In-vitro iron dialysability from legumes: Influence of phytate and extrusion cooking

In-vitro iron dialysability from five Italian legumes (mottled bean, white bean, faba bean, chickpea, lentil) and the influence of phytate and extrusion cooking on it were evaluated. Iron dialysability was 2·3 and 2·4% in mottled and white bean respectively, 1·2% infaba bean, 2·7% in chickpea and 1·1% in lentil. After extrusion cooking the flours showed a marked iron contamination and a decrease in iron dialysability, but these changes were significant only for mottled bean. Enzymic phytate removal induced an increase in iron dialysability > 100% in all the raw legumes except mottled bean which showed an increase of only 57%. This finding indicates that, although phytate consistently modifies iron dialysability, it is difficult to identify a quantitative relationship between phytate content and iron dialysability.     

降雨衰减对移动卫星系统通信的影响及补偿

针对移动卫星系统的特点，分析了降雨引起的信号衰减的原因，给出了雨衰的计算方法。Ka波段一般用于移动通信业务，从分析结果上看该波段信号受降雨影响较大。提出几种补偿雨衰的方法，给出了上行功率控制法的系统原理图。     

Seismic Physical Modeling Technology and Its Applications

1. Introduction Seismic physical modeling technology is an important method for the research on seismic exploration theory and methods. In seismic physical experiments, the earth, mantle or field site are scaled down to physical models according to the similarity principle, and then the seismic field and its variation are observed in the laboratory for the research work on the theories and methods of the earth structure, earthquake forecasting, energy and mineral resource exploration, and engi…     

Efficient Simulation of hybrid stripmap/spotlight SAR raw signals from extended scenes

The hybrid stripmap/spotlight mode for a synthetic aperture radar (SAR) system is able to generate microwave images with an azimuth resolution better than the one achieved in the stripmap mode and a ground coverage better than the one of the spotlight mode. In this paper, time- and frequency-domain-based procedures to simulate the raw signal in the hybrid stripmap/spotlight mode are presented and compared. We show that a two-dimensional Fourier domain approach, although highly desirable for its efficiency, is not viable. Accordingly, we propose a one-dimensional (1-D) range Fourier domain approach, followed by 1-D azimuth time-domain integration. This method is much more efficient than the time-domain one, so that extended scenes can be considered. In addition, it involves approximations usually acceptable in actual cases. Effectiveness of the simulation scheme is assessed by using numerical examples.     

浅析燕云十六州的战略价值

后晋天福三年(938年),"儿皇帝"石敬瑭"履约"向契丹割献燕云十六州.从此,中原王朝丧失了抵御北方游牧民族入侵的天然屏障,北方门户大开.宋代,燕云地区的争夺几乎贯穿了十至十二世纪北宋与辽金战争的整个过程.事实上,后人所指的"燕云十六州"与石敬瑭割辽的十六州在名称、时间和地域上有很大的差别;燕云地区内的险峻的山脉、横贯的河流与长城、五关一起构成了其巨大的军事价值;富庶的经济,众多的人口又构成了该地区巨大的经济价值;从历史上看,燕云十六州的归属于中原王朝和北方游牧民族政权双方而言,战略意义重大.     

The effect of support morphology on the reaction of oxidative dehydrogenation of ethane to ethylene at short contact times

The oxidative dehydrogenation of ethane is carried out in short contact time reactors over Pt and LaMnO₃ based catalysts supported on a large number of different ceramic substrates (45, 60 and 80 ppi foam monoliths and 200, 400, 600, 900 and 1200 cpsi honeycomb monoliths). Experimental results, obtained under the same conditions at varying the C₂H₆/O₂ ratio, showed that the highest performance in terms of ethylene selectivity and yield is always attained on LaMnO₃ catalysts. Furthermore, the results are significantly influenced by the morphology and cell density of the support, with 45 and 60 ppi foams and 400 and 600 cpsi honeycombs giving the best performance. The experimental results are explained by means of geometrical and fluid dynamic considerations on the support, and by means of a 2D mathematical model, which clearly indicates an optimal intermediate cell density for maximising ethylene selectivity and yield.     

水管理策略对土壤水盐动态和区域地下排水影响的模拟评价

以宁夏惠农灌区平罗试验区为对象，基于田间观测与灌溉试验结果，在田间尺度采用SWAP模型开展不同地下水调控深度与灌溉制度相结合的水管理方案下土壤水盐动态的模拟，在区域尺度采用MODFLOW模型进行不同水管理方案对区域地下排水量影响的模拟评价，据此分析土壤水盐动态过程和农田排水系统的作用，对拟定的各种水管理方案进行评价。结果表明，现状灌溉用水量虽有助于减少表土盐分积聚，但地下排水量占灌溉用水量的39．4％；现状灌溉用水量减少50％时，浅埋地下水位会加重表土积盐；现状灌溉用水量减少25％时，作物根区没有产生明显的积盐，地下排水量减少31．4％。因此，较为合理的水管理方案是将现状灌水量减少25％的同时将地下水埋深控制在70cm以下，才能达到节水、增产、改善农田水土环境的目标。     

Influence of Carrier Mobility and Interface Trap States on the Transfer and Output Characteristics of Organic Thin Film Transistors

We have used two dimensional drift diffusion simulations to calculate the electrical properties of bottom contact pentacene based organic thin film transistor, taking into account field-dependent mobility and interface or bulk trap states. In order to derive from basic principles the transport properties of the organic semiconductor we have developed a Monte Carlo simulator to calculate the field dependent mobility. We analyzed the presence of trap states at the interface between organic material and gate insulator and we show the influence of trap states combined with the effect of field-dependent mobility on the transfer characteristic. Numerical calculations are also reported for the output characteristics of the device showing a very good agreement with the available experimental results.     

Development of calibration models for quality control in the production of ethylene/propylene copolymers by FTIR spectroscopy,multivariate statistical tools,and artificial neural networks

Principal component regression (PCR), partial least squares (PLS), StepWise ordinary least squares regression (OLS), and back‐propagation artificial neural network (BP‐ANN) are applied here for the determination of the propylene concentration of a set of 83 production samples of ethylene–propylene copolymers from their infrared spectra. The set of available samples was split into (a) a training set, for models calculation; (b) a test set, for selecting the correct number of latent variables in PCR and PLS and the end point of the training phase of BP‐ANN; (c) a production set, for evaluating the predictive ability of the models. The predictive ability of the models is thus evaluated by genuine predictions. The model obtained by StepWise OLS turned out to be the best one, both in fitting and prediction. The study of the breakdown number of samples to be included in the training set showed that at least 52 experiments are necessary to build a reliable and predictive calibration model. It can be concluded that FTIR spectroscopy and OLS can be properly employed for monitoring the synthesis or the final product of ethylene–propylene copolymers, by predicting the concentration of propylene directly along the process line. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Synthesis and characterization of novel copolymer containing pyridylazo-2-naphthoxyl group via reversible addition–fragmentation chain transfer (RAFT) polymerization

A novel monomer containing pyridylazo-2-naphthoxyl group, 1-(1-(4-vinylbenzyloxy)naphthalen-2-yl)-2-(pyridin-2-yl)diazene (VBNPA), was successfully synthesized and copolymerized with styrene (St) in N,N-dimethyl formamide (DMF) via reversible addition–fragmentation chain transfer (RAFT) polymerization using 2-cyanoprop-2-yl-1-dithionaphthalate (CPDN) as RAFT agent. The polymerization behavior exhibited “living”/controlled characters. The obtained copolymer, poly(St-co-VBNPA), with pre-determinable molecular weight and narrow molecular weight distribution can be used as a carrier in metal ion detection and analysis via pre-concentration technique. The copolymer–metal ion (copper (Cu) and europium (Eu)) complexes were prepared and characterized.