Subcooled Flow Boiling in a Minichannel

It has been considered that dry-out occurs easily in boiling heat transfer for a small channel, a mini- or microchannel, because the channel was easily filled with coalescing vapor bubbles. In the present study, the experiments of subcooled flow boiling of water were performed under atmospheric conditions for a horizontal rectangular channel for which the size is 1 mm height and 1 mm width, with a flat heating surface of 10 mm length and 1 mm width placed on the bottom of the channel. The heating surface has a top of copper heating block and is heated by ceramic heaters. In the high heat flux region of nucleate boiling, about 70–80% of the heating surface was covered with a large coalescing bubble and the boiling reached critical heat flux as observed by high-speed video. In the beginning of transition boiling, coalescing bubbles were collapsed to many fine bubbles and microbubble emission boiling was observed at liquid subcooling higher than 30 K. The maximum heat flux obtained was 8 MW/m² (800 W/cm²) at liquid subcooling of higher than 40 K and a liquid velocity of 0.5 m/s. However, the surface temperature was very much higher than that of a centimeter-scale channel. The high-speed video photographs indicated that microbubble emission boiling occurs in the deep transition boiling region.     

Water quality and transparency characteristics during the Planktothrix abundance period in shallow Lake Kasumigaura,Japan

Cyanobacterial blooms in lakes cause serious environmental problems on a global scale. Planktothrix (a filamentous cyanobacterium) blooms occurred during winter and spring from 2007 to 2011 in Lake Kasumigaura, a eutrophic lake located in Japan. This study analysed water quality during the period of Planktothrix abundance (2007–2010) at the centre of Lake Kasumigaura and compared it to that in the succeeding period, which did not have Planktothrix blooms (2012–2015). The average phytoplankton biovolume during the abundance period was larger than that in the succeeding period, which would contribute to the high chemical oxygen demand (COD_Mn; annual average of 9.7 mg/L) in the abundance period, compared to the succeeding period (7.6 mg/L). The total phosphorus concentration peaked in spring and summer in the abundance period, but only in summer in the succeeding period, whereas the seasonal variation in total nitrogen concentration between the two periods was relatively small. The annual average transparency (Secchi disc depth) increased before the abundance period due to a decrease in fixed suspended solid, which is comprised mainly of inorganic matter. It is likely that the change in irradiance conditions affected the occurrence of Planktothrix blooms.     

Effect of treatment of activated carbon fiber cloth electrodes with cold plasma upon performance of electric double-layer capacitors

Charge/discharge behavior of electric double-layer capacitors composed of activated carbon fiber cloth (ACFC) electrodes and an organic electrolyte was investigated. The modification of the ACFC electrodes was performed using cold plasma generated in argon-oxygen atmosphere. The effect of the cold plasma treatment of the ACPC electrodes on the capacitor performance was discussed on the basis of the physical and chemical properties of the ACFC surface such as pore radius distribution and surface atom concentration.     

Evaluating the performance of forced convection heat transfer enhancement

Two methods for assessing thermal performance were evaluated for four kinds of forced convective heat transfer augmentations. On method uses the first law of thermodynamics, i.e., the heat transfer improvement at (1) constant Reynolds number, (2) constant pressure loss, and (3) constant pumping power. The other method uses the second law of thermodynamics, i.e., the entropy generation. The first method restricts the effective region and the second method supplies the condition for achieving the minimum entropy generation rate. © 1998 Scripta Technica, Heat Trans Jpn Res, 27(2): 142–154, 1998     

Newly Developed Thyristor Chopper Equipment for Electric Railcars

In the chopper control system for electric railcars, it is effective to adopt high operational frequency of the chopper for achievement of the following: 1) decrease of higher harmonic current induced in the trolley wire, 2) reduction of weight for reactors and capacitors in the traction circuit, and 3) improvement of control response. Through development of reverse-conducting thyristors with very short turn-off time and a repulsion type two-phase chopper, we finally realized production of a new standard high-frequency chopper equipment with regenerative braking for 1500-V dc railcars. Technical achievements mentioned previously were completely realized as a result of adoption of high frequency, 660 Hz, in the equipment. The newly developed standard high-frequency chopper equipment for 30 cars were delivered to the Chiyoda Line of Teito Rapid Transit Authority in Tokyo, and they have been operated satisfactorily in revenue service since March 1971. This paper also describes: 1) the chopper circuit using fast-switching reverse-conducting thyristors and series saturable reactors, 2) analysis of commutation circuit and methods of suppressing reapplied forward voltage increasing rate (dv/dt) and shortening commutation period, 3) the composition of the traction circuit including the protection system, such as protection for overvoltage at the regenerative braking, and 4) test results on the Chiyoda Line of Teito Rapid Transit Authority.     

Organofunctionalized catalyst surfaces highly active and selective for carbon–carbon bond-forming reactions

This article illustrates two types of organofunctionalized heterogeneous catalysts for variety of organic carbon–carbon bond-forming reactions, summarizing our previous reports and also presenting new data. Organic amines with an alkoxysilane moiety were immobilized on inorganic silica-alumina surfaces (SA-NR₂) by simple silane-coupling reactions between the silica-alumina surface (SA) and the alkoxysilane. This SA-NR₂ acted as acid–base bifunctional heterogeneous catalysts for carbon–carbon bond-forming reactions, such as cyano-ethoxycarbonylation, Michael reaction of nitriles, and nitro-aldol reaction. These reactions did not occur with either SA or homogeneous amine compounds. In addition, the mixture of SA and homogeneous amine showed low catalytic activity due to undesirable acid–base neutralization reaction. Achiral organic silane-coupling reagents with a variety of functional groups were also immobilized on a SiO₂ surface that had been immobilized with chiral bis(oxazoline) (BOX), to which Cu ions were coordinated to make chiral Cu–BOX complexes on the SiO₂ surface. The SiO₂-supported Cu–BOX complex catalyst functionalized with achiral 3-methacryloxypropyltrimethoxysilane dramatically increased enantioselectivity in the asymmetric Diels–Alder reaction of cyclopentadiene and 3-acryloyl-2-oxazolidinone. The organofunctionalized catalysts showed much better performances for the C–C bond-forming reactions compared to the corresponding homogeneous systems. The heterogeneous catalysts thus obtained were characterized by solid-state ¹³C and ²⁹Si MAS NMR, FT-IR, UV/vis, XAFS, ESR, XRF, and elemental analysis.     

An analysis of the length of hospital stay for cataract patients in Japan using the discrete-type proportional hazard model

We analyze the length of hospital stays of patients hospitalized for cataract and related diseases (Diagnosis Related Groups (DRG) 2041) in Japan, utilizing the data pertaining to 3436 patients on whom one-eye lens operations are performed. We use the discrete-type proportional hazard model to analyze variables that may affect the length of stay.     

Analysis of polymer electrolyte fuel cell performance by electrode polarization model

For development of polymer electrolyte fuel cell (PEFC) lifetime estimation method, a high accuracy PEFC electrode polarization model is required. An electrode polarization model which was previously proposed was verified. However, accuracy of the electrode polarization model was not enough to estimate PEFC performance under various conditions. A new high accuracy PEFC electrode polarization model has been developed based on electrochemical consideration and data observed at elevated pressures. In the cathode polarization model, effects of O₂ diffusion and H₂O plugging have to be considered to obtain high accuracy for long-term operation. In addition, PEFC performance degradation was analyzed by the electrode polarization model. Main factors of PEFC performance degradation are OCV drop, the cathodic activation polarization, voltage drops by O₂ diffusion and H₂O plugging.     

Guided-mode resonant grating filter with an antireflection structured surface

We describe a new structure of guided-mode resonant grating (GMRG) filters with low sideband reflectance. This GMRG filter consists of a high-index thin film on an antireflective structured surface called "moth-eye structure." Since the high-index film undulates along the surface structure, the film acts as a modulated optical waveguide. An incident light wave satisfying a resonant condition is reflected by the GMRG filter, and nonresonant light waves pass through the filter. This GMRG filter is valid for reducing reflection of nonresonant light waves in a wide spectral range. The resonant reflection of this new filter was investigated by numerical calculation based on an electromagnetic grating analysis. In the case of a triangular antireflective surface structure whose thickness is 2x greater than its period, the sideband reflectance for nonresonant light waves was lower than 0.5% for TM-polarized light in a wide range of wavelengths.     

Digalactosyldiacylglycerol suppression of inhibition by sulfoquinovosyldiacylglycerol of alpha-glucosidase

Digalactosyldiacylglycerol (DGDG) suppressed the inhibition by sulfoquinovosyldiacylglycerol (SQDG) of an alpha-glucosidase reaction. Suppressing was considered to be an apparent decrease in inhibitory activity of SQDG ascribed to direct interaction between SQDG and DGDG. This suppression was presumed to be caused by less access of SQDG to the enzyme because SQDG and DGDG formed mixed micelles.