Crystallization and thermoelectric behavior of conductive-filler-filled poly(ε-caprolactone)/poly(vinyl butyral)/montmorillonite nanocomposites

Crystallization and thermoelectric properties of poly(ε-caprolactone) (PCL)/poly(vinyl butyral) (PVB)/montmorillonite (MMT) nanocomposites containing carbon black (CB) have been studied as a functions of a small amount of amorphous PVB content and a wide range of molecular weight of PVB. X-ray diffraction data of PCL/PVB/MMT nanocomposites indicates most of the swellable silicate layers are exfoliated and randomly dispersed into PCL/PVB system. The band spacings of PCL spherulites in PCL/PVB/MMT nanocomposites decrease with increasing PVB content, and this indicates that increasing the PVB content greatly shortens the period of lamellar twisting. The presence of 1 wt% MMT and higher molecular weight of PVB also shorten the period of PCL lamellar twisting. Nucleation and crystallization parameters, such as growth rate G and Avrami exponent n, can be determined by using POM and DSC isothermally crystallized at 41 °C. For samples with the same CB content, the intensity of positive temperature coefficient (PTC) (I_PTC, defined as the ratio of peak resistivity to resistivity at room temperature) of the nanocomposites was increased as the content and the molecular weight of PVB increases. The change of the PTC property related to the morphological difference (i.e. period of lamellar twisting) in the nanocomposites can be discussed.     

硫酸铵-氯化亚锡-孔雀绿体系浮选分离铂

研究了在盐酸介质中硫酸铵存在下氯化亚锡—孔雀绿—水体系浮选分离铂的方法。在最佳实验条件下，铂的浮选率可达100．0％，并与常见贱金属完全分离。     

优化工艺指标提高盐水质量

介绍了通过优化工艺指标，如精确控制化盐温度、增加粗盐水的过碱量、减少助沉剂的投加量等提高了盐水质量并降低了生产成本。     

89-GHz fT room-temperature silicon MOSFETs

The authors report the implementation of deep-submicrometer Si MOSFETs that at room temperature have a unity-current-gain cutoff frequency (f_T) of 89 GHz, for a drain-to-source bias of 1.5 V, a gate-to-source bias of 1 V, a gate oxide thickness of 40 Å, and a channel length of 0.15 μm. The fabrication procedure is mostly conventional, except for the e-beam defined gates. The speed performance is achieved through an intrinsic transit time of only 1.8 ps across the active device region     

试谈高炉冷却壁的检漏及维护

高炉冷却壁的检漏及维护，是炼铁工作者十分关心的问题，本文针对邯钢高炉具体情况，探讨了高炉冷却壁漏水的原因，检漏方法，漏水冷却壁的维护及预防措施。     

用φ20mm离心萃取器两步法制取高纯钇

本文研究了中钇富镧稀土的氧化物溶液在环烷酸中的萃取行为，测定了镧钇组成、温度变化与分离系数的关系；在Ｐ＿（５０７）体系中研究了ｐＨ值与分配比的关系；提出用环烷酸、Ｐ＿（５０７）两种萃取剂制备高纯钇的工艺流程。用８４台φ２０ｍｍ离心萃取器进行了一个月的台架试验，结果证明两种萃取剂有很好的互补性，在满足钇的纯度要求下有较高收率。离心萃取器具有易分相、体系存留量少、液流密闭性好等优点，它更适宜于粘度大、级数多、产品纯度要求高的体系。     

1.48μm掺饵光纤放大器泵源

采用Ｐ型ＩｎＰ衬底新月型结构制备了１．４８μｍ大功率激光器，该激光器与单模光纤耦合输出功率大于４０ｍＷ。     

流动微量量热法研究阴离子表面活性剂在油砂表面的吸附

用流动微量量热法研究了十二烷基硫酸钠(SDDS)和十二碳羧酸钠(SL)在克拉玛依油田九区和乌尔禾区油砂上的吸附,简要地计论了吸附机理。所得实验结果表明,SL 在油砂上的吸附强度比 SDDS 的要大,在相当低的浓度下即可迟到饱和吸附。     

糖化酶制剂辐照性能研究

研究了工业糖化酶制剂经辐照处理后各项性能的变化。结果表明,经2kGy以下剂量的γ射线处理后,可提高其贮存稳定性,改善卫生品质,不影响其正常使用。     

Non-steady-state model for kinetics of free radical polymerization, 4. Direct thermal initiation

This paper deals with the non-steady-state kinetics of direct thermal initiated polymerization. The initiation is assumed to be a bimolecular reaction of the monomer. The relationship between the radical concentration and the monomer conversion is rigorously derived. In further treatment a few very close approximations are introduced based on the fact that the number of monomer molecules reacting in the initiation step is much less than that consumed in the propagation step for a process producing high polymer, and the value of the rate constant for propagation or chain transfer is much lower than that for chain termination. Expressions for various molecular parameters, such as molecular weight distribution, number-average and weight-average degrees of polymerization, and dispersity, are given. Several numerical examples are provided.