Hydroxy- and fluorapatite films on Ti alloy substrates: Sol-gel preparation and characterization

In this paper we describe the preparation of hydroxyfluorapatite (HFA) and fluorapatite (FA) films deposited on titanium alloys by means of the dip-coating method starting from a sol-gel prepared colloidal solution. These materials are compared with hydroxyapatite (HA) films prepared via sol gel and commercial films prepared by means of plasma spray. The film characterization from the point of view of the composition and crystallinity, performed by means of XRD, FTIR and Raman Spectroscopies, has shown a good purity degree, and compositional homogeneity for the sol-gel materials, though traces of carboxy-hydroxy apatite were found. Also, the samples exhibit a good crystallinity. SEM pictures, taken on HA coating deposited via sol-gel, revealed a homogeneous surface structure and optimum features to set up a good prosthesis-tissue interface.     

Influence of membrane oxygenators on the pulsatile flow in extracorporeal circuits: an experimental analysis

An experimental analysis was carried out to evaluate the effects induced by two typical extracorporeal circuits on the pressure and flow generated by a roller pump with a pulsatile module. The hydraulic behaviour of the patient was simulated by means of a mechanical mock-up system consisting of a few lumped parameters reproducing the physiologic vascular impedance. Pressure and flow tracings were acquired at different locations along the circuit using an automatic data acquisition system. Nine lest conditions with different pulse frequency and systolic time values were examined using a mean volumetric flow rate of approximately 4 l/min. A complete analysis of the results obtained in terms of pressure drops and inflow-outflow differences across the components of the arterial line, as well as the calculation of the hydraulic pulsatile power along the circuit, allowed us to assess the influence of the various components upon the pulsatility. The results indicated that the membrane oxygenators tested slightly affect the pulsatility of the flow and the pressure; on the contrary the arterial pipe line is responsible for large damping and head losses. To optimize the use of pulsatile flow for cardiopulmonary bypass it is necessary to reduce the length of the arterial pipe lines thus integrating the circuit as much as possible.     

Ion-exchange kinetics and thermal decomposition characteristics of Fe2+-exchanged alginic acid membrane for the formation of iron oxide nanoparticles

The ion-exchange kinetics of Fe²⁺ cations in aqueous solution with H⁺ from alginic acid have been analyzed in this study as a function of contact time lengths using inductively coupled plasma-atomic emission spectrometry analysis. The kinetic parameters have been evaluated using pseudo 1st or 2nd order models, and a consistent ion-exchange mechanism is suggested. Furthermore, an insight into the calcination of Fe²⁺ ion-exchanged alginic acid process has been obtained by using simultaneous thermo-gravimetric analysis coupled with differential scanning calorimetry and high temperature X-ray diffraction.     

Using Taguchi method to determine optimum process conditions for flue gas desulfurization through an amine scrubber

This study was done to determine the optimum process conditions for absorption of sulfur dioxide in a mixture of flue gases. Using a selective amine-based absorber; a high amount of SO₂ was absorbed in the scrubbing process. The process was designed to reduce the amount of sulfur dioxide. The pilot plant was designed and set up in the Research Center of Petroleum University of Technology, containing absorption and desorption stages. This paper reports an investigation of the effect and optimization of parameters that improve the efficiency of the whole process. The experiments were conducted under varying levels of desorption temperature, pH of the absorber solution, concentration of SO₂ inlet gas, and flow rate of the absorbing solution. Using Taguchi experimental design method, the optimum conditions were identified for the absorption process. An efficiency of more than 99 % could be obtained by varying the parameters in which all the released SO₂ gas was absorbed from the inlet flue gas; an achievement that is much favorable for industrial purposes.     

Osteopenic bone cell response to strontium-substituted hydroxyapatite

Ionic substitution is a powerful tool to improve the biological performance of calcium phosphate based materials. In this work, we investigated the response of primary cultures of rat osteoblasts derived from osteopenic (O-OB) bone to strontium substituted hydroxyapatite (SrHA), and to hydroxyapatite (HA) as reference material, compared to normal (N-OB) bone cells. Strontium (Sr) and calcium (Ca) cumulative releases in physiological solution are in agreement with the greater solubility of SrHA than HA, whereas the differences between the two materials are levelled off in DMEM, which significantly reduced ion release. O-OB cells grown on SrHA exhibited higher proliferation and increased values of the differentiation parameters. In particular, Sr substitution increased the levels of proliferation, alkaline phosphatase, and collagen type I, and down-regulated the production of interleukin-6 of O-OB cells, demonstrating a promising future of SrHA in the treatment of bone lesions and defects in the presence of osteoporotic bone.     

Characterization and optimization of Yb-doped photonic-crystal fiber rod amplifiers using spatially resolved spectral interferometry

Spatially resolved spectral interferometry is used to measure the mode content of a Yb-doped photonic-crystal fiber rod amplifier with a 2300 μm(2) mode area. The technique, known as S(2) imaging, was adapted for the short fiber amplifier at full power and revealed a small amount of a copolarized LP(11) mode. Simulations illustrate the potential for weak mode suppression in this fiber and agree qualitatively with the measurements of S(2) and M(2). Higher-order-mode content depends on the alignment of the input signal at injection and ranged from -18 dB for optimized alignment to -13 dB when the injection alignment was offset along the LP(11) axis by 30% of the 55 μm mode-field diameter.     

Osteoporosis Preclinical Research: A Systematic Review on Comparative Studies Using Ovariectomized Sheep

Sheep ovariectomy (OVX) alone or associated to steroid therapy, deficient diet, or hypothalamic–pituitary disconnection has proven to be of critical importance for osteoporosis research in orthopedics. However, the impact of specific variables, such as breed, age, diet, time after OVX, and other variables, should be monitored. Thus, the design of comparative studies is mandatory to minimize the impact of these variables or to recognize the presence of unwanted variables as well as to better characterize bone remodeling in this model. Herein, we conducted a systematic review of the last 10 years on PubMed, Scopus, and Web of Knowledge considering only studies on OVX sheep where a control group was present. Of the 123 records screened, 18 studies were included and analyzed. Results showed that (i) Merino sheep are the most exploited breed; (ii) 5–6 years of age is the most used time for inducing OVX; (iii) ventral midline laparotomy is the most common approach to induce OVX; (iv) OVX associated to steroid therapy is the most widely used osteoporosis model; and (v) success of OVX was mostly verified 12 months after surgery. In detail, starting from 12 months after OVX a significant decline in bone mineral density and in microarchitectural bone parameters as well as in biochemical markers were detected in all studies in comparison to control groups. Bone alteration was also site-specific on a pattern as follows: lumbar vertebra, femoral neck, and ribs. Before 12 months from OVX and starting from 3–5 months, microarchitectural bone changes and biochemical marker alterations were present when osteoporosis was induced by OVX associated to steroid therapy. In conclusion, OVX in sheep influence bone metabolism causing pronounced systemic bone loss and structural deterioration comparable to the situation found in osteoporosis patients. Data for treating osteoporosis patients are based not only on good planning and study design but also on a correct animal use that, as suggested by 3Rs principles and by ARRIVE guidelines, includes the use of control groups to be directly contrasted with the experimental group.     

Prediction of geological hazardous zones in front of a tunnel face using TSP-203 and artificial neural networks

This research aims at improving the methods of prediction of hazardous geotechnical structures in the front of a tunnel face. We propose and showcase our methodology using a case study on a water supply system in Cheshmeh Roozieh, Iran. Geotechnical investigations had previously reported three measurements of the newly established method of TSP-203 (Tunnel Seismic Prediction) along 684 m of the 3200 m long tunnel up to a depth of 600 m. We use the results of TSP-203 in a trained artificial neural network (ANN) to estimate the unknown nonlinear relationships between TSP-203 results and those obtained by the methods of Rock Mass Rating classification (RMR – treated here as real values). Our results show that an appropriately trained neural network can reliably predict the weak geological zones in front of a tunnel face accurately.