A multilevel PWM strategy suitable for high‐voltage motor direct drive systems with consideration of the adverse effect of dead time

Recently, high‐voltage motor direct drive systems have been put to practical use, and various multilevel PWM strategies have also been proposed. This paper describes a multilevel PWM strategy [our group calls it the Carrier Phase Selection Method (CPS)] that has the lowest line voltage harmonic distortion in order to prevent the degradation of high‐voltage motor winding insulations. This method takes the adverse effect of dead time into consideration, and it controls the shift direction of a carrier phase. Therefore, a favorable output waveform without instantaneous voltage surges is achieved even if the line voltage level changes. Moreover, the switching transitions across all switching devices are well‐balanced, so the utilization of inverter unit cells is equalized. This is an important factor when designing the entire system. Based on simulation and experimental results, it is shown that this CPS method is particularly effective in high‐voltage motor direct drive systems. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 165(2): 77–88, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20474     

Sinterability of various high-purity magnesium oxide powders

The sinterability of high-purity MgO powders with different production histories was investigated to make clear the relationship between the powder characterization, the densification processes, and the changes in microstructure both with increasing temperature at a rate of 10° C min^–1 and at a fixed temperature of 1450° C for 5 h. The densification behaviour and the changes in microstructure of these compressed bodies were affected chiefly by their original surface activity and degree of agglomeration, depending on the production histories: (i) the ultra-fine and well-dispersed powder prepared by the vapour-phase oxidation process showed that densification proceeded with an appreciable grain growth with few closed pores remaining; (ii) powder derived from the sea-water magnesia process showed that the densification behaviour was affected by the species of magnesium salt, i.e. basic magnesium carbonate or magnesium hydroxide, used as a precursor; however, whichever magnesium salt was used, its sintered compact showed similar closed porosities and grain-size distributions; (iii) powder derived from the spark-discharge process contained skeletons of the original Mg(OH)₂ particles; however, the densification proceeded gradually with slow grain growth, reflecting the fact that the powder has a moderate surface area (36 m² g^–1). The sintered compact from (iii) had a small closed porosity and the smallest grain-size distribution among the compacts used in this investigation.     

Room temperature continuous wave operation of GaInP/AlInP visible-light laser with GaInP/AlInP superlattice confinement layer grown by gas source molecular beam epitaxy

A remarkable threshold current density reduction (from 3.5 kA/cm/sup 2/ to 1.6 kA/cm/sup 2/) of GaInP/AlInP visible light lasers grown by gas source molecular beam epitaxy (GS-MBE) was obtained by introducing 50 pairs of GaInP(7.1 AA)/AlInP(7.1 AA) short period superlattice confinement (SLC) layers. As a result, the room temperature continuous wave (CW) operation was obtained at 669 nm with a minimum threshold current of 50 mA and maximum light output of 10.5 mW.<>     

Instability of the Solid-Liquid Interface of 4He during a Large Transformation

We report an instability of ⁴He crystal surface during a large modification of its shape observed by schlieren photography. ⁴He crystal was nucleated on an ultrasound transducer which was placed in the upper part of the sample cell facing the bottom. The crystal was grown on the transducer and the lowest part of it eventually touched the bottom of the cell. Almost immediately, the crystal started to change shape very quickly to adjust itself to the new boundary condition. During this large deformation, the hexagonal shape of the crystal surrounded by facets became unstable and the surface became corrugated. The corrugation pattern during the deformation was observed by a high-speed camera. The results were compared with Kelvin-Helmholtz type instability which Uwaha and Nozières predicted.      

Differential Effects of Fkbp4 and Fkbp5 on Regulation of the Proopiomelanocortin Gene in Murine AtT-20 Corticotroph Cells

The hypothalamic-pituitary-adrenal axis is stimulated in response to stress. When activated, it is suppressed by the negative feedback effect of glucocorticoids. Glucocorticoids directly inhibit proopiomelanocortin (Pomc) gene expression in the pituitary. Glucocorticoid signaling is mediated via glucocorticoid receptors, 11β-hydroxysteroid dehydrogenases, and the FK506-binding immunophilins, Fkbp4 and Fkbp5. Fkbp4 and Fkbp5 differentially regulate dynein interaction and nuclear translocation of the glucocorticoid receptor, resulting in modulation of the glucocorticoid action. Here, we explored the regulation of Fkbp4 and Fkbp5 genes and their proteins with dexamethasone, a major synthetic glucocorticoid drug, in murine AtT-20 corticotroph cells. To elucidate further roles of Fkbp4 and Fkbp5, we examined their effects on Pomc mRNA levels in corticotroph cells. Dexamethasone decreased Pomc mRNA levels as well as Fkpb4 mRNA levels in mouse corticotroph cells. Dexamethasone tended to decrease Fkbp4 protein levels, while it increased Fkpb5 mRNA and its protein levels. The dexamethasone-induced decreases in Pomc mRNA levels were partially canceled by Fkbp4 knockdown. Alternatively, Pomc mRNA levels were further decreased by Fkbp5 knockdown. Thus, Fkbp4 contributes to the negative feedback of glucocorticoids, and Fkbp5 reduces the efficiency of the glucocorticoid effect on Pomc gene expression in pituitary corticotroph cells.     

Identification of Sex Pheromones of Anadevidia peponis and Macdunnoughia confusa and Field Tests of Their Role in Reproductive Isolation of Closely Related Plusiinae Moths

Anadevidia peponis and Macdunnoughia confusa are defoliators of plants in the family Cucurbitaceae and Compositae, respectively, in Japan. GC-MS analyses of crude pheromone gland extracts treated with or without dimethyl disulfide indicated that females of A. peponis produced six monoene acetates and two monoene alcohols and that M. confusa females produced five monoene acetates. These components include (Z)-7-dodecenyl acetate as a major common constituent and three other acetates as minor common constituents. The minor constituents are quite different in blend composition. In addition, with (Z)-7-dodecenyl acetate, an indispensable component for male attraction is (Z)-5-decenyl acetate for A. peponis and (Z)-9-tetradecenyl acetate is essential for M. confusa. Field tests with synthetic lures showed synergistic effects of some other minor components and male attraction of three additional Plusiinae species, Macdunnoughia purissima, Ctenoplusia albostriata, and Chrysodeixis eriosoma, suggesting their reproductive isolation is based in part on pheromonal communication.     

卧式振动沸腾床旧砂冷却的计算机数字模拟

本文建立了新的卧式振动沸腾床旧砂冷却系统的数学模型,并进行了计算机数字模拟。通过模拟,研究了几个工艺参数对旧砂冷却的影响,并应用能耗指数E和冷却效率η对工厂中使用的旧砂冷却装置进行了评价。     

Adsorption of bovine serum albumin to a polymer brush prepared by atom-transfer radical polymerization in a porous inorganic membrane

Protein adsorption was performed by a polymer brush prepared by atom-transfer radical polymerization (ATRP) to a porous inorganic membrane. The porous inorganic membrane, Shirasu Porous Glass made from silica, was modified with a halogen-containing compound to bind the active species for the polymerization. Glycidyl methacrylate was polymerized from the halogen compound by ATRP for a prescribed time, and subsequently chemically modified. The progression of the chemical modification allowed the membrane to lower the phosphate-buffer flux of the porous membrane due to the attachment of the polymer brush. Bovine serum albumin (BSA), as a model protein, was adsorbed at 12 mg per gram of the membrane in permeating BSA solution through the polymer-brush-attached porous membrane.     

Electrolytic removal of ammonia from brine wastewater: scale‐up,operation and pilot‐scale evaluation

Brine wastewater with a high ammonia content from an iodine processing plant (commonly called kansui in Japan) was treated by electrolysis. The system, which can be considered as an indirect electrolytic treatment process, generates chlorine at the anodes and initiates the formation of mixed oxidants like hypochlorous acid. The oxidants then act as agents for ammonia destruction. Laboratory‐scale experiments showed that high ammonia concentrations (as much as 200 mg dm^?3) could be completely removed within a few minutes, and could be considered a good alternative for efficient ammonia removal from saline wastewaters. From laboratory‐scale experiments in the batch and continuous modes, the charge dose was analyzed and used as the operating and scale‐up factor. The value of the charge dose was not severely affected by changes in operating conditions such as electrode spacing and temperature. The charge dose from batch and continuous runs was found to be in the range of 23 C (mg NH₄‐N removed)^?1 to 29 C (mg NH₄‐N removed)^?1. Using the charge dose obtained from laboratory‐scale continuous electrolysis experiments as the scale‐up factor, a pilot‐scale reactor was designed, and the operating conditions were calculated. In the pilot‐scale reactor tests at different flow rates, the effluent ammonia concentrations were reasonably close to the calculated values predicted from the charge dose equation. Copyright © 2004 Society of Chemical Industry     

Isolated Schwann cells can synthesize the basement membrane in vivo

The purpose of the present study is to examine whether isolated Schwann cells that are not in contact with axons can synthesize the basement membrane in vivo. Schwann cells obtained from sciatic nerve of neonate Wistar rats were prepared in culture, harvested, and mixed with collagen matrix. The silicone tube filled with the collagen matrix containing Schwann cells was closed by a Millipore membrane at both ends to isolate the interior from the outer environment and was implanted in a gap between proximal and distal stumps of transected sciatic nerve of an adult Wistar rat. Ten days later, the implanted silicone tube was prepared for electron microscopic observations. Schwann cells in the tube were elongated longitudinally and lined up parallel to the proximo-distal direction. No regenerating axons penetrated the Millipore membrane into the tube. The basement membrane showing almost normal structure was produced on the surface of the Schwann cells. While the silicone tube was placed side by side to the intact sciatic nerve, Schwann cells in the tube were scattered and no basement membrane was observed. These results suggest that some humoral factors might be released from the transected nerve stumps, which may be responsible for the regular arrangement and the basement membrane formation by Schwann cells without any contact with axons.