Effect of hygiene measures, water sanitation and oral rehydration therapy on diarrhea in children less than five years old in the south of Ivory Coast

BACKGROUND: Gastric sucrose permeability is a noninvasive marker that reliably increases in association with gastrointestinal injury due to use of nonsteroidal antiinflammatory drugs. Despite the effect of Helicobacter pylori infection on the gastric mucosa, in a previous study we were unable to demonstrate that H. pylori infection was associated with abnormal gastric sucrose permeability. Our goal in this study was to explore further whether H. pylori infection changed gastric permeability; therefore, we evaluated the effect of treatment of H. pylori infection on gastric permeability to sucrose and the relation of sucrose permeability to density of polymorphonuclear leukocytes. MATERIALS AND METHODS: Five hundred milliliters of a solution containing 100 gm of sucrose was ingested by the subject at bedtime. Overnight urine was collected and assayed for sucrose by high-performance liquid chromatography. Sucrose permeability was assessed both before and approximately 4 weeks after anti-H. pylori therapy. RESULTS: Seventeen asymptomatic H. pylori-infected volunteers participated; 8 were cured. Sucrose permeability was in the range commonly found in normal controls both before and after anti-H. pylori therapy (mean excretion, 76.3 mg; range, 13-171 mg). Gastric sucrose permeability correlated with the density of polymorphonulcear cell infiltration of the mucosa. Cure of the H. pylori infection was associated with a small but significant decrease in sucrose permeability (98.8 +/- 18 mg to 51.7 +/- 9.8 mg (p = .01). Sucrose permeability was greater in those with a high density of mucosal polymorphonuclear cells compared to those with lower scores (119.5 +/- 4 vs 71.4 +/- 13 for those with scores > or = 5 compared to scores < or = 4; p = .023). Failed therapy resulted in an increase in the mucosal density of polymorphonuclear infiltration and sucrose permeability (56.4 +/- 13 mg-99.7 +/- 19 mg pretreatment vs posttreatment, respectively; p = .031). CONCLUSION: H. pylori gastritis causes a small but measurable increase in gastric permeability to sucrose that may reflect epithelial transmigration of neutrophils.     

Magnet Safety Assessment for ITER

The ITER magnet system consists of structurally linked sets of toroidal (TF) and poloidal (PF) field coils, central solenoid (CS), and various support structures. The coils are superconducting, force flow Helium cooled with a Kapton-Glass-Epoxy multilayer insulation system. The stored magnetic energy is about 100GJ in the TF system and 20GJ in the PF-CS. Coils and structure are maintained at 4 K by enclosing them in a vacuum cryostat. The cryostat, comprising an outer envelope to the magnets, forms most of the second radioactivity confinement barrier. The inner primary barrier is formed by the vacuum vessel, its ports and their extensions. To keep the machine size within acceptable bounds, it is essential that the magnets are in close proximity to both of the nuclear confinement barriers. The objective of the magnet design is that, although local damage to one of the barriers may occur in very exceptional circumstances, large scale magnet structural or thermal failure leading to simultaneous breaching of both barriers is not credible. Magnet accidents fall into three categories: thermal (which includes arcing arising from insulation failure and local overheating due to discharge failure in the event of a superconductor quench), structural (which includes component mechanical failure arising from material inadequacies, design errors and exceptional force patterns arising from coil shorts or control failures), and fluid (Helium release due to cooling line failure). After a preliminary survey to select initial faults conceivable within the present design, these faults are systematically analyzed to provide an assessment of the damage potential. The results of this damage assessment together with an assessment of the reliability of the monitoring and protective systems, shows that the magnets can operate with the required safety condition.     

Positive temperature dependence of the electron impact ionizationcoefficient in In0.53Ga0.47As/InP HBTs

Impact ionization is a major limiting factor to the maximum operating voltage of InGaAs-based, high-speed transistors. In this work, data on the positive temperature dependence of the electron impact ionization coefficient α_n in In_0.53Ga_0.47As at medium-low electric fields are reported for the first time. The increase of α_n with temperature is opposite to the behavior normally observed in most semiconductors. This anomalous behavior implies the onset of a positive feedback between power dissipation and avalanche generation which may adversely affect the power handling capability of In_0.53Ga _0.47As-based devices, and which should be taken into account in device thermal modeling. In the experimental procedure, based on the measurement of the multiplication factor M-1 in npn In_0.53Ga _0.47As/InP Heterojunction Bipolar Transistors (HBT), particular care has been taken in order to rule out possible spurious, temperature-dependent contributions to the measured multiplication current     

C-t analysis of MOS capacitors under constant current stress

The effect of high oxide field stress is studied using capacitance-time (C-t) measurements of MOS capacitors. The stress results in parallel shifts of the C-t curve along the time axis. The flatband voltage shift ΔV_FB obtained from the initial deep depletion capacitance C(t=0⁺) follows the same trend as that from the high-frequency C-V characteristics. However, the discrepancy between the two flatband voltages becomes larger as the stress increases due to the effect of interface charges on C-t characteristics. The flatband voltage difference is converted to interface trap density, showing a steady increase of interface trap density with stress, similar to that from low-frequency C-V measurements     

A fully soft-switched extended-period quasi-resonantpower-factor-correction circuit

This paper presents the design criteria, procedure, and implementation of a soft-switched power-factor-correction (PFC) circuit based on the extended-period quasi-resonant (EPQR) principles. All power electronic devices including switches and diodes in the circuit are fully soft switched. The design method is demonstrated in a prototype circuit. The operating principles are confirmed with computer simulation and experimental results. A comparison of the EP-QR operation and zero-voltage-transition (ZVT) pulse-width modulation (PWM) method     

Densification involved in the UV-based photosensitivity of silicaglasses and optical fibers

A comprehensive survey of photosensitivity in silica glasses and optical fiber is reviewed. Recent work on understanding the mechanisms contributing to germanium or aluminum doped fiber photosensitivity is discussed within the framework of photoelastic densification models     

A new lateral MOS-gated thyristor with controlling base-current

A new lateral MOS-gated thyristor, called the Base-Current-Controlled Thyristor, is described. This device is designed so that most holes at the on-stage reach the P base through the floating P⁺ region adjacent to the P base and the on-state MOSFET. At the turn-off stage, the interruption of the hole current to the P base due to switching off the above MOSFET occurs simultaneously with the conventional turn-off operation. The concept of this device is verified experimentally by using the fabricated lateral device with the external MOSFET. This device exhibits a better trade-off relation between the on-state voltage and the turn-off time compared uith the conventional MOS-gated thyristor     

Series equivalence/operation of current-controlled boost-typesingle-phase voltage source converters for bidirectional power flow

Single-phase voltage source power converters (VSCs) under consideration are AC-DC current-controlled boost-type power converters with bidirectional power-handling capability. Equivalence between two series-connected two-level power converters and a single three-level power converter is considered here. Further considered is the series operation of three-level power converters. Simulation results and experimental verification for both are provided. Economical configurations of three-level power converters leading to multilevel waveforms are presented thereafter     

A wafer level monitoring method for plasma-charging damage usingantenna PMOSFET test structure

A novel monitoring method for plasma-charging damage is proposed. This method performs a quick and accurate evaluation using antenna PMOSFET. It was found that not only hot-carrier (HC) lifetime but transistor parameters such as initial gate current and substrate current were changed according to the degree of plasma-charging damage. However, the present work suggests that monitoring the shift of drain current after a few seconds of HC stress is a more accurate method to indicate plasma-charging damage. The monitoring method using the present test structure is demonstrated to be useful for realizing highly reliable devices