Robust nonlinear feedback–feedforward control of a coupled kinetic Monte Carlo–finite difference simulation

Robust nonlinear feedforward–feedback controllers are designed for a multiscale system that dynamically couples kinetic Monte Carlo (KMC) and finite difference (FD) simulation codes. The coupled codes simulate the copper electrodeposition process for manufacturing on-chip copper interconnects in electronic devices. The control objective is to regulate the current density subject to the condition that the steady-state fluctuation of the overpotential remains bounded within ±0.01 V. The controller designs incorporate a low-order stochastic model that captures the input–output behavior of the coupled KMC–FD code. The controllers achieve the objectives and the closed-loop responses implemented on the low-order model and the coupled KMC–FD code match well within stochastic variations. The nonlinear feedforward control reduces the rise time of the controller response while the feedback control ensures robustness in the presence of model uncertainty.     

大牛地气田气井无阻流量的确定方法研究

大牛地气田气井试井大多采用一点法，由于气层渗透性差，测试时间短，流压很难达到稳定，计算的无阻流量往往偏高，且无法获得正确的产能方程。通过气田多口井修正等时试井数据进行统计分析，获得了一点法试井在不同生产时间下计算无阻流量的经验公式；利用气田修正等时试井的二项式方程系数曰，计算惯性阻力系数并经过曲线回归处理获得了经验关系式，很好地解决了一点法试井计算产能方程的问题。     

施工过程中腐蚀隐患的控制

通过分析石化装置施工过程中常见的现象,分析产生由这些现象加重腐蚀的原因和机理, 指出应加强施工过程中的控制,而达到预期的防腐蚀效果,消除腐蚀隐患。     

含硫化氢气井钻井过程中的腐蚀因素与防护研究

在含硫气井的钻井过程中对于HRC大于22的钻具钢材除了腐蚀疲劳之外，在pH值小于9的环境中会发生硫化物应力腐蚀破裂，这种破坏比腐蚀疲劳更突然、更快，使钻杆大量损坏。含硫气井在钻井过程中，由于湿硫化氢的出现，常常会出现油管、套管、钻井设备、钻井仪器以及对支持保护管柱的水泥环柱等腐蚀和损坏问题，为此，阐述了湿硫化氢的腐蚀特点、机理，归纳总结了影响腐蚀的因素，综述了如何在这些方面防止其腐蚀，使损失减小，为指导油管、套管防腐工程实践提供了依据。建议在钻井过程中采用碱性钻井液，其pH值可到9或更高(至pH值12)，以减缓或防止钻井过程中电化学从硫化物应力腐蚀破裂；含硫气井用的钻杆应该间歇使用。钻杆停用堆置时间可使其放氢，使钻杆恢复韧性，防止硫化物应力腐蚀断裂。     

科技进步五十年

通过回顾企业五十年的发展历程,阐述了科学技术在企业发展中发挥的重要作用.充分体现了科学技术是第一生产力.     

基于"层"模式的双机容错系统

容错技术广泛应用于各个行业来保证系统的冗余和可靠性。文章在分析比较当前的双机容错系统的性能优缺点后,提出了一种全新的基于“层”模式的双机容错系统解决方案。按照这种模式,可以从链路层到应用层构建一个通用的系统级的双机容错系统。文章对其实现的关键技术进行了阐述。     

Uplink Scheduling in CDMA Packet-Data Systems

Uplink scheduling in wireless systems is gaining importance due to arising uplink intensive data services (ftp, image uploads etc.), which could be hampered by the currently in-built asymmetry in favor of the downlink. In this work, we propose and study algorithms for efficient uplink packet-data scheduling in a CDMA cell. The algorithms attempt to maximize system throughput under transmit power limitations on the mobiles assuming instantaneous knowledge of user queues and channels. However no channel statistics or traffic characterization is necessary. Apart from increasing throughput, the algorithms also improve fairness of service among users, hence reducing chances of buffer overflows for poorly located users. The major observation arising from our analysis is that it is advantageous on the uplink to schedule “strong” users one-at-a-time, and “weak” users in larger groups. This contrasts with the downlink where one-at-a-time transmission for all users has shown to be the preferred mode in much previous work. Based on the optimal schedules, we propose less complex and more practical approximate methods, both of which offer significant performance improvement compared to one-at-a-time transmission, and the widely acclaimed Proportional Fair (PF) algorithm, in simulations. When queue content cannot be fed back, we propose a simple modification of PF, Uplink PF (UPF), that offers similar improvement. Hereafter, we refer to users with low recieved power at the base even when transmitting at peak transmit power as “weak” users, and the strongly recieved users at the base as “strong” users. Krishnan Kumaran is currently a member of the Complex Systems Modeling section in the Corporate Strategic Research of ExxonMobil Corp., Clinton, NJ. Formerly, he was a Member of Technical Staff in the Mathematics of Networks and Systems Research Department at Bell Labs in Murray Hill, NJ, where his research interests were in modeling, analysis and simulation of design, resource management and scheduling issues in telecommunication networks. Lijun Qian is an assistant professor in the Department of Electrical Engineering at Prairie View A&M University. He received his B.S. from Tsinghua University in Beijing, M.S. from Technion-Israel Institute of Technology, and Ph.D. from WINLAB, Rutgers University, all in electrical engineering. Before joining PVAMU, he was a researcher at Networks and Systems Research Department of Bell Labs in Murray Hill, NJ. His major research interests are in wireless communications and networking technologies, especially in radio resource management, protocol design, TCP/RLP optimization and MPLS traffic engineering.     

Iterative detection/decoding for two-track partial response channels

In this letter, we investigate the iterative detection/decoding algorithms for two-track partial response channels. We first describe the iterative algorithm as an iterative message-passing/processing algorithm over a high-level normal graph and then propose two trellis-based detection algorithms. The natural one is based on a joint trellis, which can be implemented for low-order channels. For moderate-order channels, we propose a separated detection, which is based on two single-track trellises. Compared with the joint detection, the separated detection is simpler in most cases. Simulation results show that, for two-track EPR4 channels with minor intertrack interferences, the separated detection causes only marginal degradation in performance.     

DSP--数字化时代的基因芯片

DSP是当今发展最为迅速的和最有发展前景的技术之一。与普通CPU和MCU相比 ,DSP在数字信号处理方面有着无可比拟的优势 ,特别适合网络、通信、控制等需要进行大量数字信号处理的应用场合。今天DSP已经成为通信、计算机、网络、工业控制以及家用电器等电子产品中不可或缺的基础器件 ,DSP在通信、计算机、网络、工业控制以及消费类电子产品等领域有着非常广泛的应用 ,本文阐述了DSP的特点、应用和市场以及DSP技术的发展前景。