Photoelectric conversion of photosynthetic reaction center in multilayered films fabricated by layer-by-layer assembly

Multilayered protein films which contained ordered layers of photosynthetic reaction center (RC) from Rhodobacter Sphaeroides (RS601) were assembled by means of alternate electrostatic adsorption with positively charged poly(diallyldimethylammonium chloride) (PDDA). The assembly of RC was monitored by spectrometry and photocurrent measurement. Linear film growth was observed up to about 20 cycles of adsorption. For the monolayer film, the photocurrent was about 8.5 nA cm⁻². For the multilayered film, the total photocurrent was about 77 nA cm⁻² for the 24-layer RC film, while the average photocurrent increment per adsorption cycle was about 3.2 nA cm⁻². The overall light-to-electricity conversion efficiency for a 24-layer film was about eight times higher than that for the monolayer one. The effects of electrode potential and pH on the photocurrent were also measured to illustrate the light-to-electric converting mechanism.     

Selective hydrogenolysis of glycerol to propylene glycol on Cu–ZnO catalysts

Hydrogenolysis of biomass-derived glycerol is an alternative route to sustainable production of propylene glycol. Cu–ZnO catalysts were prepared by coprecipitation with a range of Cu/Zn atomic ratio (0.6–2.0) and examined in glycerol hydrogenolysis to propylene glycol at 453–513 K and 4.2 MPa H₂. These catalysts possess acid and hydrogenation sites required for bifunctional glycerol reaction pathways, most likely involving glycerol dehydration to acetol and glycidol intermediates on acidic ZnO surfaces, and their subsequent hydrogenation on Cu surfaces. Glycerol hydrogenolysis conversions and selectivities depend on Cu and ZnO particle sizes. Smaller ZnO and Cu domains led to higher conversions and propylene glycol selectivities, respectively. A high propylene glycol selectivity (83.6%), with a 94.3% combined selectivity to propylene glycol and ethylene glycol (also a valuable product) was achieved at 22.5% glycerol conversion at 473 K on Cu–ZnO (Cu/Zn = 1.0) with relatively small Cu particles. Reaction temperature effects showed that optimal temperatures (e.g. 493 K) are required for high propylene glycol selectivities, probably as a result of optimized adsorption and transformation of the reaction intermediates on the catalyst surfaces. These preliminary results provide guidance for the synthesis of more efficient Cu–ZnO catalysts and for the optimization of reaction parameters for selective glycerol hydrogenolysis to produce propylene glycol.     

Inspection of Remanent Polarization in the Ferroelectric Ceramic PZT 95/5 Through Pyroelectric Effect

Shock-induced depoling of the ferroelectric (FE) ceramic PZT 95/5 is utilized in a number of pulsed power devices. Nondestructive testing of remanent polarization of PZT 95/5 is developed by pyroelectric effect in this paper. Approximately linear relation between the change of polarization during low- to high-temperature rhombohedral FE phase and the remanent polarization was found through pyroelectricity of a single piece of PZT 95/5 ceramics. The change of polarization of a prototype for shock-driven pulsed power during the FE_HT↔FE_LT phase transformation was also investigated through directly measuring the pyroelectric current. Results indicate that pyroelectric effect caused by the reversible FE_HT–FE_LT phase transition could be used as a non-destructive inspection for the remanent polarization of a prototype about shock-driven pulsed power supply.     

双螺杆转速差决定的螺杆间隙之探讨

根据相对运动原理计算了同向旋转双螺杆因螺杆转速差决定的两螺杆之间的径向和轴向间隙,可为工程上设计这些间隙时提供参考。     

Effect of incipient removal of hydrogen through palladium membrane on the conversion of methane steam reforming: Experimental and modeling

This paper presents a mathematical model based on the reaction rate expressions to describe the displacement of methane conversion in the steam reforming. The effect of several parameters including weight hourly space velocity (WHSV), load-to-surface ratio, reaction pressure, hydrogen partial pressure in permeate side and reaction temperature were investigated. Simulation and experimental results showed that a conversion higher than 80% could be achieved in a palladium membrane reactor at reaction temperature of 500 °C relative to 850 °C in a conventional fixed bed reactor (FBR). Besides, the yield of CO (<2%) in membrane reactor was much lower than that (>50%) in the FBR, which indicated the significant depression of CO production in use of membrane reactor.     

准能公司发电厂2×100MW机组循环水泵节能改造

循环水泵是热力发电厂中主要的辅机之一 ,在凝汽式电厂中循环水泵的耗电量约占厂用电量的 1 0 %～ 2 5 % ,其作用是将大量的冷却水输送到凝汽器中去冷却汽轮机的乏汽 ,使之凝结成水 ,并保持凝汽器真空。循环水泵的工作特点是流量大而扬程一般较低。为了降低准能公司发电厂 2× 1 0 0MW机组厂用电率 ,我厂对 1号机 1号循环水泵和 2号机 2号循环水泵电机级数与叶片形状先后进行了改造 ,取得了名显的节电效果。     

Effects of the reinforcement and toughening of acrylate resin/CaCO3 nanoparticles on rigid poly(vinyl chloride)

Novel composite particles based on nanoscale calcium carbonate (nano‐CaCO₃) as the core and polyacrylates as the shell were first synthesized by in situ encapsulating emulsion polymerization in the presence of the fresh slush pulp of calcium carbonate (CaCO₃) nanoparticles. Subsequently, these modified nanoparticles were compounded with rigid poly(vinyl chloride) (RPVC) to prepare RPVC/CaCO₃ nanocomposites. At the same time, the effects of the reinforcement and toughening of these modified nanoparticles on RPVC were investigated, and the synergistic effect of modified nanoparticles with chlorinated polyethylene (CPE) was also studied. The results showed that in the presence of nano‐CaCO₃ particles, the in situ emulsion polymerization of acrylates was carried out smoothly, and polyacrylates successfully encapsulated on the surface of nano‐CaCO₃ to prepare the modified nanoparticles, breaking down nano‐CaCO₃ particle agglomerates, improving their dispersion in the matrix, and also increasing the particle–matrix interfacial adhesion. Thus, the effects of the reinforcement and toughening of these modified nanoparticles on RPVC were very significant, and the cooperative effect of the nanoparticles with CPE occurred in the united modification system. Scanning electron microscopy analyses indicated that large‐fiber drawing and network morphologies coexisted in the system of joint modification of nanoparticles with CPE. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 103: 3940–3949, 2007     

论局域网的安全防范

网络技术、通信技术和计算机技术的突飞猛进使得很多的企业单位、机关部门和学校搭建了属于自己的局域网.信息安全问题是局域网实际应用过程中最受关注的问题.本文阐述了局域网安全的内涵和意义,分析了目前局域网安全防范中存在的问题,并根据笔者的实际经验给出了有效增强局域网安全防范的相关建议.     

高职院校软件教学体系研究

本文在概述软件教学体系及其理论的基础上,结合软件教学的特点,阐述了软件教学体系的结构、应用环境以及在教学中将遇到的问题和解决对策,并描述了＂软件教学资源网系统＂建立的目的、设计方案、功能及开发环境。     

计算机网络的安全问题及预防措施浅探简

导致的计算机硬件、软件数据而遭到的破坏、更改和泄露就是计算机网络安全问题,而其影响因素则比较复杂,因而,这就需要在加强法制管理,提高防范意识的同时,不断提高防范技术,而且,不仅要被动防御,更要强化主动防护、动态地对网络安全进行防护。