能实现高压输出的抽头电感升压稳压器

当您面对产生比可用电源电压更高的稳定电压任务时,可以考虑升压稳压器。虽然升压转换器在理论上能产生比其输入更高的几乎任何电压,但实际的考虑把输出限制为对其施加的电压的大约8倍。为了产生更高的电压,可考虑使用抽头电感升压拓扑结构。图1展示了某种转换器的实现,它把3V输入提高到了100Vdc。稳压器芯片的连接类似于传统升压转换器的连接,但为了达到很高的升压比,该设计使用了L1,即一个1:6匝数比的抽头电感。图2中的波形示出了输入电压、电源开关IC1输出端(5号引脚SW)的电压、整流二极管D1的阳极电压。如同任何升压电路一样,当IC1…     

Superposition Coding with Unequal Error Protection for the Uplink of Overloaded DS-CDMA System

The overloaded CDMA schemes exploited in direct sequence CDMA (DS-CDMA) systems are mainly to accommodate a greater number of users than the available spreading factor N. In this paper, a superposition coding CDMA (SPC-CDMA) with unequal error protection (UEP) is proposed as one of the overloaded CDMA schemes for the next generation mobile communication systems. It exploits the available power control in most base stations to adapt the transmitted power of active users in the uplink channel. In this scheme, the active users are divided into G groups and each group consists of K users. The K users share the same spreading sequence and are distinguished by different received power levels. At the receiver side, the system first performs despreading for group detection followed by multiuser receiver to estimate the K user signals in each group. It is shown through simulations that better performance are achieved compared to the conventional DS-CDMA and existing overloaded collaborative spreading CDMA (CS-CDMA) schemes, in additive white Gaussian noise (AWGN) and fading channels. Hence, the proposed scheme maximizes the system capacity K-fold compared to conventional DS-CDMA system without requiring extra spreading codes, with average signal to noise ratio (SNR) cost of only 1dB and 2 dB over AWGN and fading channels respectively at BER of 10^?3. On the other hand, for the same N, K and power constraints, SPC-CDMA scheme achieves twofold increase in data rate with 0.7 and 4 dB gains over AWGN and fading channels respectively, compared with overloaded CS-CDMA scheme in the same system capacity. In addition, the proposed scheme can also attain different levels of UEP for different users?? requirements by adjusting their fractions of transmitted powers.     

Analysis of etched long-period fibre grating and its response to external refractive index

Analytical formulas are presented for the first time to describe the shift in the resonance wavelength of a long-period fibre grating (LPFG) in response to etching of the fibre cladding or a change in the external refractive index. The accuracy of the formulas is confirmed by comparison with numerical simulations and experimental results. It is shown that the resonance wavelengths of an etched LPFG are more sensitive to the external refractive index than those of an unetched grating.     

Performance of ATM traffic in optical CDMA

An ATM transit switch is proposed based on direct sequence optical code division multiple access technique. No buffering is necessary to facilitate the switching. Code conversion is used instead to emulate the switching function. The switch not only provides asynchronous access to the users but also has a limited capability of dynamic bandwidth allocation. It is free from timing jitters and switching delay is significantly reduced. A look‐up table is employed in the switching and updated through network management functions. The switch provides a new approach to asynchronous cross‐connection in the ATM core network. The performance of the new switch is evaluated by a set of prime codes and modified prime codes. Copyright © 2001 John Wiley & Sons, Ltd.     

Calibrated single-plunge bipolar electrode array for mapping myocardial vector fields in three dimensions during high-voltage transthoracic defibrillation

Mapping of the myocardial scalar electric potential during defibrillation is normally performed with unipolar electrodes connected to voltage dividers and a global potential reference. Unfortunately, vector potential gradients that are calculated from these data tend to exhibit a high sensitivity to measurement errors. This paper presents a calibrated single-plunge bipolar electrode array (EA) that avoids the error sensitivity of unipolar electrodes. The EA is triaxial, uses a local potential reference, and simultaneously measures all three components of the myocardial electric field vector. An electrode spacing of approximately 500 microm allows the EA to be direct-coupled to high-input-impedance, isolated, differential amplifiers and eliminates the need for voltage dividers. Calibration is performed with an electrolytic tank in which an accurately measured, uniform electric field is produced. For each EA, unique calibration matrices are determined which transform potential difference readings from the EA to orthogonal components of the electric field vector. Elements of the matrices are evaluated by least squares multiple regression analysis of data recorded during rotation of the electric field. The design of the electrolytic tank and electrode holder allows the electric field vector to be rotated globally with respect to the electrode axes. The calibration technique corrects for both field perturbation by the plunge electrode body and deviations from orthogonality of the electrode axes. A unique feature of this technique is that it eliminates the need for mechanical measurement of the electrode spacing. During calibration, only angular settings and voltages are recorded. For this study, ten EAs were calibrated and their root-mean-square (rms) errors evaluated. The mean of the vector magnitude rms errors over the set of ten EAs was 0.40% and the standard deviation 0.07%. Calibrated EAs were also tested for multisite mapping in four dogs during high-voltage transthoracic shocks.     

Avalanche multiplication characteristics ofAl0.8Ga0.2As diodes

The avalanche multiplication characteristics of Al_0.8Ga _0.2As have been investigated in a series of p-i-n and n-i-p diodes with i-region widths, w, varying from 1 μm to 0.025 μm. The electron ionization coefficient, α, is found to be consistently higher than the hole ionization coefficient, β, over the entire range of electric fields investigated. By contrast with Al_xGa _1-xAs (x⩽0.6) a significant difference between the electron and hole initiated multiplication characteristics of very thin Al_0.8Ga_0.2As diodes (w=0.025 μm) was observed. Dead space effects in the diodes with w⩽0.1 μm were found to reduce the multiplication at low bias below the values predicted from bulk ionization coefficients. Effective α and β that are independent of w have been deduced from measurements and are able to reproduce accurately the multiplication characteristics of diodes with w⩾0.1 μm and breakdown voltages of all diodes with good accuracy. By performing a simple correction for the dead space, the multiplication characteristics of even thinner diodes were also predicted with reasonable accuracy     

DC and microwave noise transient behavior of InP/InGaAs doubleheterojunction bipolar transistor (DHBT) with polyimide passivation

DC and microwave noise transient behavior of InP/InGaAs double heterojunction bipolar transistor (DHBT) with polyimide passivation is reported in this paper for the first time. The base transient current is believed to be due to the change of surface potential near the base-emitter junction perimeter at the polyimide/emitter interface resulting from a decrease in the amount of trapped electrons in the polyimide. We also find that the surface potential on the sidewall of collector-emitter affected by the charge trapping and detrapping in polyimide may induce a parasitic polyimide field effect transistor along the surface of the base-collector junction which results in an excess collector transient current. These base and collector current transients result in associated transient of broadband shot noise. The time dependence of microwave noise figures due to the excess transients is also investigated. The better understanding of the mechanisms of the noise transient behavior of the InP HBT device is very useful to improve the device and circuit reliability     

Dual-window dual-bandwidth spectroscopic optical coherence tomography metric for qualitative scatterer size differentiation in tissues

This study investigates the autocorrelation bandwidths of dual-window (DW) optical coherence tomography (OCT) k-space scattering profile of different-sized microspheres and their correlation to scatterer size. A dual-bandwidth spectroscopic metric defined as the ratio of the 10% to 90% autocorrelation bandwidths is found to change monotonically with microsphere size and gives the best contrast enhancement for scatterer size differentiation in the resulting spectroscopic image. A simulation model supports the experimental results and revealed a tradeoff between the smallest detectable scatterer size and the maximum scatterer size in the linear range of the dual-window dual-bandwidth (DWDB) metric, which depends on the choice of the light source optical bandwidth. Spectroscopic OCT (SOCT) images of microspheres and tonsil tissue samples based on the proposed DWDB metric showed clear differentiation between different-sized scatterers as compared to those derived from conventional short-time Fourier transform metrics. The DWDB metric significantly improves the contrast in SOCT imaging and can aid the visualization and identification of dissimilar scatterer size in a sample. Potential applications include the early detection of cell nuclear changes in tissue carcinogenesis, the monitoring of healing tendons, and cell proliferation in tissue scaffolds.     

Nonparametric distance measures of speaker verification

A nonparametric technique for speaker recognition and verification is proposed. The proposed distance measures differ from existing distance measures by their symmetry. These measures have been evaluated on a text-dependent database, achieving a 99.6% verification rate for 200 French speakers. In addition, it is shown that the covariance carries more speaker information than the sample mean     

Performance of DS SS system under on-off wideband jamming

A performance analysis of a direct sequence spread spectrum (DS SS) system under a periodic on-off wideband jammer is presented. Closed-form results of system bit error rate (BER) are derived for all possible cases of jammer duty cycle