联合法提镓工艺研究

针对联合法氧化铝厂循环母液含镓的特点 ,提出采用化学法和树脂吸附法相结合的方式从烧结法拜耳法循环母液回收镓的新工艺 ,并通过小试和扩大试结果分析 ,从技术和经济诸方面阐述了该工艺的可行性     

Influence of electroplating conditions on magnetic properties of Fe-36wt.% Ni alloy film

A Fe-Ni soft magnetic film was prepared in sulphate solution by electroplating. The influences of the molar ratio of n [Fe2+ ]/ n [Ni2+ ], current density, bath temperature, pH and L-ascorbic acid concentration on magnetic properties of Fe-Ni alloy film were investigated. The results show that the saturated flux density(BS) of the film increases initially and decreases after it reaches the specific value with the increase of n [Fe2+ ]/ n [Ni2+ ] molar ratio, current density, bath temperature and pH. However, the relationship between L-ascorbic acid concentration and B S keeps linear. It is observed that the coercive force( Hc) is enhanced with the increase of n [Fe2+ ]/ n [Ni2+ ] molar ratio, current density and pH. By comparison, when the bath temperature increases, Hc always decreases. With the increase of L-ascorbic acid concentration, the coercive force increases initially and then decreases.     

INVESTIGATION ON CRYSTALLIZATION KINETICS OF Pd-Cu-Si GLASS

The crystallization kinetics of Pd-Cu-Si glass was studied by means of diferential scanningcalorimetry-Ⅱ.According to Kissinger peak shift meth(?)d and Arrhenius equation,theapparent activation energy was calculated.The crystallization kinetics follows Johnson-Mehl-Avrami equation with n=3.0 within 0.15相似文献   

板料弯曲回弹的有限元模拟影响因素研究

阐述了板料成形数值模拟中回弹问题的研究历史和发展现状,分析了塑性弯曲加工中工件发生弯曲回弹的原因、特点及有限元模拟过程的影响因素,总结了回弹模拟的算法,从成形过程模拟和回弹计算两方面系统分析了影响回弹模拟准确性和收敛性的主要因素及改进方向,讨论了模具设计中回弹的补偿算法 ,并提出了当前控制回弹的基本方法     

Phase transformation behavior in Al-Zn-Cu alloys by hammering

The 5Cu40Zn55Al and 15Cu20Zn65Al alloys were prepared in the AI-Zn-Cu system, There exist the metastable phases ε and θ in the two alloys after homogenization treatment and furnace cooling, respectively. It is shown that the particles are refined from 3 mm to less than 10 μm after hammering the two alloys but there are still metastable phases. This means that the phase constituents of the two alloys have no changes by the deformation, which is different from that by balling. The phase constituents are not changed at room temperature by hammering, which is dependent on the deformation mechanism of hammering.     

军队医院网络信息系统的安全分析

随着网络技术在医院的应用,其安全性日益受到重视。首先结合军队医院信息系统网络应用的特点,从硬件系统、软件系统、环境因素、人为因素等方面分析该网络系统的安全性;最后研究该网络系统安全可能造成的威胁,并提出安全应对措施。     

基于OCTEON芯片的高精度流回放系统的设计与实现

介绍网络多核处理器OCTEON和基于OCTEON开发的基本需求,讨论在Linux平台下基于该芯片开发高精度流回放系统的设计与实现过程,包括主机与OCTEON间PCI的通信,高精度流回放的时间戳实现,以及多个流同时回放的设计与实现。对该系统的性能测试表明,基于OCTEON的流回放实现高度并行并且高精度的处理,系统的实现对于在高速Gbps环境下的网络数据流检测、过滤与入侵检测系统具有很高的应用价值。     

基于多Agent的世博会交通疏导决策支持系统

分析世博会交通概况,把多Agent技术引入到决策支持系统中来,给出了世博会交通疏导决策的框架,以及该系统的决策模型,使之能够更好地对交通进行决策管理,为2010年将在上海举行的世博会提供参考.     

基于嵌入式系统的虚拟存储示波器设计与实现

嵌入式系统的发展和普及应用使得在嵌入式系统平台下设计虚拟仪器成为构建仪器系统的新思路。本文提出了使用AD7864与ARM S3C2410构成数据采集系统的方案,设计了AD7864与S3C2410的接口电路;并在此硬件基础上开发了虚拟存储示波器,实现了示波器的功能。     

资源管理系统中基于作业检查点的自动容错

本文提出了在资源管理系统中基于作业检查点实现自动容错支持,深入分析了作业与任务检查点分离、映像文件管理、自动恢复执行等关键技术。基于BLCR在SLURM中实现了作业的自动检查点/恢复,详细介绍了实现中的关键技术难题。分析与测试表明,检查点与恢复执行功能正确,并能有效缩短大规模作业成功运行所需的时间。