Effects of reduction of the number of primordial follicles on follicular development to achieve puberty in female rats

Effects of reduction of the number of primordial follicles on follicular development and concentrations of circulating hormones were examined in immature female rat offspring of dams given busulfan intraperitoneally on day 14 of gestation. The offspring of dams treated with 5 mg busulfan kg(-1) showed vaginal opening at an age comparable with the offspring of dams treated with 2.5 mg busulfan kg(-1) or with corn oil as a control, although they exhibited an irregular oestrous cycle until week 14 after birth. The serum concentrations of immunoreactive inhibin and FSH on day 26 after birth of the offspring treated with 5 mg busulfan kg(-1) were similar to those of age-matched controls. On day 15 after birth, however, the concentration of their immunoreactive inhibin was markedly lower than that of controls, whereas the concentration of their FSH was increased inversely. Comparison of the numbers of ovarian follicles in the controls and groups treated with 2.5 mg busulfan kg(-1) and 5 mg busulfan kg(-1) revealed that prenatal treatment with busulfan reduced the number of follicles in the primordial or primary phase and in the preantral phase on day 7 after birth. Although the increase of the ratio of the number of preantral follicles during days 7-13 after birth tended to vary with the prenatal dose of busulfan, the number of preantral follicles in the group treated with 5 mg busulfan kg(-1) was still smaller than in the controls. The concentration of serum immunoreactive inhibin of the offspring treated with busulfan was reduced on day 7 after birth without alteration of the concentration of gonadotrophin. On day 13 after birth, the concentration of serum immunoreactive inhibin was reduced only in the offspring treated with 5 mg busulfan kg(-1), and the concentration of serum FSH of the offspring was increased inversely as found on day 15 after birth. These results indicate that a reduction in the number of primordial follicles decreases the number of follicles that enter the growing phase, a major source of circulating inhibin in the neonatal and infantile ovary, and that consequently increased circulating FSH may accelerate follicular development to achieve puberty.     

Effect of pre-oxidation on reactivity of chars in steam

The effects of pre-oxidation of char from Taiheiyo coal, a non-caking bituminous coal, in the 400–550 °C temperature range on its gasification reactivity with N₂-H₂O at 0.1 MPa (steam partial pressure of 13.2 kPa) have been investigated. The pre-oxidation of char markedly enhances gasification rates at temperatures between 800 and 900 °C. Reactivity is found to parallel the burn-off level during preoxidation at low temperatures (400–430 °C), whereas at relatively high temperatures (480–550 °C), the burn-off level only affects the reactivity slightly. The amount of CO and CO₂ evolved from the preoxidized char by heat treatment is proportional to the burn-off level at low temperatures (400–430 °C), being closely related to the enhancement of the gasification reactivity in steam.     

Unsteady behavior of leading-edge vortex and diffuser stall in a centrifugal compressor with vaned diffuser

The characteristics of a rotating stall of an impeller and diffuser and the evolution of a vortex generated at the diffuser leading-edge (i.e., the leading-edge vortex (LEV)) in a centrifugal compressor were investigated by experiments and numerical analysis. The results of the experiments revealed that both the impeller and diffuser rotating stalls occurred at 55 and 25 Hz during off-design flow operation. For both, stall cells existed only on the shroud side of the flow passages, which is very close to the source location of the LEV. According to the CFD results, the LEV is made up of multiple vortices. The LEV is a combination of a separated vortex near the leading- edge and a longitudinal vortex generated by the extended tip-leakage flow from the impeller. Therefore, the LEV is generated by the accumulation of vorticity caused by the velocity gradient of the impeller discharge flow. In partial-flow operation, the spanwise extent and the position of the LEV origin are temporarily transmuted. The LEV develops with a drop in the velocity in the diffuser passage and forms a significant blockage within the diffuser passage. Therefore, the LEV may be regarded as being one of the causes of a diffuser stall in a centrifugal compressor.     

Acceleration of the redox kinetics of VO2+/VO2 + and V3+/V2+ couples on carbon paper

The redox kinetics of VO²⁺/VO₂ ⁺ and V³⁺/V²⁺ couples on a carbon paper (CP, HCP030 N, Shanghai Hesen, Ltd., China) electrode were investigated in terms of their standard rate constant (k ₀) and reaction mechanism. The values determined for k ₀ for VO²⁺ ?? VO₂ ⁺ and V³⁺ ?? V²⁺ using the CP electrode are 1.0 × 10^?3 and 1.1 × 10^?3 cm s^?1, respectively. The value of k ₀ increases by one or two order(s) of magnitude compared with values obtained using electrodes composed of pyrolytic graphite and glassy carbon. The acceleration of the redox kinetics of vanadium ions is a result of the large surface area of the CP electrode. An inner-sphere mechanism for the reaction on the surface of the electrode is proposed. The kinetic features of vanadium redox reactions on the CP electrode reveal that CP is suitable for use as the electrodes in vanadium redox-flow batteries.     

Optical assessment of silicon nanowire arrays fabricated by metal-assisted chemical etching

Silicon nanowire (SiNW) arrays were prepared on silicon substrates by metal-assisted chemical etching and peeled from the substrates, and their optical properties were measured. The absorption coefficient of the SiNW arrays was higher than that for the bulk silicon over the entire region. The absorption coefficient of a SiNW array composed of 10-μm-long nanowires was much higher than the theoretical absorptance of a 10-μm-thick flat Si wafer, suggesting that SiNW arrays exhibit strong optical confinement. To reveal the reason for this strong optical confinement demonstrated by SiNW arrays, angular distribution functions of their transmittance were experimentally determined. The results suggest that Mie-related scattering plays a significant role in the strong optical confinement of SiNW arrays.     

Improvement of carrier diffusion length in silicon nanowire arrays using atomic layer deposition

To achieve a high-efficiency silicon nanowire (SiNW) solar cell, surface passivation technique is very important because a SiNW array has a large surface area. We successfully prepared by atomic layer deposition (ALD) high-quality aluminum oxide (Al₂O₃) film for passivation on the whole surface of the SiNW arrays. The minority carrier lifetime of the Al₂O₃-depositedSiNW arrays with bulk silicon substrate was improved to 27 μs at the optimum annealing condition. To remove the effect of bulk silicon, the effective diffusion length of minority carriers in the SiNW array was estimated by simple equations and a device simulator. As a result, it was revealed that the effective diffusion length in the SiNW arrays increased from 3.25 to 13.5 μm by depositing Al₂O₃ and post-annealing at 400°C. This improvement of the diffusion length is very important for application to solar cells, and Al₂O₃ deposited by ALD is a promising passivation material for a structure with high aspect ratio such as SiNW arrays.     

Component-based robot system design for grasping tasks

The paper presents a robot system design with highly reusable components for a component-based robot system for manipulation tasks. The robot system is designed based on the analysis of manipulation tasks using a unified modeling language use case diagram. For a service robot with locomotion and manipulation mechanisms, reusability of robot system components is improved by adopting the proposed design. Our structure consists of scenario, task, robot information management server, data analyzer, sensor hardware controller, skill, and motion hardware controller on a component-based robot system. Based on the proposed robot system, we implemented a component-based robot system and subsequently realized a grasping motion by a service robot.     

Viscoelastic behavior of poly(butyl methacrylate) densely grafted on silica nanoparticles

A series of poly(butyl methacrylate)s (PBMAs) with various molar masses (33 000–270 000 g mol^?1), which were densely grafted on fumed silica nanoparticles (PBMA–SiO₂), were synthesized by surface‐initiated atom transfer radical polymerization. The dynamic viscoelastic behavior of PBMA–SiO₂ was systematically investigated in the solid and molten states with oscillatory strains, and compared to that of a conventional nanocomposite (PBMA/SiO₂). The storage moduli of PBMA–SiO₂ and PBMA/SiO₂ are equivalent in the solid state, whereas the storage modulus of PBMA–SiO₂ is lower than that of PBMA/SiO₂ in the molten state, especially at high silica loading. This is because the formation of a network structure composed of the silica nanoparticles in PBMA–SiO₂ is strongly suppressed by the polymer brushes on the particles. In contrast, even at low silica loading, the PBMA–SiO₂ system exhibits a gel‐like behavior resulting from a steric repulsion between the composite particles, because all of the tethered polymers behave as bound polymers. Copyright © 2011 Society of Chemical Industry