Crack-Healing Behavior of Si3N4/SiC Ceramics under Cyclic Stress and Resultant Fatigue Strength at the Healing Temperature

Si₃N₄/SiC composite ceramics were sintered and subjected to three-point bending. A semi-elliptical surface crack of 100 μm surface length was made on each specimen. The crack-healing behavior under cyclic stress of 5 Hz, and resultant cyclic fatigue strengths at healing temperatures of 1100° and 1200°C, were systematically investigated. The main conclusions are as follows: (1) Si₃N₄/SiC composite ceramics have an excellent ability to heal a crack at 1100° and 1200°C. (2) This sample could heal a crack even under cyclic stress at a frequency of 5 Hz. (3) The crack-healed sample exhibited quite high cyclic fatigue strength at each crack-healing temperature, 1100° and 1200°C.     

Pyrolysis of sugarcane bagasse pretreated with sulfuric acid

Pyrolysis is a promising technique for the recovery of useful gas, tar, and solid products from biomass waste. However, the low tar yields obtained from lignocellulosic biomass are a significant drawback. To enhance tar yields, sugarcane bagasse, which is the most abundant agricultural waste in Fiji, was pretreated at ambient temperature and atmospheric pressure using various sulfuric acid (H₂SO₄) concentrations. Here, the ether bonds of cellulose, hemicellulose, and lignin were partially hydrolyzed. The pretreated samples were then pyrolyzed at 500 °C, and it was confirmed that H₂SO₄-pretreatment disrupted the bagasse cell structure, with the thermogravimetry and differential thermogravimetry results confirming that decomposition occurred at lower temperatures after pretreatment. In addition, tar yields were significantly enhanced from 5.6 wt% to 13.4 wt% for the untreated and 3 M H₂SO₄-pretreated samples respectively. The main components detected in this tar product were levoglucosan, andcellulose-and hemicellulose-derived products, whose proportions were increased following pretreatment. Thus, our work demonstrates that dilute acid pretreatment enhances tar production from sugarcane bagasse due to the production of shorter chain components via the partial hydrolysis of ether bonds.     

What is the significance of nitrogen-vacancy centers in the doping into diamond?

In order to advance quantum computer after successful synthesis of a qubit (quantum-bit) using a NV (nitrogen-vacancy) center in diamond crystal, the innovation of a NOT processor is strongly demanded. A candidate of it can be one NV center associated with an additional N atom, which is called a NV–N center. Making use of a classical molecular dynamics simulation of N ion implantation into pure diamond with an energy of 200 eV, we have examined the crystallographic structure of “NV–N” centers. However, at low temperature of 30 K, most implanted N atoms became interstitials, thus it was difficult to identify even NV centers.     

Effects of energetic heavy ion irradiation on the structure and magnetic properties of FeRh thin films

Fe-54at.%Rh thin films were irradiated with 10 MeV iodine ions at room temperature. Before and after the irradiations, the changes in magnetic properties and the lattice structure of the samples were studied by means of a SQUID magnetometer and X-ray diffraction. For the low fluence irradiation, the SQUID measurement at 20 K shows that the anti-ferromagnetic region of the thin film is changed into ferromagnetic region by the irradiation. As the film thickness is much smaller than the ion range, we can discuss the relationship between the density of energy deposited by ions and the change in magnetization quantitatively. For the high fluence irradiation, the magnetization of the film is strongly decreased by the irradiation, which can be explained as due to the change in lattice structure from B2 into A1 structure by the irradiation.     

Cytoskeletal Protein 4.1G Is Essential for the Primary Ciliogenesis and Osteoblast Differentiation in Bone Formation

The primary cilium is a hair-like immotile organelle with specific membrane receptors, including the receptor of Hedgehog signaling, smoothened. The cilium organized in preosteoblasts promotes differentiation of the cells into osteoblasts (osteoblast differentiation) by mediating Hedgehog signaling to achieve bone formation. Notably, 4.1G is a plasma membrane-associated cytoskeletal protein that plays essential roles in various tissues, including the peripheral nervous system, testis, and retina. However, its function in the bone remains unexplored. In this study, we identified 4.1G expression in the bone. We found that, in the 4.1G-knockout mice, calcium deposits and primary cilium formation were suppressed in the trabecular bone, which is preosteoblast-rich region of the newborn tibia, indicating that 4.1G is a prerequisite for osteoblast differentiation by organizing the primary cilia in preosteoblasts. Next, we found that the primary cilium was elongated in the differentiating mouse preosteoblast cell line MC3T3-E1, whereas the knockdown of 4.1G suppressed its elongation. Moreover, 4.1G-knockdown suppressed the induction of the cilia-mediated Hedgehog signaling and subsequent osteoblast differentiation. These results demonstrate a new regulatory mechanism of 4.1G in bone formation that promotes the primary ciliogenesis in the differentiating preosteoblasts and induction of cilia-mediated osteoblast differentiation, resulting in bone formation at the newborn stage.     

A comparison between fission gas release data and FEMAXI-IV code calculations

The FEMAXI-IV code is an extension of the earlier version FEMAXI-III. The primary improvement in the new version is the provision for treating the fuel rod behavior during an operational transient. For this purpose, the time-dependent models are used for heat conduction, fission gas release, and mixing of the released gas with the plenum gas.In FEMAXI-IV, the fission gas release model was thoroughly revised from the previous version. It is based on the fission gas release model presented by White and Tucker. The model takes into account the following mechanisms:

• - diffusion of gas atoms to the grain boundary;

• - sweeping of gas atoms by grain growth;

• - precipitation of gas atoms into intragranular gas bubbles;

• - resolution of gas atoms from intragranular and grain boundary gas bubbles;

• - fission gas release due to bubble interconnection.

The model was incorporated into FEMAXI-IV and code calculations were compared with the fission gas release data obtained in the Inter-Ramp and Over-Ramp experiments.This paper describes the fission gas release model involved and results of calculations.     

Melting attack of solid plates by a high temperature liquid jet — effect of crust formation

When a molten UO₂ jet impinges on a steel structure in a reactor vessel during a severe accident, the erosion rate of the steel by the molten UO₂ jet is expected to be limited considerably by a UO₂ crust layer forming on a molten steel substrate at the jet/steel plate interface. A series of simulation experiments was performed to study the melting behavior of solid plates by high temperature liquid jets and the effects of crust forming at jet/structure interface. In the first series of experiments, salt (NaCl) was selected as the jet material and tin (Sn) as the solid structure. The experiments were conducted with varying the jet diameter (10 30 mm) and jet temperature (900 1100°C). The jets were accelerated to a range of 3 5 m/s at the nozzle outlet by gravitational force and impinged perpendicularly to the solid plate underneath. Furthermore, to check the effects of the thermo-physical properties on the erosion behaviors, preliminary experiments were performed by using a molten Al₂O₃ jet ( 2200°C) impinging on stainless steel plate at room temperature. The erosion rates obtained in the present experiments were far less than the values predicted by an analytical solution that neglects the existence of a crust layer and its thermal effects. With the inclusion of the crust behavior in the model, the experimental results were predicted fairly well. From the present experiments, a Nusselt number of the turbulent heat transfer, which takes into account simultaneous melting and freezing in the impingement region of a molten jet, is correlated by a Reynolds number and a Prandtl number as follows: Nu_m = 0.0033 Re---Pr.In conclusion, the existence of a crust layer plays an important role in the erosion process of a solid plate by the molten fuel jet with high melting point as in a reactor situation.     

Multiresidue method for pesticides and veterinary drugs in bovine milk using GC/MS and LC/MS/MS

A simple, sensitive and selective method with gas chromatography/mass spectrometry (GC/MS) and liquid chromatography/tandem mass spectrometry (LC/MS/MS) has been developed to detect 342 pesticides and veterinary drugs contaminating bovine milk at the maximum residue limits (MRLs) defined in the "positive list system". Sample preparation was performed by extracting the analytes with acetonitrile, followed by salting-out with sodium chloride. For some pesticides, the extract was further cleaned up by n-hexane partitioning and PSA cartridge column chromatography. GC/MS-EI or -NCI was used to determine pesticide residues, while LC/MS/MS-ESI was applicable to the determination of pesticide and veterinary drug residues. The variation of the recoveries of these drugs at MRL was relatively wide; however the relative standard deviations of the recovery of each drug were within 28%, suggesting that the present method is good enough for use as a screening test for contaminants at the MRLs. These results show that this method is useful for multiresidue analysis of numerous pesticides and veterinary drugs in bovine milk.     

Analysis of imazalil and its major metabolite in citrus fruits by GC-FTD

A simplified simultaneous analytical method of imazalil (IZ) and its major metabolite, alpha-(2,4-dichlorophenyl)-1H-imidazole-1-ethanol (IZM), in citrus fruits was developed, and commodities samples were investigated. A homogenate of citrus fruits was extracted with ethyl acetate under basic conditions. The crude extract was partitioned between 0.025 mol/L of sulfuric acid and ethyl acetate. The analytes were extracted from the aqueous fraction under basic conditions with ethyl acetate. The extract solution was purified with an ENVI-Carb cartridge, and then analyzed by GC-FTD and GC/MS. Recoveries of IZ and IZM added to grapefruit at the level of 0.05 microgram/g were 90.0 and 108.7%, and those in the case of lemon were 100.4 and 93.0%, respectively. The detection limits were 0.01 microgram/g in samples. By this method, IZ and IZM were analyzed in 46 citrus fruits on the market and were detected simultaneously in some samples.