Hereditarily elongated carotid sinus nerve in a rat colony

A specific colony of Wistar rats was found in which the common carotid artery bifurcates at an unusually caudal position, thereby the carotid sinus nerve that originates from the bifurcation is elongated. The present study was done to determine whether this elongated nerve carries baro- and chemosensations in the same manner as the carotid sinus nerve of conventional rats or of other species. In chloralose-urethane anesthetized rats of this specific colony, the afferent discharges were recorded from the elongated carotid sinus nerve in response to a phenylephrine-induced rise in blood pressure and a fall in oxygen tension, as well as an increase in carbon dioxide tension in the respiratory gas. Reflex effects of electrical stimulation of the nerve were also examined. In nerve recording, the afferent discharges of the elongated carotid sinus nerve were increased by any of the perturbations, hypertensive, hypoxic or hypercapnic. Electrical stimulation of the elongated carotid sinus nerve caused an initial rise and a subsequent fall in blood pressure, bradycardia, and an increase of respiratory volume and rate. These results confirmed that the elongated carotid sinus nerve of rats in this colony contains both baroreceptor and chemoreceptor afferent fibers. It seems that this colony of rats proffers a beneficial material which will facilitate the studies to analyze the features and reflex functions of carotid body chemoreceptors and/or carotid sinus baroreceptors.     

Three diabetic cases of acute dizziness due to initial administration of voglibose

We observed 3 diabetic patients with intolerable dizziness followed by nausea and vomiting immediately after an initial administration of the alpha-glucosidase inhibitor, voglibose. These symptoms did not recur after discontinuation of the drug. Adverse effects as observed in these cases have not been reported previously. Since the 3 patients were relatively old (average age, 72 years old) and had various degrees of micro- and macroangiopathies, these side effects may have been associated with increased micro- and macrocirculatory disturbances in their central nervous systems through alpha-glucosidase inhibition of this agent.     

Preparation of multiple oxide BaTiO3 fibres by the sol-gel method

Multiple oxide BaTiO₃ gel fibres were prepared by the sol-gel method from Ba(OC₂H₅)₂-Ti(O-isoC₃H₇)₄-H₂O-C₂H₅OH-CH₃COOH and Ba(CH₃COO)₂-Ti(O-isoC₃H₇)₄-H₂O-CH₃COOH solutions. Relatively long gel fibres of 10cm length were obtained from both solutions in the limited composition region. The latter solution in particular showed a spinnability even when it contained no water. Therefore, the occurrence of spinnability of the solution was considered to be due to the formation of linear polymers composed of bridging acetate groups such as TiO-C(CH₃)-O-Ti rather than metalloxane bonding as Ti-O-Ti. Addition of water to the solutions seems to break the bridging acetate bonds and replace some of them by bridging oxygen bonds. The as-drawn gel fibres which were X-ray amorphous crystallized into BaTiO₃ ceramic fibres of 5mm average length upon heating above 600 ° C. However, the gel fibres drawn from the sols without water became powdery on heating because of the lack of Ti-O-Ti metalloxane bonds. The crystallization behaviour of the BaTiO₃ gel fibres is discussed based on the infrared spectroscopy, X-ray diffraction analysis and thermogravimetric-differential thermal analysis.     

An abnormally shortened fatigue life of steels caused by anelasticity

Some abnormal fatigue life shortenings dependent upon load frequency for several steels are discussed. A possible relation between anelasticity caused by interstitial atoms and the abnormal fatigue life drop is presented. Normally, interstitial atoms are in a position which minimizes the energy around a dislocation, the Snoek ordering sites. We consider the Snoek effect as a typical example of anelasticity, and the possibility on atoms moving from attractive sites to repulsive ones when repeated stresses are applied and discuss a theory to explain the reduction of the fatigue life using Snoek ordered atoms moving out by fatigue stress at the frequency of Snoek effect. Bending fatigue tests were conducted to obtain the relationship between fatigue life and load frequency at two different temperatures (298 K and 333 K) for an iron nitrided steel. A sharp fatigue life drop was observed at a load frequency corresponding to the resonant frequency of the Snoek effect for nitrogen atoms. The frequency was about 3 Hz and 298 K and shifted to a higher frequency — about 6 Hz — at 333 K. Results reveal that the possible explanation to those abnormal phenomena may be anelasticity.Work partially conducted at Laboratorio E and Departamento de Ciencias de Materiales, Universidad Simón Bolívar, Venezuela.     

Ion exchange of intercalation compounds from WOP2O7 and intercalation ofn-alkylamines

Ion exchange of Na _x WOP₂O₇ ·nH₂O (x 1.4) prepared from WOP₂O₇ was attempted, using alkaline and alkaline earth ions. The degree of exchange was observed to be >50% at 90° C except for Mg²⁺. The basal spacing of ion-exchanged materials for the hydrated phase were dependent on the number of water molecules in the interlayer spaces, while those for the dehydrated phase increased with the size of ions in the interlayer spaces. The network of water molecules linked by the hydrogen bond in the interlayer spaces seems to determine the basal spacing. By the ion-exchange reaction,n-alkylammonium ions were intercalated into the interlayer spaces of Na _x WOP₂O₇ ·nH₂O (x 1.4) and Sn _x H _y WOP₂O₇ ·nH₂O (2x +y 0.5). In spite of the difference in the charge density of the host layer, a similar arrangement of alkyl chains in the interlayer spaces resulted, and neutral amines were considered to be intercalated as well as ammonium ions. Direct reaction ofn-alkylamine with WOP₂O₇ produced an intercalation compound without reduction of tungsten. The arrangement of the amines in the interlayer spaces is similar to that supposed to the ion-exchanged derivatives when heated at 140° Cin vacuo.     

Microstructural investigation and indentation response of pressureless-sintered α- and β-SiC

The microstructure and indentation response of pressureless-sintered - and -SiC were studied using a high-resolution electron microscope and analytical electron microscopy. The materials were manufactured with boron and carbon as sintering aids. It was found that the overall porosity of the materials was very low but a large number of carbon inclusions were present. X-ray diffraction revealed the fabricated -SiC material was of the same 3C polytype as the initial starting powder; however, electron microscope observations indicated that the material contained a high density of faulting of the -forms. High-resolution imaging of grain boundaries in these materials indicated that the boundaries were very clean, and when they contained an amorphous intergranular film it was at most 0.5 to 1 nm thick. The presence of boron was not detected. Deformation due to identation took several forms. Firstly, radial cracks extending from the corners of the indent suffered little hindrance from the matrix microstructure, such that transgranular fracture was the dominant mode. Secondly, the deformation zone beneath the indentations showed copious lattice microcracks with some preferred orientation during crack formation and propagation.     

Three-dimensional analysis for explosions of a propane-air mixture in cylindrical vessels

A mathematically simple spatial difference method has been applied for analysing three-dimensionally, and for illustrating graphically, the process of the development of a flame after the propane-air stoichiometric mixture is ignited. The calculated results show that the mathematical simulation can well express the process of mixture explosion in cylindrical vessels, and can evaluate the effects of laminar swirl flow on the flame development. It is concluded that the swirl motion deforms the flame front and accelerates the flame enlargement. Described also is a comparison of swirl flame calculation, with and without the centripetal effect caused by the difference in densities between burnt and unburnt gases.List of symbols A, A _f , A _K , A _W area, flame surface area, flame element area, and wall area - b _e heat penetration coefficient - C _d coefficient - C _p molar specific heat at constant pressure - G mass of gas - H cylinder height - h enthalpy and molar enthalpy - L effective length - M _j molecular weight - n, N normal unit vector and normal vector to flame surface - p pressure - q heat input per unit mass - r _c flame center location - r, R radius and vessel radius - R universal gas constant - Re Reynolds number - s _b , s _u flame speed and burning velocity - t time measured from spark-ignition - U _c inward moving velocity of flame center - u _u compression velocity of the unburnt gas just ahead of the flame front - U(u, v, w) velocity vector - v _i , V _i specific volume and volume of region-i - x _j mole fraction of specie-_j - x mass fraction of burnt gas - X(x, Y, z), X(x, r, ) orthogonal and cylindrical coordinate systems - Y _j mass fraction of specie-_j - Y mass fraction of burnt gas - small amount of change - change from the initial state Suffixes ij flame element number - i region or state - j chemical species     

Optimum/adaptive incremental sequence in nonlinear analysis

An approach to improve the accuracy of the incremental solutions to a nonlinear problem, through a strategy to control the size of the increment, based on stationary of an argumented energy functional, is presented. The problem of control of an optimum step size in the incremental theory is formulated for a fixed number of increments. The variables in this argumented functional are: (i) the incremental displacement vector, (ii) the scalar parameters _i which characterize the size of each of the increments, i = 1,..., N, and (iii) a Lagrange multiplier which enforces the constraint that the sum of all the normalized increments, i. e., _i is equal to 1. The optimality condition provides us a rigorous approach which gives rise to an iterative procedure because of nonlinearity of the stationary condition. If the number of increments is not prescribed, a noniterative procedure can be obtained, where the incremental sequence is controlled adaptively with less computational effort. The extension of the proposed method to non-selfadjoint problems, where a potential energy function does not exist, is also discussed. Numerical examples demonstrate the remarkable improvement in the accuracy of the solution by optimizing the incremental sequence, as well as the effectiveness of the adaptive control procedure proposed.Paper presented at The 16th International Congress of Theoretical and Applied Mechanics, Lyngby, Denmark, August 19–25, 1984     

Activities of FexO in CaO + CaF2 + SiO2 + FexO quaternary slags by disposable electrochemical oxygen probes

The activities of Fe_xO in CaO + CaF₂ + SiO₂ + Fe_xO quaternary slags were measured by means of solid-oxide galvanic cell. The Fe_xO activities in the slags are influenced by CaF₂ as well as SiO₂. At constant Fe_xO mole fractions, e.g., , at low SiO₂ mole fractions i.e., , the substitution of CaF₂ for CaO has an effect of raising the Fe_xO activity. At higher SiO₂ mole fractions, e.g., , however, such an effect becomes insignificant.