An investigation of seated postural stability

Results of tests undertaken to identify which measures of seated posture control are most effective in two areas, distinguishing differences in the x and y direction control strategies for a given task and distinguishing differences in overall control strategies for pairs of different tasks, are presented. The test platform, calibration tests, test protocol, and data analysis method are described. The results of statistical analyses performed on the data are summarized     

Gain control in reflex pathways

Summary form only given. A series of experiments was undertaken to determine the gain of the stretch reflex in decerebrate cats. Stretches are applied through a servo-controlled motor that receives length and velocity feedback which are adjusted so that it behaves like a spring of a particular stiffness. As the stiffness decreases the gain of the reflex increases until the stiffness is made much less than the intrinsic muscle stiffness. Under these conditions small brief pulses can elicit shortening of 1 mm or more and reflex forces that are larger than the force produced by the stretch itself. This suggests that the gain in the reflex is 1 or more at low frequencies. It is concluded that muscle control systems are adaptive and time-varying to accomplish the various tasks required by the organism. Although under some conditions the reflex gain is on the order of one, measurement of gain is compounded by a number of nonlinearities, and the value of these nonlinearities in various tasks remains to be determined     

An electrical network approach to the analysis of semiconductordevices

A simple electrical network is used to represent the five differential equations describing basic phenomena in one-dimensional semiconductor devices. Both standard and integrated approaches for solving transport equations are developed. Also, an electrical network equivalent for the nonlinear Poisson equation was derived. It allows students to better understand the physical phenomena and the process of computer simulation of such semiconductor devices     

On the geometry of parallel impedances

A geometrical construction for the equivalent (sinusoidal) impedance of two impedances connected in parallel is presented. The special case of two resistors connected in parallel is reviewed     

Work-site smoking policies: their population impact in Washington State

This article presents data from a population-based, random-digit dialing telephone survey of 1228 employed adults in Washington State, conducted 1989 through 1990. Eighty-one percent of men and 91% of women reported work-site smoking restrictions. Employees in work sites with no-smoking policies were less likely to be current smokers; men in work sites with policies restricting smoking smoked fewer cigarettes on both workdays and nonworkdays. Forty-eight percent of male and 53% of female smokers reported reduced smoking as a result of work-site policy. Work-site smoking policies, intended to protect against smoke exposure, may also reduce employee smoking.     

A 56 mm twin aperture model dipole magnet for the large hadroncollider

A 56 mm twin aperture model dipole magnet for the large hadron collider has been built at CERN. The magnet design incorporates stainless steel collars and a special yoke structure to minimize saturation-induced field errors. The magnet has proved to be the most successful model prototype constructed so far. In the tests the design field of 10.0 Tesla was achieved with a record-short training. In this paper, the quench performance and the electromagnetic behavior of the magnet are presented and discussed     

Heading towards an advanced signalling system for multimedia,multiparty services in broadband ISDN

Introduction of the broadband integrated services digital network (B-ISDN) will enable network users to make use of advanced multimedia, multiparty services. With this aim in view, RACE II project R2044, MAGIC, is investigating long-term signalling requirements, architecture and protocols for B-ISDN. New service concepts are being developed in MAGIC which will provide more flexibility when compared to narrowband ISDN (N-ISDN). The service requirements and other signalling requirements, such as the separation between call and associated connections at the network-node interface, are used to determine the distribution of functions over the network. The signalling protocols which are used to exchange the signalling information are subsequently developed. These signalling protocols are simulated to prove the performance and the feasibility of call handling concepts