Rapid Quenching Technique Using Thermal-Image Furnace for Glass Preparation

A new technique combining a thermal-image furnace and a twin roller is described for quenching the melt to form glass. The technique was applied to the simple system Li₂O-SiO₂, since its fundamental parameters in the estimation of critical cooling rate are available. Glass flakes were obtained in the composition Li₄SiO₄, for which a very large critical cooling rate (∼10⁹ K·s⁻¹) was needed for glass formation.     

Effect of perchloric acid on the molecular weight and yield of poly-THF

Polytetramethylene glycol (molecular weight range 1000–8000) was prepared by the polymerization of tetrahydrofuran (THF) using a binary catalyst system of fuming sulfuric acid and perchloric acid. When 28% fuming sulfuric acid alone was used as the catalyst, the average molecular weight of polymer was low, the maximum value being 1000–1100. By the combination of fuming sulfuric acid with a small amount of perchloric acid, the average molecular weight of the polymer was increased to about 8000. Furthermore, the molecular weight was readily controlled in the range of 1000 to 8000 by varying the amount of the binary catalyst.     

Charged ultrafiltration membrane for permeation of proteins

Polyacrylonitrile-g-poly(N,N-dimethylaminoethyl methacrylate) was synthesized photochemically and quaternized. The positively charged membranes made from the quaternized graftcopolymer showed high ultrafiltration rate for water by adding poly(vinyl alcohol) to casting solution and washing it out after the casting. In buffered saline solution, the permeability of the membranes was very small at pH below isoelectric point of albumin but increased markedly at higher pH. On the other hand, the permeability for γ-globulin was very small and did not show any pH dependence.     

Computer-aided reaction system synthesis based on structured process energy-exergy-flow diagram

A computerized thermodynamics-oriented procedure for reaction system synthesis is proposed. First, hierarchy structure of chemical reactions is discussed and the reaction system is categorized into three types; (1) combination with a heat source or sink, (2) combination with a reaction donor, and (3) decomposition of target reaction into subtargets. Then, the algorithm to find subtarget reactions and/or donor reactions is presented.     

Performance of solvothermally prepared Ga2O3-Al2O3 catalysts for SCR of NO with methane

The solvothermal reaction of mixtures of aluminum isopropoxide (AIP) and gallium acetylacetonate (Ga(acac)₃) directly yielded the mixed oxides of γ-Ga₂O₃-Al₂O₃. In the solvothermal synthesis, the crystal structure of mixed oxides was controlled by the initial formation of γ-Ga₂O₃ nuclei. The mixed oxides prepared in diethylenetriamine have extremely high activities for selective catalytic reduction (SCR) of NO with methane as a reducing agent. With increasing crystallite size of the spinel structure, the catalytic activity increased. The ratio of the amount of methane consumed by combustion to total methane conversion was proportional to the density of acid sites on the surface of the mixed oxides. The mixed oxide catalysts prepared in diethylenetriamine had lower densities of acid sites and showed a higher methane-efficiency for CH₄-SCR than those prepared in other solvents. These catalysts maintained their high activity even when the reaction was carried out under the severe conditions (i.e., high space velocity and low NO concentration).     

Iodine reaction of vinyl acetate/vinyl propionate copolymers. III. Iodine affinities of the radically polymerized copolymers and the copolymers derived from partially saponified polyvinyl acetate

The minimum sequence lengths (n_c) of vinyl acetate (VAc) units necessary to form a colored iodine complex were determined to be 4 and 17 for radically polymerized VAc/vinyl propionate (VPr) and VAc/isopropenyl acetate (IPAc) copolymers, respectively. The iodine affinities (I/VAc) of VAc/VPr copolymers (SP-series) obtained by propionylation of partially saponified polyvinyl acetate (PVAc) were remarkably affected by the saponification conditions. An increase of the water content in acetone/water mixture as saponification solvent brought about a decrease of the iodine affinities of the SP-series. The dependence of the iodine affinity on the saponification of monomer units in the SP-series was compared with that in the radically polymerized VAc/VPr copolymers by taking the sequence probability as the measure of monomer unit distribution. The results strongly supported an occurence of the slide fastener reaction at high degrees of saponification, which was well-known in the saponification of PVAc. Furthermore, it was found that the saponification mode of PVAc at low degrees of saponification was influenced uniquely by the water content in saponification solvents and the saponification temperature.     

Novel method of preparing Ag–Hg alloy on polyacrylamide films and their structure

A novel method is proposed of preparing thin Ag–Hg alloy on PAAm film surface at room temperature: The film of interest is formed by holding PAAm aqueous solution with AgNO₃ in Hg-saturated atmosphere. Two kinds of films, one of which is a conductor and the other an insulator, can be selectively formed with pH-controlled PAAm solution by ammonia. The conducting surface is assigned to the α phase of Ag–Hg alloy by means of X-ray analysis. Potentiometric titration and IR spectral studies suggest the existence of PAAm–Ag⁺ complexes. On the basis of their structure and the oxidation and reduction potential of Ag⁺ and Hg²⁺, the mechanism of film formation is also discussed.     

Temperature Dependence of KIC for High-Pressure Hot-Pressed Si3N4 Without Additives

Temperature dependence of K_IC values for Si₃N₄ bodies sintered at high pressures without additives was studied from room temperature to 1400°C. Little change in K_K was found in this range.     

DNA recognition by a {beta}-sheet

DNA recognition by a ß-sheet is discussed in the lightof crystal structures of the MetJ and Arc repressors. The DNAbinding geometry of a ß-sheet can be understood interms of (i) close fitting of the two surfaces and (ii) matchingof residue and base positions. A ß-sheet is not entirelyflat but has a curvature. A ß-sheet of the Met-Arcfamily faces the DNA major groove with its convex surface; thelocal DNA major groove is deepest at the centre. The ß-sheetfollows 6 bp; every two residues face the DNA and the firstand fifth residues, which are separated by 13.2 Å, bind,respectively, to the third and sixth bases, which are separatedby 13.5 Å, on the same DNA strand.     

Balanced corpus of contemporary written Japanese

The balanced corpus of contemporary written Japanese (BCCWJ) is Japan’s first 100 million words balanced corpus. It consists of three subcorpora (publication subcorpus, library subcorpus, and special-purpose subcorpus) and covers a wide range of text registers including books in general, magazines, newspapers, governmental white papers, best-selling books, an internet bulletin-board, a blog, school textbooks, minutes of the national diet, publicity newsletters of local governments, laws, and poetry verses. A random sampling technique is utilized whenever possible in order to maximize the representativeness of the corpus. The corpus is annotated in terms of dual POS analysis, document structure, and bibliographical information. The BCCWJ is currently accessible in three different ways including Chunagon a web-based interface to the dual POS analysis data. Lastly, results of some pilot evaluation of the corpus with respect to the textual diversity are reported. The analyses include POS distribution, word-class distribution, entropy of orthography, sentence length, and variation of the adjective predicate. High textual diversity is observed in all these analyses.