Improvement of RCA transistor using RTA annealing after theformation of interfacial oxide

A polysilicon emitter RCA transistor (an ultra-thin interfacial oxide layer exists between polysilicon and silicon emitter) is presented which can operate at 77 K for the first time. An ultra-thin (1.5 nm) interfacial oxide layer is grown deliberately between polysilicon and silicon emitter using RCA oxidation and excellent device stability is obtained after rapid thermal annealing (RTA) treatment in nitrogen atmosphere. The RCA transistor exhibits good electrical performance at very low temperature for an emitter area of 3 × 8 μm². The maximum toggle frequency of a 1:2 static divider is 1.2 GHz and 732 MHz at 300 K and 77 K, respectively     

液压集成块校核软件的编制和应用

本文叙述了液压集成块校核软件的编制思想和方法，并重点介绍了编制过程中所使用的相关技术，同时给出部分源程序。     

氨气提工艺尿素生产中操作的改进

中原大化集团公司尿素装置在操作上使用的是Ｓｎａｍ公司提供的尿素操作手册 ,在运行过程中 ,发现有许多地方与实际状况出入很大 ,经过不断的总结经验 ,并在工艺操作中进行改进、优化 ,使装置达到安全、稳定、经济运行的目的。1　二氧化碳压缩机操作方式的改进二氧化碳压缩机自开车以来 ,防喘振系统一直未投用。由于Ｓｎａｍ公司提供的防喘振曲线富裕度较大 ,操作人员对实际喘振点不清楚 ,正常生产中转速控制较高 ,操作盲目性很大 ,在 1 0 0 %负荷下 ,防喘振阀仍有 1 0 %左右的开度 ,造成蒸气消耗偏高。1 999- 0 3- 31 ,对二氧化碳压缩机各…     

双时基频率校准电路

提供精确的时间基准是精密仪器和高精度设备计时和工作的关键技术之一。文中采用两套晶振电路，通过分频产生高频和低频两个频率信号，采用编码的方法对两个频率信号在每一个时钟周期内进行动态校核，只有两个晶振的频率在允许的精度范围内，或同时增大（缩小）相同的倍数，校核后频率信号才是正确的，且能给系统提供精确的时间基准。该方法能有效防止系统的时钟周期因意外的原因伸长或缩短。整个电路可以作为精密仪器或高精度设备的一个模块电路。     

轧机主传动万向联轴器辊端接头结构探讨

分析了衬板槽平面与叉头十字轴孔轴线的相对位置对辊端接头应力的影响 ,研究了轧辊扁头与衬板之间间隙所产生的冲击和应力集中 ,讨论了辊端接头中部过渡段结构对应力分布和制造质量的影响。提出辊端接头结构设计的优化方案     

减压渣油与FCC油浆共炭化的化学组成变化

考察了齐鲁石化胜利炼油厂催化油浆（FCC）和胜利减压渣油（VR）在490℃，0.8MPa下不同混合比的原料和不同反应时间的中间产物的HS、TS、PS、P及其1h中间产物的HS和TS的^1H-NMR。数据结果反映了体系的反应速度。掺入FCC油浆抑制了VR的反应活性，降低了体系的反应速度，增加了基质的溶解度；1h中间产物的组成结构更接近于原料及反应体系的反应性和基质的溶解度；1h中间产物的芳香度越高，取代基越少，侧链越短，基质对VR中的活性反应组分在炭化早期生成的高度缩合物质的溶解度越大。     

健康住宅正在走近我们

人类居住健康的问题越来越受到全世界居住者和舆论的关注.长期以来人类过于不当的城市建设行为,人口的过于集中,城市建筑的高层化倾向,过分的人造环境造成土地失水性严重、热岛现象衍生.城市作为人类居住生活的功能区,在很大程度上被削弱,居住条件恶化、环境受到污染.让城市功能朝着人居、健康的目标发展,包括生理和心理的、社会的和人文的、近期的和长期的多层次的健康,是我们今天的历史责任.     

A new efficient method for one‐pot conversions of aryl carboxylic acids into nitriles without solvent

A new efficient method for synthesising nitriles, important organic reagents, is reported in this paper. In an environmentally benign solvent‐free system, aryl carboxylic acids were converted into the corresponding nitriles via one‐pot reactions, by amidation with ethyl carbamate followed by dehydration with thionyl chloride, in excellent yields. The results showed that the method has the advantages of lower cost, higher yield, less pollution and greater ease of work‐up. Copyright © 2008 Society of Chemical Industry     

Influence of ethyl methacrylate content on the volume‐phase transition of temperature‐sensitive poly[(N‐isopropylacrylamide)‐co‐(ethyl methacrylate)] microgels

A novel series of temperature‐sensitive poly[(N‐isopropylacrylamide)‐co‐(ethyl methacrylate)] (p(NIPAM‐co‐EMA)) microgels was prepared by the surfactant‐free radical polymerization of N‐isopropylacrylamide (NIPAM) with ethyl methacrylate (EMA). The shape, size dispersity and volume‐phase transition behavior of the microgels were investigated by transmission electron microscopy (TEM), ultraviolet–visible (UV–Vis) spectroscopy, dynamic light scattering (DLS) and differential scanning calorimetry (DSC). The transmission electron micrographs and DLS results showed that microgels with narrow distributions were prepared. It was shown from UV–Vis, DLS and DSC measurements that the volume‐phase transition temperature (VPTT) of the p(NIPAM‐co‐EMA) microgels decreased with increasing incorporation of EMA, but the temperature‐sensitivity was impaired when more EMA was incorporated, causing the volume‐phase transition of the microgels to become more continuous. It is noteworthy that incorporation of moderate amounts of EMA could not only lower the VPTT but also enhance the temperature‐sensitivity of the microgels. The reason for this phenomenon could be attributed to changes in the complicated interactions between the various molecules. Copyright © 2004 Society of Chemical Industry