Study of polarization phenomena in Schottky CdTe diodes using infrared light illumination

Schottky CdTe diode detectors suffer from a polarization phenomenon, which is characterized by degradation of the spectral properties over time following exposure to high bias voltage. This is considered attributable to charge accumulation at deep acceptor levels. A Schottky CdTe diode was illuminated with an infrared light for a certain period during a bias operation, and two opposite behaviors emerged. The detector showed a recovery when illuminated after the bias-induced polarization had completely progressed. Conversely, when the detector was illuminated before the emergence of bias-induced polarization, the degradation of the spectral properties was accelerated. Interpretation of these effects and discussion on the energy level of deep acceptors are presented.     

Optical-fibre network system for air-pollution monitoring over a wide area by optical absorption method

A low-loss optical-fibre network system for monitoring air pollution and species concentrations in various environments utilising the differential absorption method is proposed and discussed as a sensitive and economical as well as nonhazardous method. Its feasibility and advantages are also described on the basis of the present state of the art of the relevant technology.     

Node pacing for small optical RAM-buffered packet-switching networks

One of the difficulties with optical packet switched (OPS) networks is buffering optical packets in the network. The only available solution that can currently be used for buffering in the optical domain is using long fiber lines called fiber delay lines (FDLs), which have severe limitations. Moreover, the research on optical RAM presently being done is not expected to achieve a large capacity soon. However, the burstiness of Internet traffic causes high packet drop rates and low utilization in very small buffered OPS networks. We therefore propose a new node-based pacing algorithm for decreasing burstiness. We show that by applying some simple pacing at the edge or core backbone nodes, the performance of very small optical RAM buffered core OPS networks with variable-length packets can be notably increased.     

Multimodal sensing and active continuous closed‐loop feedback for achieving reliable manipulation in the outdoor physical world

The use of field robots can greatly decrease the amount of time, effort, and associated risk compared to if human workers were to carryout certain tasks such as disaster response. However, transportability and reliability remain two main issues for most current robot systems. To address the issue of transportability, we have developed a lightweight modularizable platform named AeroArm. To address the issue of reliability, we utilize a multimodal sensing approach, combining the use of multiple sensors and sensor types, and the use of different detection algorithms, as well as active continuous closed‐loop feedback to accurately estimate the state of the robot with respect to the environment. We used Challenge 2 of the 2017 Mohammed Bin Zayed International Robotics Competition as an example outdoor manipulation task, demonstrating the capabilities of our robot system and approach in achieving reliable performance in the fields, and ranked fifth place internationally in the competition.     

Pipe Heating System with Underground Water Tank for Snow Thawing and Ice Prevention on Roads and Bridge Decks

In order to prevent traffic accidents on snow-covered bridge decks, the writers developed a new pipe heating system that uses only groundwater stored in a large underground tank. The underground tank provides geothermal energy, i.e., groundwater of constant temperature, through heating pipes embedded in concrete pavements with no electric heater or fuel boiler. The pipe heating system was constructed at approximately 50% of the cost of comparable systems. In addition, there is a reduction of 10% in operating costs compared with the previous system. The present paper outlines its design and construction and provides fundamental data for the developed system. The piped heating system has kept the road conditions safe during the winter season by always removing the snow and ice from the heated road and bridge sections earlier than the surrounding roads. According to long-term temperature measurements, this system has prevented the road temperature from decreasing below 0°C, even through nighttime and morning periods. This report presents the system as an economical and effective solution for snow thawing and ice prevention.     

各种引气剂以及抑泡剂对混凝土经时变化状态等的影响

众所周知,采用粉煤灰制备混凝土,因粉煤灰成分中含有未燃炭等微粒子,容易造成阴离子型引气剂吸附在这些微粒子上,导致含气量经时损失.同时在混凝土的制备、运输过程中,因受采用的材料、拌和状态等物理因素影响,还会发生含气量经时增加的现象.所以在制备、管理混凝土时,如何保证出机初期一定的含气量、缓解含气量的经时损失或经时增加,是一项极其关键的技术.本文将就采用能改善上述状态的引气剂、抑泡剂拌和混凝土,对混凝土的经时变化以及抗冻融性等特征产生的影响进行论述.     

Characterization of microstructural damage due to low-cycle fatigue by EBSD observation

Electron backscatter diffraction (EBSD) in conjunction with scanning electron microscopy was used to assess the damage due to cyclic or uniform strain. Samples of Type 316 stainless steel after fatigue and tensile tests were prepared for EBSD observation and the misorientation angle between neighboring points (local misorientation) was evaluated. It was shown that the local misorientation developed due to the cyclic and uniform strain and that its spatial distribution was not uniform. In fatigue samples, the area of large local misorientation tended to form clusters, whereas it localized to the grain boundaries in the tensile samples, and the magnitude of local misorientation and the degree of the localization increased with the strain amplitude. The degree of localization was quantified via statistical processing of the measured data. It was also shown that the source of damage (cyclic or uniform strain) and the loading direction could be deduced from the EBSD observations of the damaged sample.     

Preliminary spectrum shifter design for intermediate energy nuclear data benchmark experiments with DT neutrons

Integral benchmark experiments with DT neutrons are not always sufficient for nuclear data benchmarking in the MeV region, below 10 MeV. A neutron spectrum shifter, which will be placed between a sample and a DT neutron source, is effective to moderate DT neutrons incident to the sample. In order to estimate effects of the spectrum shifter, the ratio of the contribution of 14 MeV neutrons in the leakage neutron and gamma-ray spectra was calculated with MCNP-4C for an experimental configuration at FNS of JAEA, Japan. The calculations were carried out for a Li₂TiO₃ sample with a Be, D₂O, or ⁷LiD spectrum shifter. It was found out that the Be shifter was superior to others and the Be shifter was effective to decrease the contribution of 14 MeV neutrons especially for secondary gamma-ray spectrum measurements.