Parameter evaluation in automated digital deep-level transientspectroscopy (DLTS)

A method of directly evaluating the activation energy ΔE, capture cross section σ, and density N_T, of deep-level traps from the pulsed reverse bias capacitance transient is described. The main advantages of this technique are that it requires only a single temperature scan, and it can resolve nonexponential transients due to closely-spaced energy levels. The test samples used for this paper consisted of Schottky diodes fabricated on nonirradiated and 1-MeV electron-irradiated n-type VPE (vapor-phase epitaxy) GaAs wafers. The well known EL2 trap was identified with ΔE of 0.81 eV, and σ _n of 1.0×10^-13 cm² for the nonirradiated sample. These values were found to be in good agreement with published data using established, conventional DLTS techniques. For the irradiated samples a nonexponential capacitance transient was found in the EL2 range of temperatures. The discussed technique was able to resolve two closely spaced deep levels lying at E_c-0.81 eV and E_c-0.84 eV, and with capture cross sections of 1.5×10^-13 cm² and 2.5×10^-12 cm², respectively     

马来酸及其酐和衣康酸与PP熔体接枝反应机理的研究

以马来酸酐作对照，用热分析、流变、化学分析等方法，研究了马来酸和衣康酸在非隔氧条件下与ＰＰ熔体催化接枝反应的特点和规律，阐述了单体结构－单元反应相对速率－－接枝产物结构之间的关系，提出了３种接枝物的结构模型。     

A newly robust controller design for the position control ofpermanent-magnet synchronous motor

A robust controller which is designed by employing variable-structure control and linear-quadratic method is presented for a permanent-magnet synchronous motor (PMSM) position control system. It is to achieve accurate control performance in the presence of plant parameter variation and load disturbance. In addition, it possesses the design flexibility of the conventional state feedback control. It is applied to the position control of a PMSM. Simulation and experimental results show that the proposed approach gives a better position response and is robust to parameter variations and load disturbance     

Resonant snubber-based soft-switching inverters for electricpropulsion drives

This paper summarizes recently developed soft-switching inverters and proposes two possible options for electric propulsion motor drive applications. The newly developed soft-switching inverter employs an auxiliary switch and a resonant inductor per phase to produce a zero voltage across the main switch, so that the main switch can turn-on at the zero-voltage condition. Both the auxiliary switch and the resonant inductor are operating at a fractional duty and, thus, are small in size as compared to the main inverter circuit components. Operation modes in a complete zero-voltage switching cycle for the single-phase soft-switching inverter are described in detail, with graphical explanations. The circuit operation was first verified by a computer simulation, and then further tested with a 1 kW single-phase and a 100 kW three-phase inverter. Both simulation and experimental results are presented to show the superior performance in efficiency improvement, EMI reduction and dv/dt reduction of the proposed soft-switching inverters     

催化裂化装置中大型波纹管膨胀节失效分析

对某石化公司催化裂化装置中泄漏的大型波纹管膨胀节进行了失效分析.结果表明,应力腐蚀是该膨胀节失效的主要原因,而局部的点蚀和残余应力、工作应力是应力腐蚀的必要条件.     

Non-contact flood discharge measurements using an X-band pulse radar (I) theory

This article describes a non-contact method for measuring surface velocity and discharge in a natural channel. The X-band pulse (9.36 GHz) radar, developed by the Applied Physics Laboratory of the University of Washington, was used to scan instantaneously the lateral distribution of surface velocity across a river section, according to Bragg scattering from short waves produced by turbulent boils on the surface of the river. Based on the assumption that the vertical velocity distribution follows a universal power or logarithmic law, the discharges were estimated.     

SNCP环带链的组网与维护

在实际传输网络结构中,有些站点由于条件限制不能与其它站点连接成环.过去采用通道保护(PP)环带链组网,环链网元间业务在环上没有保护;随着技术的发展,提出了子网连接保护(SNCP)环带链组网方式,确保环链网元间业务在环上得到保护,使网络的稳定性和可靠性大大提高.     

一种确定高窄带滤光片峰值波长的方法

本文介绍一种主动式高窄带滤光片峰值波长的测量方法。该方法可以有效的测量出窄带滤光片的敏感波长，而不需要太复杂的设备。通过染料激光谐振腔的模式竞争，可以测量出滤光片的透射或反射波的波长。