Effects of Mg/Si Ratio on Microwave Dielectric Characteristics of Forsterite Ceramics

Nonstoichiometric Mg₂SiO₄ forsterite dielectric ceramics with various Mg/Si ratios ( R =2.025, 2.05, and 2.2) were prepared and characterized. The appearance of a MgSiO₃ secondary phase could be effectively suppressed by adjusting the nonstoichiometry, and a single-phase forsterite structure was obtained in the present ceramics with Mg/Si ratios of 2.025 and 2.05. The microwave dielectric characteristics were significantly improved in the nonstoichiometric Mg₂SiO₄ ceramics on eliminating the MgSiO₃ secondary phase, where an enhanced Q × f value and a suppressed temperature coefficient of resonant frequency λ _f were obtained. The best microwave characteristics were achieved in the nonstoichiometric forsterite ceramics with an Mg/Si ratio of 2.05: ɛ _r =7.5, Q × f =114 730 GHz, and λ _f =−59 ppm/°C.     

应用炉膛压力诊断气流床气化炉的火焰状态

气化炉是煤气化技术中的关键设备 .气化炉内火焰燃烧稳定性下降 ,会出现燃烧噪音增加、气化燃烧效率降低及熄火等现象 ,对安全性和经济性产生严重的影响 .对气流床气化炉内不同气化燃烧状态下的火焰压力信号进行了小波分析 .结果表明 ,压力信号在一定频段内的分布与气化炉内火焰燃烧的状态密切相关 ,发现随着火焰燃烧稳定性加强 ,气化炉内压力信号向高频方向移动 ,以此可以建立气流床气化炉燃烧诊断模型 .     

脲类杀菌剂戊菌隆的合成

以对氯氯苄为原料，先与六甲基次胺进行胺化反应制得对氯苄胺；然后在Raney Ni催化剂存在下。在高压釜中与环戊酮进行缩合反应，同时加氢还原，得到N-对氯苄基-N-环戊胺；最后N-对氯苄基-N-环戊胺与苯基异氰酸酯在50℃的甲苯溶液中缩合，处理后得到戊菌隆。产品戊菌隆含量95％，以对氯氯苄计总收率67．3％。     

压出过程中胎面胶流动特性的研究

应用Monsanto加工性能试验机(MPT)对胎面胶进行压出流变试验。在实验条件下,考察试样熔体的流动特性及其影响因素,并作初步的分析和讨论。实验发现,试样的流动曲线可近似用指数方程描述;而熔体粘度对温度的依赖性则大体上符合Arrhenius方程。     

The role of the WO x ad-component to Pt and PtRu catalysts in the electrochemical CH3OH oxidation reaction

High surface area carbon-supported platinum-based catalysts, Pt/C, PtWO _x /C, PtRu/C and PtRuWO _x /C, were prepared via a chemical reduction route using single metal precursor salts. The catalyst particles were found to be in the nanoscale range, and the addition of Ru clearly decreased the particle size. The Ru was found to be partially incorporated into the face centered cubic lattice of Pt and to form a single Ru catalyst component. X-ray diffraction and X-ray photon spectroscopy did not provide evidence for electronic interactions between WO _x and Pt as well as WO _x and Ru. However, the addition of tungsten to the PtRuWO _x /C catalyst resulted in a high degree of catalyst particle agglomeration. Both Ru containing catalysts showed significantly higher activities for the CH₃OH oxidation reaction in terms of Pt + Ru mass as well as electroactive Pt + Ru surface area than the Pt/C and PtWO _x /C catalysts. The addition of tungsten appeared to mainly result in some ‘physical’ modification of the catalytically active Pt and Ru surface components such as differences in electroactive surface area rather than promotion of the CH₃OH oxidation reaction via a true catalytic mechanism.     

Possible use of methylbenzenes as electrolyte additives for improving the overcharge tolerances of Li-ion batteries

Based on the voltammetric behaviour of a series of methyl-substituted benzenes in 1M LiPF₆/EC-DMC electrolyte, xylene was selected and tested as an electrolyte additive for overcharge protection of Li-ion batteries. From the overcharge curves, CV behaviour and SEM observations of the cells in the presence of xylene, it was found that the additive can polymerize at the overcharged voltage to form a dense layer of isolating polymer film at the cathode surface, which blocks off further oxidation of the electroactive material and electrolyte and, therefore, improves the overcharge tolerance of the Li-ion battery. In addition, the xylene additive has shown only a slight influence on the cycling behaviour.     

浆态床中合成二甲醚的研究

考察了浆态床中3种甲醇合成催化剂反应行为,考察了温度、压力、催化剂比例和种类对二甲醚合成的影响.结果表明,低压下甲醇合成催化剂中C30l活性最好,温度降低和压力升高有利于甲醇的合成.二甲醚合成中,不同脱水催化剂反应性能不同.在考察范围内,温度升高,CO转化率变化不大,二甲醚的选择性增加;压力升高,CO转化率和二甲醚选择性都随之升高;两种催化剂(C301Hβ)的质量比为41时,CO转化率和二甲醚选择性最高.     

加气混凝土砌块生产新工艺

对现行的加气混凝土砌块切割工艺进行改革,提高了产品成品率。     

能有效抑制碱集料反应的复合矿物掺合料

研究了在80℃养护条件下，掺加复合矿物掺合料对含沸石化珍珠岩集料砂浆碱一集料反应膨胀的影响。研究发现．混凝土中复合矿物掺合料掺量为25％和40％时，可以有效抑制碱硅酸反应，且40％掺量时抑制作用更强。     

深水表层钻井随钻压力与温度监测装置设计

深水表层钻井随钻压力与温度监测装置是监测深水表层钻井过程中井底当量循环密度（ECD）和循环温度的重要工具。通过深水表层钻井随钻压力与温度监测装置,现场技术人员可以实时掌握井下环空压力、钻柱内压和温度等工程参数,进而了解和分析井下工况,为深水表层钻井作业和动态压井钻井技术提供指导。设计的深水表层钻井随钻压力与温度监测装置以ARM为核心,利用数据采集技术和通信技术,实现了随钻压力与温度的采集传输。完成的深水表层钻井随钻压力与温度监测装置具有体积小、功耗低、抗振动和抗高温和低温的优点。监测装置已经在我国南海第一口深水井LW6—1—1井的领眼井中成功进行应用试验,验证了其在深水无隔水管钻井条件下的机械强度、稳定性、可靠性,测量得的数据能真实反映钻井工况。