′‐dimethyl‐1,1′‐biphenyl or 2,7‐diiodo‐9,9‐dioctylfluorene via the Sonogashira reaction, and their photoluminescence (PL) and electroluminescence (EL) properties were studied. The new poly(arylene ethynylenes) were poly[(3,3′‐dimethyl‐1,1′‐biphenyl‐4,4′‐diyl)‐1,2‐ethynediyl‐(2,5‐dioctyl‐1,4‐phenylene)‐1,2‐ethynediyl] (PPEBE) and poly[(9,9‐dioctylfluorene‐2,7‐diyl)‐1,2‐ethynediyl‐(2,5‐dioctyl‐1,4‐phenylene)‐1,2‐ethynediyl] (PPEFE), both of which were blue‐light emitters. PPEBE not only emitted better blue light than PPEFE, but it also performed better in EL than the latter when the light‐emitting diode devices were constructed with the configuration indium–tin oxide/poly(3,4‐ethylenedioxythiophene) doped with poly(styrenesulfonic acid) (50 nm)/polymer (80 nm)/Ca:Al. The device constructed with PPEBE exhibited an external quantum efficiency of 0.29 cd/A and a maximum brightness of about 560 cd/m², with its EL spectrum showing emitting light maxima at λ = 445 and 472 nm. The device with PPEFE exhibited an efficiency of 0.10 cd/A and a maximum brightness of about 270 cd/m², with its EL spectrum showing an emitting light maximum at λ = 473 nm. Hole mobility (μ_h) and electron mobility (μ_e) of the polymers were determined by the time‐of‐flight method. Both polymers showed faster μ_h values. PPEBE revealed a μ_h of 2.0 × 10^?4 cm²/V·s at an electric field of 1.9 × 10⁵ V/cm and a μ_e of 7.0 × 10^?5 cm²/V·s at an electric field of 1.9 × 10⁵ V/cm. In contrast, the mobilities of the both carriers were slower for PPEFE, and its μ_h (8.0 × 10^?6 cm²/V·s at an electric field of 1.7 × 10⁶ V/cm) was 120 times its μ_e (6.5 × 10^?8 cm²/V·s at an electric field of 8.6 × 10⁵ V/cm). The much better balance in the carriers' mobilities appeared to be the major reason for the better device performance of PPEBE than PPEFE. Their highest occupied molecular orbital (HOMO) and lowest unoccupied molecular orbital (LUMO) levels were also a little different from each other. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 299–306, 2006     

Increased liver and lupus mortalities in 24-year follow-up of the Taiwanese people highly exposed to polychlorinated biphenyls and dibenzofurans

BACKGROUND: A follow-up study was designed to compare the 24-year overall and disease-specific mortality in Yucheng people who were highly exposed to polychlorinated biphenyls/dibenzofurans (PCBs/PCDFs) to that in the background population in Taiwan. In 1979, the Yucheng (oil-disease in Chinese) incident occurred in central Taiwan involving approximately 2000 victims due to ingestion of rice oil contaminated with PCBs/PCDFs. Long-term follow-up of these people has been continued for 24 years. METHODS: Standardized mortality ratios were calculated using the Taiwan population as comparison group. Overall and disease-specific mortality was compared between Yucheng and background populations. RESULTS: Mortality from chronic liver disease and cirrhoses was increased in the Yucheng men, but not in women, in the early period after exposure. Cancer mortality was not increased in the Yucheng population up to 24 years after exposure. SLE in females was highly increased in the later period after PCB/PCDF exposure. Mortality from disease in any other organ system was not significantly different between Yucheng and background populations. CONCLUSIONS: The study provided a long-term mortality picture after the Taiwanese PCB/PCDF exposure incident. In addition to re-confirming the increase in liver mortality, we found high mortality of SLE among exposed population. This finding highlights the importance of further investigating the immunological effects associated with PCB/PCDF exposure.     

Characterization of microbial community during Asian dust events in Korea

An Asian dust event, also sometimes known as a Yellow Sand event, is a seasonal meteorological phenomenon affecting East Asia, typically in the early spring. Because of the significant ecological and health effects of these events on East Asia, and the large amount of dust that is transported from the desert in China to Korea and Japan, these events have been receiving increased attention. It is likely that these storms often provide long-range transport to various microorganisms. However, despite a certain level of attention to the chemical analysis of these storms, microbiological studies of Yellow Sand dust have been scarce. We collected a total of 30 microbiological air samples using a PM_2.5 cyclone sampler in Seoul, Korea from April 2007 to March 2008. Six of these samples were collected during Yellow Sand events, while 24 were from non-Yellow Sand events. Chemical analysis was performed on the samples using a thermal–optical transmittance (TOT) method. Total nucleic acids were also extracted, and the 16S rDNA was amplified by PCR and analyzed by denaturing gradient gel electrophoresis (DGGE). Dendrogram analysis, based on DGGE, indicated that the microbial profiles from the Yellow Sand were distinctive from those of the non-Yellow Sand samples. Microorganisms identified in Yellow Sand samples included Aquabacterium sp., Flavobacteriales bacterium sp., Prevotellaceae bacterium sp., and others, whereas microorganisms in non-Yellow Sand samples included Propionibacterium sp., Bacillus sp., Acinetobacter sp., and others. These results suggest that, as a result of Yellow Sand events, humans in the affected regions are exposed to communities of microorganisms that might cause various adverse health effects.     

Measurement of neutron total cross-section and resonance parameters of xenon

We measured the neutron total cross-sections of natural xenon in the neutron energy region from 0.1 to 40 eV by using the time-of-flight method at the Pohang neutron facility, which consists of an electron linear accelerator, a water-cooled tantalum target with a water moderator, and a 12-m long time-of-flight path. A ⁶Li-ZnS(Ag) scintillator with a diameter of 12.5 cm and a thickness of 1.6 cm was used as a neutron detector. Notch filters composed of Co, In, Cd were used to estimate the background level and to calculate the neutron flight path length. The present measurement was compared with the existing experimental and the evaluated data. The resonance parameters of Xe isotopes were obtained from the transmission ratio by using the SAMMY code and were compared with other previous results.     

Influence of rosemary-tocopherol/packaging combination on meat quality and the survival of pathogens in restructured irradiated pork loins

Irradiated restructured pork loins treated with rosemary-tocopherol/double-packaging had lower TBARS values than vacuum-packaged control after 10 days of refrigerated storage. The rosemary-tocopherol combination, however, had no effect on the production of sulfur volatiles responsible for the irradiation off-odor, and color changes in irradiated pork. V7/A3 double-packaging was effective in reducing the sulfur volatiles significantly. Rosemary-tocopherol combination was highly effective in reducing the volatile hexanal in irradiated restructure pork. Irradiation was effective in reducing Listeria monocytogenes and Salmonella typhimurium inoculated on the surface of restructured pork loin in dose-dependent manner. The irradiation D(10) values for L. monocytogenes and S. typhimurium were 0.58 and 0.55kGy, respectively. During the 20 days of refrigerated storage, L. monocytogenes in both nonirradiated and irradiated samples grew gradually, but the number of S. typhimurium decreased. The added rosemary-tocopherol, however, showed little bacteriocidal effects to L. monocytogenes and S. typhimurium.     

Failure analysis of R-regions of CFRP hat-shaped structure under pull-off load

Journal of Mechanical Science and Technology - As a kind of typical structure, the hat-shaped structure (HSS) is widely used in carbon fiber reinforced plastics (CFRP) aircraft parts. In this work,...     

Design and implementation of multicasting for multi-channel multi-interface wireless mesh networks

Multicasting is a useful communication method in wireless mesh networks (WMNs). Many applications in WMNs require efficient and reliable multicast communications, i.e., high delivery ratio with low overhead among a group of recipients. In spite of its significance, little work has been done on providing such multicast service in multi-channel WMNs. Traditional multicast protocols for wireless and multi-hop networks tend to assume that all nodes, each of which is equipped with a single interface, collaborate on the same channel. This single-channel assumption is not always true, as WMNs often provide nodes with multiple interfaces to enhance performance. In multi-channel and multi-interface (MCMI) WMNs, the same multicast data must be sent multiple times by a sender node if its neighboring nodes operate on different channels. In this paper, we try to tackle the challenging issue of how to design a multicast protocol more suitable for MCMI WMNs. Our multicast protocol builds multicast paths while inviting multicast members, and tries to allocate the same channel to neighboring members in a bottom-up manner. By unifying fixed channels of one-hop multicast neighbors, the proposed algorithm can improve the performance such as reducing multicast data transmission overhead and delay, while managing a successful delivery ratio. In order to prove such expectation on the performance, we have implemented and evaluated the proposed solution on the real testbed having the maximum 24 nodes, each of which is equipped with two IEEE 802.11a Atheros WLAN cards.     

Pixel‐Structured Scintillator with Polymeric Microstructures for X‐Ray Image Sensors

We introduce a pixel‐structured scintillator realized on a flexible polymeric substrate and demonstrate its feasibility as an X‐ray converter when it is coupled to photosensitive elements. The sample was prepared by filling Gd₂O₂S:Tb scintillation material into a square‐pore‐shape cavity array fabricated with polyethylene. For comparison, a sample with the conventional continuous geometry was also prepared. Although the pixelated geometry showed X‐ray sensitivity of about 58% compared with the conventional geometry, the resolving power was improved by about 70% above a spatial frequency of 3 mm^?1. The spatial frequency at 10% of the modulation‐transfer function was about 6 mm^?1.