Characteristics of interfacial profiles in upward and downward gas-liquid two-phase plug flow

Gas-liquid interfacial profiles in plug flow for both upward and downward flows were obtained using semi-supermultiple point-electrode probes, comprising 67 sensing tips arranged on a tube diameter. Typical interfacial profiles are demonstrated for both flows. Close inspection of the profiles reveals that four zones exist in a pair of gas and liquid slugs for upward plug flow and a high slip velocity region in downward plug flow. The lengths of the swelling liquid front zone and the wake zone were determined. The length of the wake zone strongly depends on the relative velocity between the liquid film around the gas slug and the liquid phase in the liquid slug. Characteristic distributions of bubbles within liquid slugs were found, i.e., three types of radial distributions of void fraction, namely saddle-shaped, trapezoidal and bullet-shaped distributions, exist for upward flow. The two types for downward flow exclude the saddle-shaped distribution. © 1997 Scripta Technica, Inc. Heat Trans Jpn Res, 25 (8): 568–579, 1996     

Crack-Healing Behavior of Si3N4/SiC Ceramics under Cyclic Stress and Resultant Fatigue Strength at the Healing Temperature

Si₃N₄/SiC composite ceramics were sintered and subjected to three-point bending. A semi-elliptical surface crack of 100 μm surface length was made on each specimen. The crack-healing behavior under cyclic stress of 5 Hz, and resultant cyclic fatigue strengths at healing temperatures of 1100° and 1200°C, were systematically investigated. The main conclusions are as follows: (1) Si₃N₄/SiC composite ceramics have an excellent ability to heal a crack at 1100° and 1200°C. (2) This sample could heal a crack even under cyclic stress at a frequency of 5 Hz. (3) The crack-healed sample exhibited quite high cyclic fatigue strength at each crack-healing temperature, 1100° and 1200°C.     

Effect of chitosan feeding on intestinal bile acid metabolism in rats

The effect of chitosan feeding (for 21 days) on intestinal bile acids was studied in male rats. Serum cholesterol levels in rats fed a commercial diet low in cholesterol were decreased by chitosan supplementation. Chitosan inhibited the transformation of cholesterol to coprostanol without causing a qualitative change in fecal excretion of these neutral sterols. Increased fiber consumption did not increase fecal excretion of bile acids, but caused a marked change in fecal bile acid composition. Litcholic acid increased sigificantly, deoxycholic acid increased to a leasser extent, whereas hyodeoxycholic acid and the 6β-isomer and 5-epimeric 3α-hydroxy-6-keto-cholanoic acid(s) decreased. The pH in the cecum and colon became elevated by chitosan feeding which affected the conversion of primary bile acids to secondary bile acids in the large intestine. In the cecum, chitosan feeding increased the concentration of α-,β-, and ω-muricholic acids, and lithocholic acid. However, the levels of hyodeoxycholic acid and its 6β-isomer, of monohydroxy-monoketo-cholanoic acids, and of 3α, 6ξ, 7ξ-trihydroxy-cholanoic acid decreased. The data suggest that chitosan feeding affects the metabolism of intestinal bile acids in rats.     

Leak detection in pipe using transient flow and genetic algorithm

An inverse transient method with genetic algorithm (GA) was applied to leak detection in pipeline. Transient flow caused by valve operation was calculated using the characteristics method. The location and discharge of leak were determined so that the difference of the calculated pressure may be minimized from the reference pressure calculated under a given leak condition. Calculations were done for the leak at one and two locations in pipeline. Furthermore, the effect of noise in pressure data was discussed, and the leak locations and leak discharges can be predicted precisely even in the case of noisy data. This paper was presented at the 9^th Asian International Conference on Fluid Machinery (AICFM9), Jeju Korea, October 16–19, 2007.     

Formation Mechanism of Hydrous-Zirconia Particles Produced by Hydrolysis of ZrOCl2 Solutions: II

The primary and secondary particle sizes of monoclinic hydrous-ZrO₂ particles produced by the hydrolysis of various ZrOCl₂ solutions, with and without the addition of NaCl, CaCl₂, or AlCl₃, were measured using X-ray diffraction and transmission electron microscopy in order to clarify the formation mechanisms of primary and secondary particles. The primary particle size of hydrous ZrO₂, under a constant ZrOCl₂ concentration, decreased monotonously with increasing Cl⁻-ion concentration. On the contrary, the secondary particle size increased monotonously with increasing Cl⁻-ion concentration. The present experimental results revealed that the primary and secondary particle sizes of hydrous ZrO₂ are controlled primarily by the concentrations of H⁺ and Cl⁻ ions produced during hydrolysis, and are independent of the type of added metal ions. The formation mechanisms of the primary and secondary particles of hydrous ZrO₂ were determined on the basis of the present experimental results.     

Numerical analysis of coupled transport and reaction phenomena in an anode-supported flat-tube solid oxide fuel cell

Heat and mass transfer with electrochemical reaction in an anode-supported flat-tube solid oxide fuel cell (FT-SOFC) is studied by means of three-dimensional numerical simulation. The distributions of the reaction fields in the anode-supported FT-SOFC are found to be similar to those in the planar SOFC with co-flow arrangement. However, in comparison with the latter, the concentration and activation overpotentials of the former can be reduced by additional reactant diffusion through the porous rib of the fuel channel. Parametric survey reveals that, for a fixed activation overpotential model, the output voltage can be improved by increasing the pore size of anode, while the cross-sectional geometry has smaller effect on the cell performance. Based on the results of three-dimensional simulation, we also develop a simplified numerical model of anode-supported FT-SOFC, which takes into account the concentration gradients in the thick anode of complex cross-sectional geometry. The simplified model can sufficiently predict the output voltage as well as the distributions of temperature and current density with very low computational cost. Thus, it can be used as a powerful tool for surveying wide range of anode-supported FT-SOFC design parameters.     

Effect of blending on liquefaction of coals

After solvent extraction of Taiheiyo, Miike and Balmer coals using wash oil under nitrogen atmosphere at 370 °C for 30 min, the extraction yield is always within the additivity law. Further studies used Yallourn, Soyakoishi, Taiheiyo, Horonai, Miike, Shin Yubari, Balmer coals and their blends which were hydrogenated in tetralin, wash oil or creosote oil, with or without catalyst, at 400–450 °C under 10 or 3 MPa of initial hydrogen pressure. When hydrogen is available, the additivity law exists for blended coals, but when the hydrogen supply is deficient, the experimental conversion of blended coals is always lower than calculated conversions. This may be due to the faster consumption of the hydrogen by more reactive coals and thus the less reactive coals were unable to react with hydrogen.     

Correlation of reactivity to hydrogenation and chemical structure of lignites

Three North Dakota lignites with almost the same percentage carbon have been used to determine the relation between chemical structure and reactivity to hydrogenation. Average structural indices of the lignites were estimated using the pyridine-soluble products after alcohol-alkali treatment, the structural indices obtained at various reaction times being extrapolated to zero reaction time. Hydrogenation was influenced by the average structure, with the lignite having higher aromaticity, higher molecular weight of the pyridine extract from the alcohol-alkali reaction product, larger aromatic ring size and lower content of aliphatic structure, showing a smaller degree of conversion.     

Sintering Kinetics at Constant Rates of Heating: Effect of Al2O3 on the Initial Sintering Stage of Fine Zirconia Powder

The sinterabilities of fine zirconia powders including 5 mass% Y₂O₃ were investigated, with emphasis on the effect of Al₂O₃ at the initial sintering stage. The shrinkage of powder compact was measured under constant rates of heating (CRH). The powder compact including a small amount of Al₂O₃ increased the densification rate with elevating temperature. The activation energies at the initial stage of sintering were determined by analyzing the densification curves. The activation energy of powder compact including Al₂O₃ was lower than that of a powder compact without Al₂O₃. The diffusion mechanisms at the initial sintering stage were determined using the new analytical equation applied for CRH techniques. This analysis exhibited that Al₂O₃ included in a powder compact changed the diffusion mechanism from grain boundary to volume diffusions (VD). Therefore, it is concluded that the effect of Al₂O₃ enhanced the densification rate because of decrease in the activation energy of VD at the initial sintering stage.     

Enhanced Light Storage of SrAl2O4 Glass‐Ceramics Controlled by Selective Europium Reduction

A luminescent Eu, Dy: SrAl₂O₄ glass‐ceramics with high transparency in the visible region was successfully synthesized using the frozen sorbet technique with the control of O₂ partial pressure () for the oxidation of Eu²⁺ ions. The glass‐ceramics include Eu²⁺, Eu³⁺, and Dy³⁺ ions, and thus exhibits three characteristic types of emission bands, 4f–5d at around 520 nm (Eu²⁺ ions), 4f–4f at 610 nm (Eu³⁺ ions), and 480 nm (Dy³⁺ ions). The Eu, Dy: SrAl₂O₄ glass‐ceramics provide remarkable long‐persistent luminescence under dark condition. The glass‐ceramics also exhibits color‐changing luminescence in the visible region based on their remarkable light storage properties. The luminescent Eu, Dy: SrAl₂O₄ glass‐ceramics using the frozen sorbet technique with control of are promising materials for application in novel photonic and light storage materials.