Examination of the role of oxygen in the photografting of methacrylic acid on a polyethylene film with a mixed solvent consisting of water and organic solvents

The photografting of methacrylic acid (MAA) on a linear low‐density polyethylene film (thickness = 30 μm) under air and nitrogen atmospheres was investigated at 60°C in mixed solvents consisting of water and an organic solvent, with xanthone as a photoinitiator. The organic solvents used were acetone, methanol, tetrahydrofuran, and dioxane. A maximum percentage of grafting occurred at a certain concentration of the organic solvent in the mixed solvent. This was observed for the systems under both air and nitrogen. The grafting reaction under air exhibited an induction period, but the rate of grafting after the period was greater than that under nitrogen. The formation of poly(ethylene peroxide)s by photoirradiation seemed to be a factor for the accelerated photografting under air. On the basis of attenuated total reflection infrared spectroscopy and scanning electron microscopy of the grafted film, the MAA‐grafted chains of the sample prepared under air tended to penetrate more deeply inside the film than those of the sample prepared under nitrogen. The resulting grafted films exhibited a pH‐responsive character: the grafted films shrank in an acidic medium but swelled in alkaline medium. This was evaluated from measurements of dimensional changes in the grafted films. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 992–998, 2003     

新型智能加速度传感器的设计

详细介绍了一种智能加速度传感器的具体实现方案.试验证明,该传感器性能稳定,具有测量精度高、价格较低、便携性好、灵活可靠的特点,克服了传统加速度传感器测量精度低,元器件精度要求较高,测试系统复杂昂贵,应用范围具有局限性的缺陷.它大大提高了加速度测量的自动化水平,具有重要的应用价值.     

国外有机硅树枝状化合物的应用进展

有机硅树枝状化合物是以Si-O、Si-C、Si-Si等键为骨架，具有三维立体结构类似于树枝形状的化合物。结合当今国外该领域的最新进展系统地介绍了国外有机硅树枝状化合物的最新应用。     

Low surface energy films based on partially fluorinated isocyanates: the effects of curing temperature

Self-stratification strategy can be used to prepare films in which both bulk and surface properties can be optimized. By using this approach, only a very small quantity of fluorinated species is needed to generate a surface with low surface energy. When cross-linking is involved during film formation, we are dealing with a competition behavior between the diffusion of fluorinated species and the formation of cross-linked network. In this study low surface energy polymeric films were prepared on the basis of partially fluorinated polyisocyanates, in combination with hydroxyl-end-capped three-armed solventless liquid oligoesters and modified hyperbranched polyesters. At a fluorine concentration of only 0.5 wt.%, contact angles of water and hexadecane can reach 120° and 80°, respectively. A surface energy as low as 10–15 mN/m can be obtained upon the addition of less than 1 wt.% of fluorine in the films. It was shown, from real time ATR-FTIR and contact angle measurements, that the curing temperatures demonstrated significant effects on the cross-linking rate as well as on the wettability of the films.     

纳米Fe2O3对镁铬耐火材料烧结及力学性能的影响

在镁铬耐火材料中添加纳米Fe2O3,研究了它对镁铬耐火材料烧结性能与常温力学性能的影响.结果发现,在相同的工艺条件下,加入1%(外加)的纳米Fe2O3即可使镁铬砖的烧成温度降低150℃左右,并在相同烧成温度下能使试样的常温抗折强度和耐压强度大幅度提高.分析认为,在镁铬耐火材料中添加少量纳米级Fe2O3,可促进MgO-FeO固溶体中Cr3+和Al3+含量的提高,增强镁铬砖的直接结合程度,从而提高其力学性能.     

长江口北支水道水沙特性分析

从实测资料出发,结合水流数值计算成果,对长江口北支水道的水流、泥沙和含盐度等资料进行分析,得出了北支水道的水沙特性,并分析了水沙变化与河床变化的相互关系.北支水道在1958年南通河段河势控制后,径流分流比逐年下降,并渐趋稳定于3%左右.北支水道受径流影响越来越小,主要受潮流作用.随着水沙特性的逐年变化,北支水道0 m以下槽蓄容量逐年减小,并渐趋稳定,北支上段为逐年淤积最快的区域.由此反过来影响了水沙条件的进一步变化,使北支上段平均潮差增加,北支的会潮点由崇头附近下移至青龙港附近.     

舰载光电探测作战使用与技术发展

高技术战争复杂的电磁环境对雷达等探测装备作战使用产生了一定影响,但又促进了光电探测技术的发展,弥补了雷达等探测能力的不足,从而满足了水面舰艇作战使用的需要.针对高技术战争的特点,叙述了舰载光电探测设备的作战使用,提出了光电探测技术的发展方向.     

制备方法对Ba2FeMoO6双钙钛矿磁性能的影响

采用湿化学法和固相反应制备了Ba2FeMoO6双钙钛矿化合物,对比研究了制备方法对其磁性能尤其是磁卡效应的影响.实验结果表明,湿化学法准备的样品具有较高的磁化强度,在居里温度附近磁化强度随温度的变化更加陡峭,因此具有较大的磁熵变值.     

Characterisation of plasticity-induced closure--crack flank contact force versus plastic enclave

This paper presents some results from a totally new and powerful fusion between automated, digital photoelastic techniques and mathematical analysis of a crack experiencing closure. In essence, real-time photoelastic stress field data is acquired and fitted to a Muskhelishvili complex potential model of a loaded crack experiencing closure. The fit entails optimisation of multiple variables via a memetic algorithm, which combines a genetic algorithm and a local search. From observations made in this work, it is proposed that the plastic enclave around a crack tip will shield the crack from the full influence of the applied stress field. Furthermore, the effects of this ‘back stress’ are overcome by the applied tensile load in a way that, often, cannot be readily correlated with crack contact length, wake contact force, or with compliance.     

双头螺栓失效分析

与汽车电机装配在一起的双头螺栓在拧紧后不久便发生断裂。采用扫描电镜、化学分析、金相检验等方法对失效件进行了检测，同时又进行了氢脆试验验证。结果表明，螺栓在进行表面酸洗及电镀时，氢向金属内部扩散和富集，当氢浓度达到一定临界值后，促使氢致裂纹的产生和扩展。在外应力的作用下，即出现氢脆现象导致螺栓断裂。