Analysis of the unloading performance considering dimple–flexure behavior in HDD

Currently, almost all hard disk drives (HDDs) have adopted a loading/unloading mechanism that increases their recording capacity and improves their reliability. However, these mechanisms still create a few scratches or defects in the loading/unloading zone. Slipping at the dimple–flexure interface was recently reported as one of the causes. In this research, we first analyzed the relative behavior of dimple–flexure based on fretting wear marks. We determined that the dimple–flexure behavior included both slipping and rotating motion simultaneously. We then verified the distinct slipping and rolling phenomenon at the moment of ramp contact using finite-element method (FEM) analysis. An experimental setup was constructed, and an unloading experiment was carried out to obtain the ramp contact characteristics corresponding to various unloading velocities. Based on the verified FEM, the characteristics of dimple–flexure relative behavior were investigated for various suspension design parameters, ramp contact characteristics, and unloading velocities. A higher ramp contact force and shorter contact duration resulted in larger slip displacements and roll angles between the dimple and the flexure. Finally, we analyzed the unloading performance of an HDD for various design parameters using quasi-static approximation while considering the relative behavior between the dimple and flexure. The quasi-static analysis indicated a change of approximately 15?% in the flying height at an unloading velocity of 40?in. per second when the relative motion between the dimple and flexure was considered during the unloading process. Even, slider–disk contact occurred at an unloading velocity of 50 ISP.     

锅炉过热器/再热器管道热流密度的评估方法

通过建立数值模型进行编程计算,分析了锅炉过热器/再热器管道在不同的管道几何尺寸、烟气温度、蒸汽流量和温度下,各个界面热流密度的变化情况。通过回归分析得到了热流密度与管道内壁侧氧化层厚度和运行时间的关系表达式,即热流密度的评估关系式。     

从媒体控制探讨媒体工作者的性观念与性道德

从媒体控制考察媒体工作者的性观念与性道德,围绕媒体工作者的双重身份——普通大众与媒体人,对媒体工作者进行实证调查,分析得出媒体工作者的性观念与性道德总体上趋于保守和规范,但仍存在偏离现象。     

On learning and development, Piagetian style: I. A reply to Lefebvre-Pinard.

Examines the equilibration theory of Piaget (learning vs development, stage transitions) to make more explicit the methodological foundations of B. Inhelder et al (1974). In this connection, the "problem-solving" learning method used by these authors is analyzed by means of the new concept of "learning loops." Similarly, the successful equilibration learning method used by M. Lefebvre and A. Pinard (1974) is analyzed and shown to involve executive facilitation and chunking (coordination) of 2 crucial schemes. A process-structural model of conservation acquisition previously developed by the present author, and its empirical tests by R. Case (1975) and by G. M. Parkinson (1975), are used to illustrate and to empirically support the process-structural differences theoretically found between these 2 equilibration methods. (54 ref) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

一类非光滑非凸分式半无限规划的最优性

在一致Fb-凸函数，一致Fb-伪凸和一致Fb-拟凸等广义凸性函数的基础上，研究了一类分式半无限规划问题，得到了涉及这些广义凸性函数的一类非光滑分式半无限规划的一些最优条件。     

Consecutively spin-assembled layered nanoarchitectures of poly(sodium 4-styrene sulfonate) and poly(allylamine hydrochloride)

The recently established spin-coating electrostatic self-assembly (SCESA) technique has been shown to facilitate not only the rapid fabrication of polyelectrolyte multilayer assemblies, but also allow each layer to be easily controlled on a monomolecular scale by minimizing the film thickness across a substrate surface. In this paper, the influence of polyelectrolyte concentration on the amount and thickness of spin-deposited polymer films has been examined for a multilayer system of poly(allyamine hydrochloride) (PAH) and poly(sodium 4-styrenesulfonate) (PSS), when the washing steps employed for removing weakly bound polyelectrolytes on a resultant film on a substrate are excluded from the standard fabrication procedure of the SCESA method. The thickness of the spin-deposited PAH/PSS bilayer increased linearly for the PSS concentrations in the range from 1 to 10 mM with PAH constant at 1 mM, which demonstrates the uniform deposition of each layer material onto the thin film. The thickness of PAH/PSS bilayers increased from 1.43 ± 0.06 to 3.37 ± 0.08 nm as the PSS concentration increased from 1 to 10 mM, while the PAH concentration was kept constant at 1 mM. The multilayer films were found to be stable in a good solvent (H₂O) for at least 30 h, without any noticeable loss of the adsorbed layer component of the polyelectrolyte. This improvement to the SCESA method (exclusion of washing steps) provides a convenient way to create multilayer heterostructures with the thickness of each layer being easily adjusted.     

Preparation of a sensor substrate using functionalized mesoporous silica on a gold film for surface plasmon resonance (SPR) spectroscopy

The use of surface plasmon resonance (SPR) spectroscopy has been applied to a wide variety of fields such as biosensors and surface analysis instruments. In general, a SPR substrate is prepared using self-assembled monolayer (SAM) method of organic molecules as receptor for the target on a layer of gold or silver. However, mesoporous inorganic materials such as SBA-15 have benefits as sensor substrate for SPR. Mesoporous silica has a large surface area which receptor molecule can be attached and has a rigid body which has an excellent stability in the extreme condition compared to organic sensing layer. We prepared an organic modified mesoporous silica and successfully immobilized it on a gold surface, in an attempt to use as a substrate for SPR spectroscopy. For the comparison of sensitivity of prepared substrate, Pt²⁺ detection was selected as a model system. Substrate prepared in this study exhibited the capability of selective sensing for Pt²⁺ ions.     

Preparation of SnO2 whiskers via the decomposition of tin oxalate

A new method for preparing SnO₂ whiskers by the decomposition of SnC₂O₄ is suggested. A Whisker-like morphology of a SnC₂O₄ precipitate was attained via the gradual addition of an oxalic acid solution to a hot SnCl₂ aqueous solution (T > 50^∘C). In comparison, when the solution temperature was either lower than 50^∘C or when ethanol was used as the solvent, the SnC₂O₄ precipitate showed an angular and relatively isotropic morphology. The morphology of the SnC₂O₄ precipitate remained even after its thermal decomposition into SnO₂ at 400^∘C indicating that SnC₂O₄ precipitation is a key step in preparing the whiskers. The formation mechanism of SnO₂ whiskers was explained by the supersaturation during the precipitation of SnC₂O₄.     

民营二级学院数学教学探微

对现阶段我国民营二级学院数学课程的设置进行了介绍,讨论了民营二级学院数学课程的新定位、内涵以及应该予以重视的几个问题.     

一次同余方程组的一种矩阵解法

同余方程组是数论中一个极为有用的课题。文中考虑的是具有一个未知数而具有不同的模的一次同余方程组。一般可以用中国剩余定理或者递推算法等方法给出一次同余方程组的解法。利用矩阵的初等变换和矩阵的Sm ith标准形给出了求解一次同余方程组的一种矩阵解法。