A wavelet-based procedure for process fault detection

To detect faults in a time-dependent process, we apply a discrete wavelet transform (DWT) to several independently replicated data sets generated by that process. The DWT can capture irregular data patterns such as sharp "jumps" better than the Fourier transform and standard statistical procedures without adding much computational complexity. Our wavelet coefficient selection method effectively balances model parsimony against data reconstruction error. The few selected wavelet coefficients serve as the "reduced-size" data set to facilitate an efficient decision-making method in situations with potentially large-volume data sets. We develop a general procedure to detect process faults based on differences between the reduced-size data sets obtained from the nominal (in-control) process and from a new instance of the target process that must be tested for an out-of-control condition. The distribution of the test statistic is constructed first using normal distribution theory and then with a new resampling procedure called "reversed jackknifing" that does not require any restrictive distributional assumptions. A Monte Carlo study demonstrates the effectiveness of these procedures. Our methods successfully detect process faults for quadrupole mass spectrometry samples collected from a rapid thermal chemical vapor deposition process     

热带城市垃圾典型组分的热解特性研究

对热带城市垃圾的几种典型组分进行了热解实验，得到了它们的失重曲线，通过对失重曲线进行分析，得到了这几种典型组分的热解规律，并通过建立热解动力学模型，求出了其中两种组分的活化能E和频率因子A。     

超高相对分子质量聚乙烯纤维研究进展

介绍了超高分子质量聚乙烯纤维的制备、表面改性及应用的研究进展 ,指出了今后超高分子质量聚乙烯纤维的研究及应用的发展方向     

Iterative receivers for space-time block-coded OFDM systems indispersive fading channels

We consider the design of iterative receivers for space-time block-coded orthogonal frequency-division multiplexing (STBC-OFDM) systems in unknown wireless dispersive fading channels, with or without outer channel coding. First, we propose a maximum-likelihood (ML) receiver for STBC-OFDM systems based on the expectation-maximization (EM) algorithm. By assuming that the fading processes remain constant over the duration of one STBC code word and by exploiting the orthogonality property of the STBC as well as the OFDM modulation, we show that the EM-based receiver has a very low computational complexity and that the initialization of the EM receiver is based on the linear minimum mean square error (MMSE) channel estimate for both the pilot and the data transmission. Since the actual fading processes may vary within one STBC code word, we also analyze the effect of a modeling mismatch on the receiver performance and show both analytically and through simulations that the performance degradation due to such a mismatch is negligible for practical Doppler frequencies. We further propose a turbo receiver based on the maximum a posteriori-EM algorithm for STBC-OFDM systems with outer channel coding. Compared with the previous noniterative receiver employing a decision-directed linear channel estimator, the iterative receivers proposed here significantly improve the receiver performance and can approach the ML performance in typical wireless channels with very fast fading, at a reasonable computational complexity well suited for real-time implementations     

利用闲置设备生产均三甲苯的探索

介绍了利用闲置设备工业化生产均三甲苯的方法,并从理论上研究了生产的可行性。探讨了提高均三甲苯产品纯度和收率的途径。     

提高综合勘测实力开拓岩土工程市场

随着西北勘测设计研究院（以下简称西北院）勘测总队所承担的黄河龙￣青段、白龙江流域等河段前期综合勘测工作的相继结束，拥有２０００多名职工的勘测队伍面临着何去何从的重大选择。在此转折关头，勘测总队面对现实，审时度势，抓住机遇，开拓前进，及时转轨变型，制定了本单位发展的战略和方向，使勘测总队由单一勘测业务转变为集勘测与岩土工程施工为一身的新型综合队伍。几年来，经过全体职工的奋发努力，缍获得了１９９５年￣     

弱激发氩离子激光的振荡频率特性

通过改变激光器的相对激发,观察到了氩离子激光器振荡频率的演变特性。用模竞争效应对实验现象进行了理论解释。     

Studies on Catalytic Side-Chain Oxidation of Nitroaromatics to Aldehydes with Oxygen

The side-chain oxidation of 2-nitrotoluene in liquid phase in the presence of catalytic amount of manganese sulfate and stoichiometric amount of potassium hydroxide with oxygen was studied. In the most favorable conditions, over 80% of conversion of 2-nitrotoluene and 50% of selectivity to 2-nitrobenzaldehyde was achieved. Effects of the reaction parameters on the conversion of the reactant and the selectivity of the product were examined. These results, together with EPR spectroscopic study, show that a benzyl anion was formed in the early stage of the reaction, which was then converted to the final product via a free radical mechanism.