Interface characterization of Al/Cu 2-ply composites under various loading conditions

The effects of reduction ratio during roll bonding on the microstructural evolution at interface and subsequent mechanical properties of roll-bonded Al/Cu 2-ply sheets were investigated. The interface microstructures for several Al/Cu 2-ply sheets fabricated under different reduction ratios between 30% and 65% were verified by transmission electron microscopy (TEM). Taking the difference of interface microstructure into consideration, 3-point bending and peel tests were performed for obtaining flexural and bonding strengths for Al/Cu 2-ply sheets. The effect of the quantified areas of metallurgical bonding at interfaces on the bonding strength was also discussed. The results show that both the bonding and flexural strengths for Al/Cu 2-ply sheets are reduced by decreasing the reduction ratio during the roll bonding process, which is strongly correlated with the interface microstructure. This was especially verified by observing the interface delamination from the 3-point bent samples.     

液压挤压对复合铸造Al3003/Al4004包覆材料显微组织的影响(英文)

研究液压对混合复合铸造Al 3003/Al 4004包覆材料微观组织变化的影响。复合铸造Al 3003/Al 4004包覆材料试样为圆形,由Al 3003(外部)和Al 4004(内部)材料组成。采用液压设备,在温度423 K、挤压比5的条件下制造试样。在挤压之前,Al 4004材料的直径为80 mm,Al 3003材料的厚度为35 mm,在挤压后,2种材料的直径和厚度分别为30 mm和5 mm。研究了2个试样的微观组织和硬度。在挤压之前,复合铸造Al 3003/Al 4004包覆材料横截面的硬度以抛物线的形式向中心增大。然而,在挤压后,Al 4004材料的硬度几乎没有变化。在挤压之前,Al 3003和Al 4004材料的界面存在大量直径超过1 mm的大空洞,这些大空洞随着液压过程的进行而消失。     

电镀锌钢材表面物理气相沉积Zn-Mg合金镀层的电化学性能(英文)

锌合金镀层由于具有较强的耐腐蚀性能而得到广泛的关注,特别是Zn-Mg合金镀层,其耐腐蚀性能能得到显著提高。采用气相沉积方法制备不同镁含量的Zn-Mg合金镀层,研究Zn-Mg合金镀层中镁含量对其耐腐蚀性能的影响。在3%NaCl溶液中进行浸泡试验、动电位测试和电偶腐蚀试验,研究不同Mg含量镀层的耐腐蚀性能。结果表明,Zn-Mg合金镀层的耐腐蚀性能与Mg含量显著相关,镀层的腐蚀电位随着Mg含量的增加而降低,但是腐蚀电流密度却升高,直至15%Mg含量;在Zn-Mg合金镀层中存在钝化区。     

真空热压铝和铜的固态连接(英文)

在温度623~923K下采用真空热压扩散连接铝和铜,具体工艺为在预置温度下,变形率为0.2mm/min时热压缩10min,再在炉冷过程中,以0.2mm/min成型10min。通过界面分析可以看出,合适的扩散连接温度为823K,在扩散过程中产生了3种主要的金属间化合物层,分别为Al2Cu、AlCu+Al3Cu4和Al4Cu9。3种化合物层的局部硬度分别为(4.97±0.05)、(6.33±0.00)、(6.06±0.18)GPa。     

NEURAL NETWORK MODELING FOR ESTIMATION OF SCOUR DEPTH AROUND BRIDGE PIERS

It is essential to predict the scour depth around bridge piers for hydraulic engineers involved in the economical design of bridge pier foundation. Conventional investigations have long been of the opinion that empirical scour prediction equations based on laboratory data over predict scour depths. In this article, the Back-Propagation Neural Network (BPN) was applied to predict the scour depth in order to overcome the problem of exclusive and the nonlinear relationships. The observations obtained from thirteen states in USA was verified by the present model. From the comparison with conventional experimental methods, it can be found that the scour depth around bridge piers can be efficiently predicted using the BPN.     

Roughness coefficient and its uncertainty in gravel-bed river

Manning's roughness coefficient was estimated for a gravel-bed river reach using field measurements of water level and discharge,and the applicability of various methods used for estimation of the roughness coefficient was evaluated.Results show that the roughness coefficient tends to decrease with increasing discharge and water depth,and over a certain range it appears to remain constant.Comparison of roughness coefficients calculated by field measurement data with those estimated by other methods shows that,although the field-measured values provide approximate roughness coefficients for relatively large discharge,there seems to be rather high uncertainty due to the difference in resultant values.For this reason,uncertainty related to the roughness coefficient was analyzed in terms of change in computed variables.On average,a 20%increase of the roughness coefficient causes a 7% increase in the water depth and an 8% decrease in velocity,but there may be about a 15% increase in the water depth and an equivalent decrease in velocity for certain cross-sections in the study reach.Finally,the validity of estimated roughness coefficient based on field measurements was examined.A 10% error in discharge measurement may lead to more than 10% uncertainty in roughness coefficient estimation,but corresponding uncertainty in computed water depth and velocity is reduced to approximately 5%.Conversely,the necessity for roughness coefficient estimation by field measurement is confirmed.     

PREDICTING RELATIVE HUMIDITY IN MODIFIED ATMOSPHERE PACKAGING SYSTEM CONTAINING BLUEBERRY AND MOISTURE ABSORBENT

A modified respiration-transpiration model was developed to predict the relative humidity in modified atmosphere packaging system containing fresh produce and moisture absorbent. The model is based on heat and mass balances accounting for the respiratory and transpiratory behavior of the fresh produce, the transport phenomena across the package, and the moisture sorption behavior of the absorbent. A set of experiments was conducted to obtain the parameter values that were necessary for generating model predictions. Another set of experiments was conducted using model packages containing blueberries and moisture absorbents Sanwet and xylitol to obtain experimental data under various conditions, including different weights of blueberries, types of absorbers, weights of absorbers, and temperatures. In general, the model predictions agree well with the experimental data, except the model sometimes exaggerates the effects of the absorbent in the initial period (<10 h).     

EXPERIMENTAL ESTIMATION OF A SCALING EXPONENT FOR TIP VORTEX CAVITATION VIA ITS INCEPTION TEST IN FULL- ANDMODEL-SHIP

Tip vortex cavitation noise of marine propeller became primary concerns to reduce hazardous environmental impacts from commercial ship or to keep the underwater surveillance of naval ships. The investigations of the tip vortex and its induced noise are normally conducted through the model test in a water cavitation tunnel. However the Reynolds number of model-test is much smaller than that of the full-scale, which subsequently results in the difference of tip vortex cavitation inception. Hence, the scaling law between model-and full-scales needs to be identified prior to the prediction and assessment of propeller noise in full scale. From previous researches, it is generally known that the incipient caivtation number of tip vortex can be represented as a power of the Reynolds number. However, the power exponent for scaling, which is the main focus of this research, has not been clearly studied yet. This paper deals with the estimation of scaling exponent based on tip vortex cavitation inception test in both full-and model-scale ships. Acoustical measurements as well as several kind of signal processing technique for an inception criterion suggest the scaling exponent as 0.30. The scaling value proposed in this study shows slight difference to the one of most recent research. Besides, extrapolation of model-ship noise measurement using the proposed one predicts the full-scale noise measurement with an acceptable discrepancy.     

Retinyl Palmitate Isomers in Skim Milk During Light Storage as Affected by Ascorbic Acid

Effects of ascorbic acid addition on the contents of retinyl palmitate isomers in skim milk treated with or without 3 mg/mL added riboflavin were studied during storage for 30 h under fluorescent light. Light illumination induced the reduction of all-trans-retinyl palmitate and 13-cis isomer, but promoted the production of 9-cis isomer in the skim milk. Riboflavin increased the reduction of all-trans-retinyl palmitate, but decreased the formation of 9-cis isomer in lightstored skim milk. The addition of ascorbic acid greatly inhibited the light-induced reduction of all-trans-retinyl palmitate and 13-cis isomer in skim milks. Ascorbic acid also greatly increased the formation of 9-cis-retinyl palmitate in skim milks during light storage.     

Selective Solubilization of α- Lactalbumin and β-Lactoglobulin into Reversed Micelles from Their Mixtures

Phase transfer experiments were performed, involving contact between an aqueous 1:1 solution of α-lactalbumin and β-lactoglobulin and an AOT-in-isooctane reversed micellar phase. The resulting extraction and separation of the two proteins were analyzed as functions of pH, ionic strength and total protein concentration using SDS-PAGE, and compared with extractions from pure solutions. At low protein concentrations, the extent of reversed micellar solubilization of the two pure proteins predicted well the extraction from mixtures. However, at higher protein concentrations β-lactoglobulin appeared to be excluded from the micellar droplets. Because of the significantly different partitioning behavior of the two proteins, reversed micellar extraction from an initially equal weight mixture led to an effective separation of the proteins.