Optical dot gain on newsprint determined with the Lund nuclear microprobe

A technique for measuring optical dot gain, i.e. the relative difference between the actual screen dot and the optically perceived one, is presented. By combining measurements from the non-optical nuclear microprobe with data from image analyzing technique the optical dot gain can be determined. The procedure to reach pixel by pixel correlation on a micrometer scale is discussed. In the newsprint sample studied in this investigation a typical optical dot gain between 15 and 20% was deduced. The variation in the optical dot gain was correlated with other characteristic parameters of the print and newsprint and especially a positive correlation to the mass density of the newsprint was observed.     

FRACTURE ASSESSMENT FOR SECONDARY LOADS

The fracture assessment of structures subjected to secondary loading systems was studied by FEM-analysis of a few illustrative two-dimensional examples. The first example is an edge-cracked plate with a thermal gradient. The FEM-calculations revealed that a purely elastic analysis yielded J-values that are in most cases considerably more conservative than the ones calculated from an elastic-plastic analysis. The results were further compared with different engineering type non-linear estimates. As a second example a crack emanating from a semi-circular notch in a rectangular plate was chosen. The plate was subjected to uniaxial tension along its boundaries. It turned out that for the cases considered the J-values were fairly close to those elastically predicted.     

An overview of the Telecommunications Information NetworkingArchitecture

The Telecommunications Information Networking Architecture (TINA) Consortium is an international collaboration aiming at defining and validating an open architecture for telecommunication services for the broadband, multimedia, and information era. The architecture is based on distributed computing, object orientation, and other concepts and standards from the telecommunications and computing industries. This paper provides an introduction to TINA. First, it presents an overall view of TINA, followed by a brief introduction to the main parts of the architecture, namely the computing, network, service, and management architectures. This is followed by a brief overview of interworking and migration scenarios for legacy systems. Finally, an overview of a tool-set to aid service specification and design is presented     

Comparison of demineralized allogeneic bone matrix grafting (the Urist procedure) and the Ilizarov procedure in large diaphyseal defects in sheep

The bone inductive capability of the Urist and Ilizarov procedures was compared in the repair of large diaphyseal defects in sheep. In 30 animals, a 4 cm segmental defect was created in the middle portion of the right femur and was stabilized with an external fixator. The sheep were divided into four groups according to the type of reconstruction of the defect. In group 1, a demineralized allogeneic bone matrix (DABM) cylinder was used; in group 2, DABM chips; and in group 3, gradual transport of a piece of bone detached from the proximal femoral fragment was used to fill the defect. Group 4 served as a control (the defect was left empty). New bone formation was assessed by serial radiographs until the time of death at 2 or 4 months. Postmortem specimens were analyzed with respect to bone mineral content, uptake of isotopes (45Ca and 3H-proline), and histology. The first signs of new bone formation were radiographically evident at 4 weeks. In the two groups in which reconstruction involved DABM (Urist procedures), new bone failed to form in eight of the 13 animals. Full bridging of the defect was observed at 8 weeks in one animal with a DABM cylinder and two with DABM chips. No decisive difference in bone yield could be demonstrated between the two Urist procedures. In the group treated with the Ilizarov procedure, new bone formation consistently occurred at a high rate; full bridging of the defect was observed in seven of the eight animals. Bone mineral scanning and histologic analysis essentially confirmed the radiographic results. Uptake of isotopes was selectively analyzed in two sheep from each experimental group in which new bone formation was exhibited in the defect; new bone formation was increased compared with that in the contralateral femur but was equal among the three experimental groups. Our study shows that gradual transport of a detached piece of autogeneic bone (Ilizarov procedure) is more effective than implantation of DABM (Urist procedure) in eliciting new bone formation in large diaphyseal defects in sheep. The variable bone induction by DABM may be explained by differences in host immune responses to the implants.     

Probabilistic cell modelling of cleavage fracture

Various aspects on probabilistic modelling of cleavage fracture are discussed. The investigation involves consideration of a unit cell with an explicitly modelled void. The results from this model are compared with results for the case when the void content is accounted for in the sense of a Gurson-Tvergaard law. It is found that explicit modelling of the void can give substantially different results for the fracture probability. The effect depends on the exponent in the assumed Weibull distribution, the threshold stress, the constraint conditions and the hardening of the material. This revised version was published online in August 2006 with corrections to the Cover Date.     

The transient response technique for the study of hydrocarbon oxidation on metal oxides: Simulation of the responses for various propene oxidation mechanisms

Partial differential equations, describing the consumption of reactants and the formation of products, have been solved numerically for a step change from inert to reactant feed considering different variants of propene oxidation mechanisms. The response features and their dependency on the rate limiting step have been rationalised in terms of conclusions, which can serve as general guidelines for mechanistic interpretation of experimental transients from hydrocarbon oxidation over metal oxides. Though the response pattern is characteristic of the rate limiting step, it is demonstrated that different variants of mechanisms can give identical response features. In that case complementary investigation with other techniques, or more detailed mathematical analysis is necessary.     

795 nm and 1064 nm dual pump thulium-doped tellurite fibre for S-band amplification

Gain measurement in thulium-doped tellurite fibre is demonstrated with a maximum internal gain of 7 dB at 1480 nm. An improvement in gain by a factor of 2 is achieved using a 795 nm and 1064 nm dual pump scheme. Gain in tellurite fibres extends to longer wavelength than in fluorides, showing improved overlap with the C-band EDFA.