Nanoindentation measurement of core–skin interphase viscoelastic properties in a sandwich glass composite

Mechanics of Time-Dependent Materials - Debonding at the core–skin interphase region is one of the primary failure modes in core sandwich composites under shear loads. As a result, the...     

热挤压变形力计算的研究

本文考虑到变形区内切应力非线性分布的特点,采用球坐标系下的平衡微分方程和塑性条件联立求解,得出圆棒热挤压时变形区入口球面上的应力分布方程,然后应用功平衡法导出了圆棒热挤压力的计算公式。     

Fabrication of Cu(In,Ga)Se2 thin films by ion beam sputtering deposition from a quaternary target at different substrate temperatures

Cu(In, Ga)Se₂ (CIGS) thin films were fabricated by ion beam sputtering deposition from a single quaternary target at different substrate temperatures (T _sub). The thin films were characterized with X-ray diffractometry, scanning electron microscopy, energy-dispersive X-ray spectroscopy and four-point probe technique to study the microstructures, surface morphology, composition and electrical properties, respectively. The results show that the films grown above 400?°C are of chalcopyrite structure. Cu(In_0.7Ga_0.3)Se₂ thin film was obtained when T _sub is 550?°C. The Cu and Se atomic percentage when T _sub is above 500?°C is higher than when T _sub is below 500?°C. With the increase in T _sub, the surfaces morphology of the films is denser and the resistivity of the films decreases.     

淀粉接枝共聚物制备的影响因素的研究进展

综述了制备淀粉接枝共聚物过程中,淀粉种类、其是否糊化,引发剂及单体的选择及其用量,以及反应温度和反应时间等因素对制备淀粉接枝共聚物的影响,指出应根据所需产物性能要求,综合考虑各方面因素的影响.并提出开发新的廉价而高效的引发剂成为市场所需,淀粉制备工艺的简约处理以及性能优良的淀粉衍生物产品的开发值得人们进一步的深入探讨.     

Preparation and thermophysical properties of nano-sized Ln2Zr2O7 (Ln?=?La, Nd, Sm, and Gd) ceramics with pyrochlore structure

Rare earth zirconates (Ln₂Zr₂O₇, Ln = La, Nd, Sm, and Gd) with pyrochlore structure were prepared by hydrothermal method with polyethylene glycol as surfactant. X-ray diffraction, thermogravimetric analysis/differential scanning calorimetry, Fourier transform infrared spectroscopy, Raman spectroscopy, and field emission scanning electron microscopy were utilized to characterize the phase structure, thermal decomposition, and morphology of the products. Qualitative analysis indicates that the as-prepared zirconates are pyrochlore-type structures. The specific surface area, lattice parameter, and average crystallite size of the as-prepared products are closely related to the ionic radius. The activation energy of crystal growth shows an increasing trend with the decrease in ionic radii. The sintering behavior of compacted body was also investigated, revealing that the sintering-resistance properties of Ln₂Zr₂O₇ are descending as the order of La₂Zr₂O₇, Nd₂Zr₂O₇, Sm₂Zr₂O₇, and Gd₂Zr₂O₇.     

汽车挡风玻璃刮雨器的控制

本拟设计了一种用于汽车挡风玻璃上的自动雨点检测器及刮雨器控制装置,其原理利用了挡风玻璃中的光波导作用,并经模拟实验证实此方案可行。     

Direct sampling of chemical weapons in water by photoionization mass spectrometry

The vulnerability of water supplies to toxic contamination calls for fast and effective means for screening water samples for multiple threats. We describe the use of photoionization (PI) mass spectrometry (MS) for high-speed, high-throughput screening and molecular identification of chemical weapons (CW) threats and other hazardous compounds. The screening technology can detect a wide range of compounds at subacute concentrations with no sample preparation and a sampling cycle time of approximately 45 s. The technology was tested with CW agents VX, GA, GB, GD, GF, HD, HN1, and HN3, in addition to riot agents and precursors. All are sensitively detected and give simple PI mass spectra dominated by the parent ion. The target application of the PI MS method is as a routine, real-time early warning system for CW agents and other hazardous compounds in air and in water. In this work, we also present comprehensive measurements for water analysis and report on the system detection limits, linearity, quantitation accuracy, and false positive (FP) and false negative rates for concentrations at subacute levels. The latter data are presented in the form of receiver operating characteristic curves of the form of detection probability P(D) versus FP probability P(FP). These measurements were made using the CW surrogate compounds, DMMP, DEMP, DEEP, and DIMP. Method detection limits (3sigma) obtained using a capillary injection method yielded 1, 6, 3, and 2 ng/mL, respectively. These results were obtained using 1-microL injections of water samples without any preparation, corresponding to mass detection limits of 1, 6, 3, and 2 pg, respectively. The linear range was about 3-4 decades and the dynamic range about 4-5 decades. The relative standard deviations were generally <10% at CW subacute concentrations levels.     

30.4 nm Si/C多层膜反射镜的制备与测量

采用离子束溅射镀膜装置制备了一种新的材料组合Si/C多层膜 ,用于 30 4nm波段的正入射多层膜反射镜。并用软X射线反射率计测得其反射比最大值为 0 14。有效地抑制了 15 0nm处的二级衍射峰。     

Effect of V doping concentration on the electronic structure,optical and photocatalytic properties of nano-sized V-doped anatase TiO2

V-doped TiO₂ with V/Ti ratio of 1–5% has been synthesized by hydrothermal method and then characterized by XRD, TEM, BET specific surface area, XPS and UV–vis. absorption spectra. The photocatalytic activity of the as-synthesized samples was investigated by the degradation of methylene blue in aqueous solution under visible light irradiation. Density functional theory (DFT) based calculations were performed to investigate the mechanism of band gap narrowing, the shift of light absorption edge, the location of V in the TiO₂ lattice and the variation in electronic and optical properties of TiO₂ with the increase of V doping concentration. Irrespective of the V doping concentration, TEM images indicate that all the doped samples were composed of equiaxed spherical anatase TiO₂ particles with good crystallinity and uniform particle size distribution. Both the experimental results from XPS survey and the theoretical calculation argue that the doped V replaces the lattice Ti and form substitutional impurity. The visible light absorption can be optimized by adjusting the V doping concentration. Among the doped samples with different V doping concentrations, the sample with V/Ti ratio of 2% depicts better visible light photocatalytic activity due to the enhanced visible light absorption and improved separation of electron–hole pairs.