Electrochemical examination of the ascorbic acid radical anion in non-aqueous electrolytes

A quasi-reversible redox reaction involving ascorbic acid was observed in non-aqueous electrolytes at conductive diamond electrode. The chemical reversibility of these reactions is consistent with ascorbic acid being reduced to the ascorbic acid radical anion in a one-electron process, with subsequent reoxidation to ascorbic acid. This is the first report on the electrochemical production of the ascorbic acid radical anion in non-aqueous electrolytes. Ascorbyl 6-stearate and 4-hydroxy 2(5H)-furanone, which have somewhat similar structures as ascorbic acid, also showed one-electron transfer reduction reaction producing radicals with a single negative charge, suggesting that these compounds follow the same electrochemical behavior as ascorbic acid. The double bond and hydroxyl substituent on the five-membered ring are shown to be necessary for the stabilization of the radical anions. It was confirmed by the calculation of the total energy using molecular orbital methods that resonance structures involving the double-bond and hydroxyl group provide significant stabilization of the radical anions. Electrochemical preparation may be a useful method for the detailed study of radicals, their molecular structure and reactivity.     

The effects of Ni and Li doping on the performance of lithium manganese oxide material for lithium secondary batteries

Layered Li_0.7[M_1/6Mn_5/6]O₂ (M=Li, Ni) was synthesized using a sol-gel method. P2-Na_0.7[M_1/6Mn_5/6]O₂ precursor was first synthesized by a sol-gel method, and then O2-Li_0.7[M_1/6Mn_5/6]O₂ was prepared by an ion exchange of Li for Na in P2-Na_0.7[M_1/6Mn_5/6]O₂ precursor. From charge/discharge curves, it was seen that Li_0.7[Li_1/6Mn_5/6]O₂ has two plateaus similar to those observed from a spinel structure, but Li_0.7[Ni_1/6Mn_5/6]O₂ holds a single plateau as observed from a typical layered structure. It was considered that Li_0.7[Li_1/6Mn_5/6]O₂ undergoes a phase transformation from layered to spinel structure during the charge/discharge cycle, but Li_0.7[Ni_1/6Mn_5/6]O₂ maintains O2-layered structure after the cycles. Li_0.7[Ni_1/6Mn_5/6]O₂ was higher in discharge capacity and retention rate than Li_0.7[Li_1/6Mn_5/6]O₂.     

Alteration of substrate specificity of cholesterol oxidase from Streptomyces sp. by site-directed mutagenesis

Despite the structural similarities between cholesterol oxidasefrom Streptomyces and that from Brevibacterium, both enzymesexhibit different characteristics, such as catalytic activity,optimum pH and temperature. In attempts to define the molecularbasis of differences in catalytic activity or stability, substitutionsat six amino acid residues were introduced into cholesteroloxidase using site-directed mutagenesis of its gene. The aminoacid substitutions chosen were based on structural comparisonsof cholesterol oxidases from Streptomyces and Brevibacterium.Seven mutant enzymes were constructed with the following aminoacid substitutions: L117P, L119A, L119F, V145Q, Q286R, P357Nand S379T. All the mutant enzymes exhibited activity with theexception of that with the L117P mutation. The resulting V145Qmutant enzyme has low activities for all substrates examinedand the S379T mutant enzyme showed markedly altered substratespecificity compared with the wild-type enzyme. To evaluatethe role of V145 and S379 residues in the reaction, mutantswith two additional substitutions in V145 and four in S379 wereconstructed. The mutant enzymes created by the replacement ofV145 by Asp and Glu had much lower catalytic efficiency forcholesterol and pregnenolone as substrates than the wild-typeenzyme. From previous studies and this study, the V145 residueseems to be important for the stability and substrate bindingof the cholesterol oxidase. In contrast, the catalytic efficiencies(k_cat/K_m) of the S379T mutant enzyme for cholesterol and pregnenolonewere 1.8- and 6.0-fold higher, respectively, than those of thewild-type enzyme. The enhanced catalytic efficiency of the S379Tmutant enzyme for pregnenolone was due to a slightly high k_catvalue and a low K_m value. These findings will provide severalideas for the design of more powerful enzymes that can be appliedto clinical determination of serum cholesterol levels and assterol probes.     

Knoop Microhardness Anisotropy and the Indentation Size Effect on the Basal Plane of Single-Crystal Alumina (Sapphire)

The Knoop microhardness anisotropy profile was determined for the basal plane of a Czochralski grown alumina single crystal for indentation test loads from 100 through 1000 g. Microhardness maxima occur at low indentation test loads for the long axis of the Knoop indenter parallel to the 〈2[Onemacr][Onemacr]0〉. Minima exist for the long axis parallel to the 〈10[Onemacr]0〉. This low indentation test load profile is attributed to slip on the primary slip system, the (0001)〈[Onemacr][Onemacr]20〉, as previously noted by Brookes and co-workers. The degree of the microhardness anisotropy decreases for higher indentation test loads. This results from the activation of multiple slip systems to accommodate the greater amounts of plastic flow required by the larger indentation sizes. The microhardness profile becomes more uniform with increasing indentation test load until the Knoop microhardness approaches a test-load-independent, orientation-independent microhardness of 1167 ± 34 kg/mm². The indentation size effect (ISE) was further investigated through lubricated indentation hardness measurements. Lubrication of the test specimen surface significantly reduces the ISE. Results indicate that friction between the test specimen surface and the indenter facets is a major portion of the ISE.     

采用MAMMOS技术的高密度光记录

MAMMOS(Magnetic Amplifying Magneto－ Optical System:磁畴扩大磁光系统 )是实现高密度磁光盘的有效方法。不仅能得到不依赖于磁畴长度的较大的读出信号振幅,而且还能实现超出光学系统衍射极限的分辨率。过去,为实现磁畴的复印与扩大,要对记录膜面施加垂直方向的外部磁场。而现在得知,同时施加垂直磁场和水平方向的磁场,可大幅度地提高微小磁畴的读出特性。确认采用施加水平磁场的方法,在λ =635 nm, NA=0.55的条件下, 0.15μ m的连续磁畴也能获得 BER=2× 10－ 4的读出效果。     

Construction of an expression system of insect lysozyme lacking thermal stability: the effect of selection of signal sequence on level of expression in the Pichia pastoris expression system

Expression systems of human and silkworm lysozymes were constructedusing the methylotrophic yeast Pichia pastoris as a host. Theleader sequence and its prepro peptide of     

Chemical‐Free Approach for Z‐Isomerization of Lycopene in Tomato Powder: Hot Air and Superheated Steam Heating above the Melting Point of Lycopene

Z‐isomers of lycopene exhibit higher bioavailability and antioxidant capacity than those of the all‐E‐isomer. Therefore, it is important to develop an efficient and environmentally friendly procedure for Z‐isomerization. The current methods for Z‐isomerization of (all‐E)‐lycopene use toxic chemicals such as organic solvents and catalysts. This study is aimed to develop a chemical‐free method for Z‐isomerization of (all‐E)‐lycopene in tomato powder by hot air and superheated steam heating. The Z‐isomerization reaction is promoted by heating above the melting point of lycopene. When heated with superheated steam, the thermal decomposition of lycopene is suppressed compared to that when heated with hot air. When tomato powder is heated at 240 °C for 5 min by superheated steam, the total Z‐isomer content and remaining lycopene are 69.0% and 90.7%, respectively, while with hot air heating, the total Z‐isomer content and remaining lycopene are 69.9% and 68.0%, respectively. These results indicate that the thermal Z‐isomerization of lycopene occurs in the molten state and heating in a low oxygen atmosphere suppresses the thermal decomposition of lycopene. Practical Applications: Tomato powder rich in lycopene Z‐isomers is an important ingredient for the food and animal feed industries. Since Z‐isomers of lycopene are more soluble in solvents including ethanol which is a low‐toxicity and environmentally friendly solvent, the efficiency of lycopene extraction with ethanol can be improved by using the Z‐isomer‐rich tomato powder as a raw material. The obtained Z‐isomer‐rich extract has a high added value because the Z‐isomers have higher bioavailability and antioxidant capacity than those of the all‐E‐isomer. In addition, since lycopene Z‐isomers exhibit higher accumulation efficiency and better color improvement in hen egg yolks than those of the all‐E‐isomer, Z‐isomer‐rich tomato powder is an effective animal feed.     

Hydrogen and carbon dioxide adsorption with tetra‐n‐butyl ammonium semi‐clathrate hydrates for gas separations

Gas adsorption rates of H₂, CO₂, and H₂‐CO₂ gas mixture (H₂/CO₂ = 3.4) with tetra‐n‐butyl ammonium salt (bromide, chloride, and fluoride) semi‐clathrate hydrate particles were measured at 269 K to assess their properties for gas separation. Equilibrium gas occupancies in the S‐cages of the particles were in order of (high to low) for hexagonal structure‐I, tetragonal structure‐I, and superlattice of cubic structure‐I structures with the maximum fractional occupancy by CO₂ being about 40%. The CO₂ diffusion rate depended on the anion size of the salt, which is attributed to distortion of the S‐cage that is close to the molecular size of CO₂. Simulations of semi‐clathrate hydrate particles with theory showed that H₂/CO₂ selectivities could be as high as 36 (3.0 mol% TBAF) and that selectivities for an ideal membrane (3.3 mol% TBAF) could be >100 (269 K, 0.3–4.5 MPa). Semi‐clathrate hydrates have wide application as separation media for gas mixtures. © 2014 American Institute of Chemical Engineers AIChE J, 61: 992–1003, 2015     

High tensile strength fiber of poly[(R)‐3‐hydroxybutyrate‐co‐(R)‐3‐hydroxyhexanoate] processed by two‐step drawing with intermediate annealing

High tensile strength fibers of poly[(R)‐3‐hydroxybutyrate‐co‐(R)‐3‐hydroxyhexanoate] [P(3HB‐co‐3HH)], a type of microbial polyesters, were processed by one‐step and two‐step cold‐drawn method with intermediate annealing. Thermal degradation behaviors were characterized by differential scanning calorimeter and gel permeation chromatography measurements. Thermal analyses were revealed that molecular weights decreased drastically within melting time at a few minute. One‐step cold‐drawn fiber with drawing ratio of 10 showed tensile strength of 281 MPa, while tensile strength of as‐spun fiber was 78 MPa. When two‐step drawing was applied for P(3HB‐co‐3HH) fibers, the tensile strength was led to 420 MPa. Furthermore, the optimization of intermediate annealing condition leads to enhance the tensile strength at 552 MPa of P(3HB‐co‐3HH) fiber. Wide‐angel X‐ray diffraction measurements of these fibers suggest that the fibers with high tensile strength include much amount of the planer‐zigzag conformation (β‐form) as molecular conformation together with 2₁ helix conformation (α‐form). © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015 , 132, 41258.