A study on information security management system evaluation—assets, threat and vulnerability

The security of information system is like a chain. Its strength is affected by the weakest knot. Since we can achieve 100% Information Security Management System (ISMS) security, we must cautiously fulfill the certification and accreditation of information security. In this paper, we analyzed, studied the evaluation knowledge and skills required for auditing the certification procedures for the three aspects of ISMS—asset, threat, and vulnerability.     

GENERALISED TRANSFER FUNCTIONS OF NEURAL NETWORKS

When artificial neural networks are used to model non-linear dynamical systems, the system structure which can be extremely useful for analysis and design, is buried within the network architecture. In this paper, explicit expressions for the frequency response or generalised transfer functions of both feedforward and recurrent neural networks are derived in terms of the network weights. The derivation of the algorithm is established on the basis of the Taylor series expansion of the activation functions used in a particular neural network. This leads to a representation which is equivalent to the non-linear recursive polynomial model and enables the derivation of the transfer functions to be based on the harmonic expansion method. By mapping the neural network into the frequency domain information about the structure of the underlying non-linear system can be recovered. Numerical examples are included to demonstrate the application of the new algorithm. These examples show that the frequency response functions appear to be highly sensitive to the network topology and training, and that the time domain properties fail to reveal deficiencies in the trained network structure.     

Thin Film Deposition of Semiconducting Ni-Co Oxide Spinel with Adequate Electrical and Optical Properties for Energy Application

Nickel-cobalt oxide with spinel structure was successfully fabricated using a wet chemical route followed by calcinations at 300 °C. In nickel-cobalt spinel oxide, Ni²⁺ ions occupy the octahedral sites and Co³⁺ ions are distributed over both octahedral and tetrahedral sites. Very interestingly, nickel-cobalt spinel oxide does not only show a p-type semi-conducting behavior material but also exhibits desired transparency in infrared wavelengths. Electrical and optical properties of the deposited films were investigated as a function of different processing conditions. The sputtering target is fabricated by homogeneously mixing oxide powders and followed by sintering at 1,500 °C. The nickel-cobalt oxide film showed a resistivity as low as 10^?2 Ω-cm by radio frequency (RF) magnetron sputtering in a pure oxygen atmosphere. The sputter-deposited nickel-cobalt oxide films also showed more than 70% transmittance in the infrared range.     

Simulation and experimental investigation of two hybrid solar domestic water heaters with drain water heat recovery

In this paper, the performance of two solar domestic hot waters (SDHW) with drain water heat recovery (DWHR) units is investigated. Both SDHW systems are recently installed at the Archetype Sustainable Twin Houses at Kortright Center, Vaughan, Ontario. The first SDWH system in House A consists of a flat plate solar thermal collector in combination with a gas boiler and a DWHR unit. The second SDHW system in House B includes an evacuated tube solar collector, an electric tank, and a DWHR unit. Both systems are modeled in TRNSYS, and the models are validated by experimental data. The addition of the DWHR and the flat‐plate solar thermal collector would result in 1831 kWh of annual energy saving in House A. While the addition of the DWHR and the evacuated tube collector in House B would result in an annual energy saving of 1771 kWh. Subsequently, the models are used to investigate the performance of similar systems for five major Canadian cities of Halifax, Montreal, Toronto, Edmonton, and Vancouver. The conjunctions of solar thermal collectors with DWHR units are found most beneficial in Edmonton. It is also noted from experimental and simulated results that flat‐plate solar collector‐based water heater produced more thermal energy than the system based on the evacuated tube solar collector for all major Canadian cities. Copyright © 2015 John Wiley & Sons, Ltd.     

Ultrafine particles generated from coloring with scented markers in the presence of ozone

High concentrations of ultrafine particles (UFPs) have been previously reported during school art activities. This is possibly due to secondary organic aerosols (SOAs) formed from reactions between ozone and volatile organic compounds emitted from art products. Four brands of markers, three scented and one unscented, were tested inside a stainless steel chamber at eight different ozone concentrations between 0 and 300 ppb. Out of the 32 tested markers, only the lemon‐ and orange‐scented markers from one brand reacted with ozone to form UFPs. Limonene, pinene, and several other terpenes were identified as ingredients of ink in SOA‐forming markers. Coloring with one lemon‐scented marker for 1 min without ozone generated on average approximately 26 ± 4 ppb of limonene inside the chamber. At 150 ppb ozone, using one lemon marker for 1 min formed on average 7.7 × 10¹⁰ particles. The particle size distribution indicated an initial mode of 15 nm which grew to 40 nm. At 50 ppb ozone and below, no significant SOA formation occurred. The number of particles formed is moderately correlated with the mass of ink used (R² = 0.68). Based on these data, scented markers are not likely a strong source of SOA under normal indoor ozone levels.