Evidence for a Jahn-Teller distortion of Cs2NaHoCl6 at 150 mK observed by X-ray diffractometry

By means of SR X-ray diffractometry, cooperative Jahn-Teller distortion as a structural phase transformation of the first kind is directly confirmed by a splitting of Laue spots. It is understood that the degenerate ground state of a nonmagnetic doublet (₃) of Ho³⁺ in a cubic Ho-elpasolite, Fm3m(O _h ⁵ ), at least above 600 mK, is lifted up by a distortion below 150 mK, which was predicted by a splitting of the NQR spectrum and anomalies in the specific heat and magnetic susceptibility. This structural transformation shows not only the lowest transition temperature up to now, but also the greatest hysteresis specified by a Schottky-type excitation. The magnitude of the relative distortion (1/1) has been roughly estimated to be on the 2.0 · 10^–3 order of magnitude, which is much larger than the predicted value obtained from a point charge approximation. The pecularities of this transition are discussed from the viewpoint that the general theory of a structural transformation, established convincingly at high temperatures could not be easily applied.     

Successful fabrication of bicrystal Si substrates for YBa2Cu3O7 − y Josephson junctions

Bicrystal Si(BiSi) substrates for grain boundary (GB) Josephson junctions (GBJJs) have been fabricated by a direct bonding technique using a hot press method. The fracture strength and structure of the bonding interfaces were investigated to obtain substrates suitable for the junctions. It was found that an increase in the pressure of the hot press improves the reproducibility of the GBJJs. YBa₂Cu₃O_{7 − y} GBJJs were successfully fabricated on Bi-Si substrates with a misorientation angle of 15 ° bonded under a pressure of 90 kgf cm⁻² at 1200 °C in a vacuum of ≈10⁻³ Pa. These junctions showed typical I-V curves described by the RSJ model. The Shapiro steps induced by millimetre wave irradiation of 101 GHz were clearly observed in the I-V curves up to 3 mV, corresponding to at least 1.5 THz (, where e is the unit charge, V the voltage and h Planck's constant).     

Reconstruction of a complex-valued object in double-passage coherent imaging through a random-phase screen

We consider the reconstruction of a complex-valued object that is coherently illuminated and viewed through the same random-phase screen. The reconstruction is based on two intensity measurements: the intensity of the Fourier transform of the image and the intensity of the Fourier transform of the image when modulated with an exponential filter. The illumination beam has a Gaussian intensity profile of arbitrary width, and the phase screen is assumed to be described by a Gaussian random process of large variance and arbitrary correlation length. Computer-simulated examples of the reconstruction of a two-dimensional complex object demonstrate that the reconstruction is robust.     

Disposition of diadenosine 5',5"'-P1,P4-tetraphosphate (Ap4A) in rats

The disposition of diadenosine 5'5"'-P1,P4-tetraphosphate (Ap4A), an endogenous dinucleotide, was investigated in rats. The degradation of Ap4A in rat plasma was very rapid and could be explained by a Michaelis-Menten equation: Km and Vmax values were 1.69 micrograms/ml and 4.32 micrograms/min/ml, respectively. Ap4A was degraded in rat plasma to ATP and AMP, but not to 2 ADP molecules, and these nucleotides were further degraded through adenosine. The degradations kinetics were examined. After intravenous bolus injection, Ap4A in plasma declined rapidly and the rate of elimination was dose-dependent: the biological half-life was about 3s at the dose of 1 mg/kg and was longer at 3 mg/kg. When Ap4A was administered by intravenous infusion (0.5 or 1.0 mg/kg/min), the plasma level rapidly reached a steady-state, which then rapidly declined after stopping the infusion.     

Engineering Transition Metal Layers for Long Lasting Anionic Redox in Layered Sodium Manganese Oxide

Oxygen-redox-based-layered cathode materials are of great importance in realizing high-energy-density sodium-ion batteries (SIBs) that can satisfy the demands of next-generation energy storage technologies. However, Mn-based-layered materials (P2-type Na-poor Na_y[A_xMn_1−x]O₂, where A = alkali ions) still suffer from poor reversibility during oxygen-redox reactions and low conductivity. In this work, the dual Li and Co replacement is investigated in P2-type-layered Na_xMnO₂. Experimentally and theoretically, it is demonstrated that the efficacy of the dual Li and Co replacement in Na_0.6[Li_0.15Co_0.15Mn_0.7]O₂ is that it improves the structural and cycling stability despite the reversible Li migration from the transition metal layer during de-/sodiation. Operando X-ray diffraction and ex situ neutron diffraction analysis prove that the material maintains a P2-type structure during the entire range of Na⁺ extraction and insertion with a small volume change of ≈4.3%. In Na_0.6[Li_0.15Co_0.15Mn_0.7]O₂, the reversible electrochemical activity of Co³⁺/Co⁴⁺, Mn³⁺/Mn⁴⁺, and O^2-/(O₂)^n- redox is identified as a reliable mechanism for the remarkable stable electrochemical performance. From a broader perspective, this study highlights a possible design roadmap for developing cathode materials with optimized cationic and anionic activities and excellent structural stabilities for SIBs.     

Origin of Hole-Trapping States in Solution-Processed Copper(I) Thiocyanate and Defect-Healing by I2 Doping

Solution-processed copper(I) thiocyanate (CuSCN) typically exhibits low crystallinity with short-range order; the defects result in a high density of trap states that limit the device's performance. Despite the extensive electronic applications of CuSCN, its defect properties are not understood in detail. Through X-ray absorption spectroscopy, pristine CuSCN prepared from the standard diethyl sulfide-based recipe is found to contain under-coordinated Cu atoms, pointing to the presence of SCN⁻ vacancies. A defect passivation strategy is introduced by adding solid I₂ to the processing solution. At small concentrations, the iodine is found to exist as I⁻ which can substitute for the missing SCN⁻ ligand, effectively healing the defective sites and restoring the coordination around Cu. Computational study results also verify this point. Applying I₂-doped CuSCN as a p-channel in thin-film transistors shows that the hole mobility increases by more than five times at the optimal doping concentration of 0.5 mol.%. Importantly, the on/off current ratio and the subthreshold characteristics also improve as the I₂ doping method leads to the defect-healing effect while avoiding the creation of detrimental impurity states. An analysis of the capacitance-voltage characteristics corroborates that the trap state density is reduced upon I₂ addition.     

Generalized multiplicative stochastic processes arising from one-dimensional maps with noise

Artificial Life and Robotics - We propose a class of generalized multiplicative stochastic processes obtained by introducing an endo-perspective into one-dimensional maps with additive noise. We...     

Prediction of color changes in acetaminophen solution using the time–temperature superposition principle

A prediction method for color changes based on the time–temperature superposition principle (TTSP) was developed for acetaminophen solution. Color changes of acetaminophen solution are caused by the degradation of acetaminophen, such as hydrolysis and oxidation. In principle, the TTSP can be applied to only thermal aging. Therefore, the impact of oxidation on the color changes of acetaminophen solution was verified. The results of our experiment suggested that the oxidation products enhanced the color changes in acetaminophen solution. Next, the color changes of acetaminophen solution samples of the same head space volume after accelerated aging at various temperatures were investigated using the Commission Internationale de l’Eclairage (CIE) LAB color space (a*, b*, L* and ΔE*ab), following which the TTSP was adopted to kinetic analysis of the color changes. The apparent activation energies using the time–temperature shift factor of a*, b*, L* and ΔE*ab were calculated as 72.4, 69.2, 72.3 and 70.9 (kJ/mol), respectively, which are similar to the values for acetaminophen hydrolysis reported in the literature. The predicted values of a*, b*, L* and ΔE*ab at 40?°C were obtained by calculation using Arrhenius plots. A comparison between the experimental and predicted values for each color parameter revealed sufficiently high R² values (>0.98), suggesting the high reliability of the prediction. The kinetic analysis using TTSP was successfully applied to predicting the color changes under the controlled oxygen amount at any temperature and for any length of time.     

Use of sky brightness measurements from ground for remote sensing of particulate polydispersions

The software code SKYEAD.pack for retrieval of aerosol size distribution and optical thickness from data of direct and diffuse solar radiation is described; measurements are carried out with sky radiometers in the wavelength range 0.369-1.048 μm. The treatment of the radiative transfer problem concerning the optical quantities is mainly based on the IMS (improved multiple and single scattering) method, which uses the delta-M approximation for the truncation of the aerosol phase function and corrects the solution for the first- and second-order scattering. Both linear and nonlinear inversion methods can be used for retrieving the size distribution. Improved calibration methods for both direct and diffuse radiation, the data-analysis procedure, the results from the proposed code, and several connected problems are discussed. The results can be summarized as follows: (a) the SKYRAD.pack code can retrieve the columnar aerosol features with accuracy and efficiency in several environmental situations, provided the input parameters are correctly given; (b) when data of both direct and diffuse solar radiation are used, the detectable radius interval for aerosol particles is approximately from 0.03 to 10 μm; (c) besides the retrieval of the aerosol features, the data-analysis procedure also permits the determination of average values for three input parameters (real and imaginary aerosol refractive index, ground albedo) from the optical data; (d) absolute calibrations for the sky radiometer are not needed, and calibrations for direct and diffuse radiation can be carried out with field data; (e) the nonlinear inversion gives satisfactory results in a larger radius interval, without the unrealistic humps that occur with the linear inversion, but the results strongly depend on the first-guess spectrum; (f) aerosol features retrieved from simulated data showed a better agreement with the given data for the linear inversion than for the nonlinear inversion.