用微机图象法对脉冲MAG焊接熔池进行观察和控制的研究

本文对微机图象法在脉冲MAG焊接中的应用作了探讨,设计和采用了带有CCD摄象机的微机控制系统,对脉冲MAG焊接熔池进行了观察、监控和图象处理。其结果证明了采用微机图象法来实现实时控制是可行的。     

Cation Effect on the Binary and Ternary Phase Behaviors of Double-Tailed Methanesulfonate Amphiphiles

A series of symmetrical dialkyl methanesulfonate amphiphiles [DiC _n CHSO ₃ ] _m M (n = 6, 7, 8) with different counter cations (M^m+ = H⁺, Li⁺, Na⁺, K⁺, Cu²⁺, Zn²⁺, Mg²⁺, Ca²⁺, Sc³⁺) were synthesized in five steps. Their solubility and critical micelle concentration (CMC) in water were determined highlighting a huge effect of the chain length and the nature of the cation. The hydrophilic–lipophilic balance of the surfactants were assessed with the phase inversion temperature (PIT)-slope method based on the deviation from the PIT of the reference C₁₀E₄/n-octane/0.01 M NaCl_(aq) emulsion through addition of increasing amounts of the dialkyl methanesulfonates. The hydrophilicity of the surfactants was thus ranked in terms of dPIT/dx_sulfonate. A “cation” scan with the [DiC ₆ CHSO ₃ ] _m M /benzene/water systems at f_w = 0.5 was finally performed confirming the hydrophilicity ranking obtained with the PIT-slope method. It revealed that the [DiC ₆ CHSO ₃ ] ₂ Mg behaves as a “Balanced Surfactant” able to form spontaneously a three-phase microemulsion system (Winsor III) just in the presence of water and oil, in the same way as the catalytic surfactant dimethyldioctylammonium molybdate, which has the same PIT-slope.     

The Effect of Small Additions of Fe and Heavy Deformation on the Precipitation in an Al–1.1Mg–0.5Cu–0.3Si At. Pct Alloy

Metallurgical and Materials Transactions A - The effect of 0.03 and 0.08 at. pct Fe additions on the formation of secondary phases in an Al–1.1Mg–0.5Cu–0.3Si at. pct alloy was...     

Laser-Sintered Barium Titanate

Laser sintering of alkoxy-derived ultrafine BaTiO₃ powders was investigated. The temperature increases of the sample with laser irradiation were measured with a thermocouple. It was found that laser irradiation could generate enough heat to sinter ceramics. A slurry was prepared by mixing an alkoxy-derived BaTiO₃ powder, binder additives, solvent, and plasticizer. The slurry was tape cast and dried to give a green sheet. The green sheet was laser sintered and was then characterized by SEM, XRD, and density measurements. The effect of burnout before laser irradiation and the characteristic microstructure of laser-sintered BaTiO₃ are described.     

Gas permeation property of polyaniline films

We examined the influence of polyaniline (PAn)'s unit sequence and doping with low molecular weight dopants or polymer dopants on permeation property. It was found that CO₂ permeability was increased by the formation of a quinonediimine unit in PAn with the oxidation. CO₂ sorption amount of PAn was decreased by oxidation. The increase of CO₂ permeability with oxidation, therefore, resulted from the increase of diffusivity, which was attributable to morphological variation by the increase of a quinonediimine unit. The permselectivity of PAn films was found to be remarkably improved by doping. In particular, the selectivity value of the PAn film doped with polyvinyl sulphonic acid as a polymer dopant went up to over 2,000. This remarkable increase of selectivity was found to result in the increase of selectivity, depending on diffusivity. It was also found that the permselectivity of the PAn film doped by polymer dopants was surpassed, as compared with that doped by low molecular dopants. © 1995 John Wiley & Sons, Inc.     

Gas chromatographic separation of wax esters based on the degree of unsaturation

The wax esters of sperm whale head oil have been characterized by gas-liquid chromatography on an APOLAR 10C column according to their carbon number and number of double bonds. The novel technique permits the direct quantitative analysis of saturated and unsaturated wax esters.     

高速气流冲击式粉体表面改性装置——HYBRIDIZATION系统及应用

利用高速气流冲击法进行粉体/粉体系表面改性技术,是迄今为止各种粉体材料开发中最为引人注目的技术之一。HYBRIDIZATION(下称HYB)系统是利用高速气流冲击法对微粉体进行干式/机械化处理,是使材料复合化的最实用的装置,可对各类有机物、无机物、金属等进行广泛组合,通用性很强,适用于许多行业领域。从本文所述的系统构成、型式,有关的典型球形化处理的运转特性,利用复合化高温粉体测定被处理粉体表面温度,利用颜料改变色调等的处理特点及该系统的适用性等(一部分是从已发表的学术论文及专利上摘录的),可以说明HYB系统的概况。     

PTCR Characteristics in Barium Titanate Ceramics with Curie Points Between 60° and 360°C

PTCR characteristics in porous semiconducting barium titanate ceramics with Curie points from 60° to 360°C were investigated. The magnitude of the PTCR effect in these cerumics decreases self-onsistently with increasing Curie point within this temperature range. A PTCR efSect of more than 4 orders of magnitude was ahserved, for a Ba_0.44Pb_0.6TiO₃ ceramic with a Curie point of 360°C .     

Functional metal-porphyrazine derivatives and their polymers, 10. Secondary fuel cells based on oxygen reduction on platinum electrode modified by polymers and metal-phthalocyanines

Secondary fuel cells based on oxygen reduction of platinum electrode modified by polymers and metal-phthalocyanine (Mt = Fe(III), Co(II), Ni(II), and Cu(II)) were studied. The discharge curves for the platinum electrode modified by poly(2-vinylpyridine) (or polystyrene) and Co-phthalocyanine in 30% KOH aqueous solution, for a 30 min charge at 500 μA, followed by a 100 μA discharge showed a stable plateau at about ?0.24 V SCE (Saturated Calomel Electrode). The open circuit voltage (vs. Zn) of the cell was 1.2 V, and the discharge capacity was of 46 A · h/kg. For this battery there was no significant decay in its characteristics after more than 30 charge-discharge cycles. In Mt-phthalocyanines, the values decreased in the order of Co(II) > Fe(III) > > Cu(II) > Ni(II). From a cyclic voltammogram for the electrode modified by the polymer and Co-Pc, the cathodic reactions were discussed.     

Functional monomers and polymers, 64. Synthesis of poly-β-alanine from β-alanine, β-alanyl-β-alanine,and β-alanyl-β-alanyl-β-alanine 4-dodecanoyl-2-nitrophenyl esters

Active 4-dodecanoyl-2-nitrophenyl esters of β-alanine, β-alanyl-β-alanine, and β-alanyl-β-alanyl-β-alanine were prepared, and tried to polymerize in various solvents. Nonpolar solvents were found to be convenient for the polycondensation reaction. The yield of the polycondensation was high for the monopeptide ester, and less for the dipeptide and tripeptide esters. The effect of temperature on the polycondensation reaction was also studied.