含钡合金的生产及其对钢液脱氧行为的研究

介绍了含钡合金的生产状况。在MoSi2炉上对钢管钢进行了含钡合金脱氧行为的研究，然后在150tLF／VD精炼设备上进行了使用含钡合金的工业试验。研究中主要选取SiAlBa、SiCaBa、SiAlBaCa、SiAlBaCaSr及用于钙处理的SiCa包芯线，并选用Al和FeSiAl作为对比脱氧剂，分别考察了实验室条件下和实际生产过程中，采用钡系合金对钢液脱氧的全氧含量，脱氧产物的分布、尺寸和形貌，探讨了钡系合金脱氧和对夹杂物的变质作用的机理。     

吉林闹枝金矿床黄铁矿的标型特征研究

从成因矿物学及找矿矿物学的观点出发，系统地研究了闹枝金矿床黄铁矿的形态、粒度、化学成分、热电性、硫同位素方面的标型特征，为矿床的成因研究和深部远景评价提供了矿物学依据。     

A novel optical burst switching scheme—logical cascaded private subnet with start wavelength assignment policy

Many recent studies have convincingly demonstrated that network traffic exhibits a noticeable self-similar nature, which has a considerable impact on network performance, and most studies of optical burst switching (OBS) networks are under a fundamental assumption that full wavelength conversion is available throughout the network. In practice, however, economic and technical considerations are likely to dictate a more limited and sparse deployment of wavelength converters in the optical network. Therefore, we present a novel scheme for OBS networks, called logical cascaded private subnet (LCPN) with start wavelength assignment policy. We define the concept of canoe relative to cluster in self-similar traffic, and introduce a new device named payload segregator at the edge node as a gateway to the core node in OBS Networks. According to the changes in the edge node framework, we put forward the concept of cluster private subnet and canoe private subnet in the core node correspondingly. A new start wavelength assignment policy is proposed for the absence of (full) wavelength conversion capabilities in the core node of OBS Networks. The performance study indicates that, our new scheme is robust under self-similar traffic and wavelength continuity constraint.     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.     

DSP在声频谱测井仪器中的应用

声频谱仪器是一种新型的数控全波列测井仪，采用DSP作为它的控制核心器件，以便实现对整个仪器的工作状态、数据采集及传输的控制，是声频谱测井仪器的核心部分。文章主要介绍DSP的芯片结构和性能、ADSP-2101在声频谱仪器控制系统中的功能及实现、声频谱仪器现场采集的接收全波列波形和结论。     

板载电源模块--开放式与封闭式的选择

目前,分布式电源架构被广泛用于通信和计算设备中,该电源架构经常采用板载电源(BMP)模块,在尽可能靠近负载点的地方进行电源变换.     

基于极限平衡理论定量评价井壁稳定性

井壁稳定性的准确评价对优化井身结构、优选完井方式、提高固井质量、提高测井解释精度等具有极其重要的指导意义。井壁稳定归根结底是井周应力状态与地层岩石强度的平衡关系问题。基于极限平衡理论从受力与材料强度两方面出发,应用统一处理平衡方程与破坏准则,分析了井周的应力分布,得出在与原水平最大主应力方向夹角为90°和270°处,井壁最易坍塌;夹角为0°和180°处,井壁最易破裂。进而提出了井壁的坍塌评价系数Sc和破裂评价系数Sf,当Sc=1或Sf=1时,井壁处于极限平衡状态;当Sc>1、Sf>1时,井壁稳定,且值越大,井壁越稳定。井壁坍塌评价系数和破裂评价系数为评价井壁稳定性提供了定量指标。     

脉冲电镀最佳参数之探索和优化

本文利用正交实验法对脉冲电镀各控制参数进行试验,对影响分散能力、镀层可靠性及外观质量的各种因素进行探讨,寻找影响外观质量的显著因子并加以控制,同时进一步优化脉冲电镀的工艺参数。     

辐射剂量对环氧树脂电子束固化行为的影响

分析了电子束剂量对环氧树脂体系辐射固化行为的影响规律。研究结果表明，电子束辐射过程中，温度由树脂辐射体系表面向内部逐渐降低，随着辐射剂量提高，树脂体系温度上升，辐射表面与内部的温度梯度加大，高辐射剂量下的温度变化缓慢。树脂辐射固化层厚度以及在相同厚度的固化程度均随辐射剂量增加，但增幅逐渐变小，树脂辐射固化度沿固化深度会加速下降。     

Integrated magnetic full wave converter with flexible output inductor

A new integrated magnetic full wave DC/DC power converter that provides flexible transformer design by incorporating an independent output inductor winding is introduced. The transformer is implemented on a traditional three-leg magnetic core. The inductor winding can be separately designed to control the output current ripple. The cross-sectional area of the inductor core leg can be reduced dramatically. The operation and performance of the proposed circuit are verified on a 100 W prototype converter.