Continuous monitoring of the dynamic behavior of a high‐rise telecommunications tower

This article describes the experimental evaluation of the dynamic effects induced by wind on a high‐rise telecommunications tower based on a permanent monitoring system. Monte da Virgem telecommunications tower is located near the city of Porto (Portugal), and its structure consists in a reinforced concrete shaft and a steel mast, with a total height of 177 m. The monitoring system includes accelerometers, anemometers, and a meteorological station, allowing the characterization of the maximum accelerations of the structure and wind regimes during a period of 6 months. The analysis of the results enabled identifying specific events, denominated as critical events, for which the dynamic response of the tower under wind actions appears significantly amplified due to wind aeroelastic instability phenomena in the steel mast. The automatic identification of the critical events was based on the application to the acceleration's records of an autoregressive model and estimation of its optimal order number based on a singular value decomposition. The results proved the robustness and efficiency of the proposed technique in identifying the number, duration, and maximum amplitude of accelerations associated to the critical events, envisaging its potential integration in structural health monitoring systems.     

On the association between poly(vinyl alcohol) and sodium dodecyl sulfate and its effect on liquid–liquid interfacial tension: A mathematical model

Association between poly(vinyl alcohol-co-vinyl acetate) copolymer (PVA) and sodium dodecyl sulfate (SDS) was studied experimentally and theoretically. It was found that, for the ethyl acetate-aqueous phase interface in which PVA was previously adsorbed, the interfacial tension (γ) increases abruptly to a maximum and then exhibits a relatively mild decay with the addition of SDS to the aqueous phase. The theoretical results indicate that vinyl acetate (VAc) segments determine γ. However, for relatively low concentrations of SDS (C_SDS), this latter plays a major role because through its association with the VAc segments it modulates the extent to which PVA is adsorbed at the interface, indirectly determining the value of γ. As C_SDS approaches to the CMC value for SDS, its influence on γ decreases because SDS tends to self-assembly rather than associates with VAc. These model predictions are consistent with experimental findings reported in the literature.     

Production and purification of a fused recombinant protein gp-36 (HIV-2) from Escherichia coli

A fragment of the gp-36 gene of the Human Immunodeficiency Virus type 2 (HIV-2) was fused to a stabilizer sequence, which encodes for the first N-terminal 58 amino acids of the human interleukin-2. The fused protein was expressed under the control of the tryptophan promoter in Escherichia coli, and expressed as 20% of the total cellular protein. Transmission electron microscopy indicated that the fusion protein formed cytoplasmic insoluble inclusion bodies. Inclusion bodies were semipurified by a wash pellet cell procedure, rendering a material with a purity higher than 70% by SDS–polyacrylamide gel electrophoresis. After solubilization with urea, this preparation was further purified by gel-filtration chromatography up to 95% purity.     

Intralesional Infiltrations of Arteriosclerotic Tissue Cells-Free Filtrate Reproduce Vascular Pathology in Healthy Recipient Rats

Lower-extremity arterial disease is a major health problem with increasing prevalence, often leading to non-traumatic amputation, disability and mortality. The molecular mechanisms underpinning abnormal vascular wall remodeling are not fully understood. We hypothesized on the existence of a vascular tissue memory that may be transmitted through soluble signaling messengers, transferred from humans to healthy recipient animals, and consequently drive the recapitulation of arterial wall thickening and other vascular pathologies. We examined the effects of the intralesional infiltration for 6 days of arteriosclerotic popliteal artery-derived homogenates (100 µg of protein) into rats’ full-thickness wounds granulation tissue. Animals infiltrated with normal saline solution or healthy brachial arterial tissue homogenate obtained from traumatic amputation served as controls. The significant thickening of arteriolar walls was the constant outcome in two independent experiments for animals receiving arteriosclerotic tissue homogenates. This material induced other vascular morphological changes including an endothelial cell phenotypic reprogramming that mirrored the donor’s vascular histopathology. The immunohistochemical expression pattern of relevant vascular markers appeared to match between the human tissue and the corresponding recipient rats. These changes occurred within days of administration, and with no cross-species limitation. The identification of these “vascular disease drivers” may pave novel research avenues for atherosclerosis pathobiology.     

Deciphering the Complex Molecular Pathogenesis of Myotonic Dystrophy Type 1 through Omics Studies

Omics studies are crucial to improve our understanding of myotonic dystrophy type 1 (DM1), the most common muscular dystrophy in adults. Employing tissue samples and cell lines derived from patients and animal models, omics approaches have revealed the myriad alterations in gene and microRNA expression, alternative splicing, 3′ polyadenylation, CpG methylation, and proteins levels, among others, that contribute to this complex multisystem disease. In addition, omics characterization of drug candidate treatment experiments provides crucial insight into the degree of therapeutic rescue and off-target effects that can be achieved. Finally, several innovative technologies such as single-cell sequencing and artificial intelligence will have a significant impact on future DM1 research.     

Adsorption onto fluidized powdered activated carbon flocs-pACF

This work presents a new adsorption technique where the adsorbent (powdered activated carbon-PAC) is in the form of suspended flocs formed with water-soluble polymer flocculants. Thus, the adsorption of a typical dye, methylene blue (MB), was studied onto polyacrylamide flocs of PAC (PACF) in a fluidized bed reactor. The technique is based on the fact that the adsorption capacity of PAC does not decrease after flocculation because the adsorbed polymer occupies only a few surface sites, in the form of trains, loops, and tails. Moreover, the adsorption was found to proceed through a rapid mass transfer of MB to the adsorbing PAC flocs, in the same extent as onto PAC. Because of the rapid settling characteristics of the aggregates formed, the two phase separations, loaded PAC and solution, become easier. Thus, the technique offers the advantages of conducting simultaneously both adsorption and solid/liquid separation all in one single stage. Results obtained showed that high MB removal values can be attained in a fluidized bed reactor (>90%) and that PACF presents a much higher adsorption capacity (breakthrough points) than granulated activated carbon (GAC) in the same adsorbing bed. It is believed that this technique highly broadens the potential of the use of powdered activated carbon or other similar ultrafine adsorbents.     

Thermodynamic and Structural Properties of Sodium Lithium Niobate Solid Solutions

Thermodynamics of the Na_1−xLi _x NbO₃ system is investigated by high-temperature drop-solution calorimetry in molten 3Na₂O–4MoO₃ solvent at 973 K. Standard molar enthalpies of formation are derived. The estimated heats of transition between hypothetical and stable structures, lithium niobate and perovskite for NaNbO₃ and vice versa for LiNbO₃ are −6 kJ/mol and −10 kJ/mol, respectively. X-ray diffraction studies at room temperature showed for 0 ≤ x ≤ 0.14 there are three phases based on different ordering of the perovskite type lattice: orthorhombic with a quadrupled reduced perovskite cell at 0 ≤ x ≤ 0.02, orthorhombic with a doubled reduced perovskite cell at 0.015 ≤ x ≤ 0.14, and rhombohedral at 0.08 ≤ x ≤ 0.13. There are two two-phase (morphotropic) regions with coexistence of the two orthorhombic phases at 0.015 ≤ x ≤ 0.02 and with the second orthorhombic phase coexisting with the rhombohedral phase at 0.08 ≤ x ≤ 0.13. A reproducible anomaly in specific heat at ∼600 K, not reported previously, has been observed in pure NaNbO₃. Heat-capacity measurements confirm a phase transition at 553 K for 0.07 ≤ x ≤ 0.09. With increasing lithium concentration, a gradual disappearance of high-temperature phase transitions associated with tilting of oxygen octahedra has been observed.     

Incorporation and metabolic conversion of erucic acid in various tissues of the rat in short term experiments

Rats were intravenously injected with a mixture of free (14-¹⁴C) erucic acid (22∶1) and (9–10³H) oleic acid (18∶1). After 2, 4, 8, 16, and 30 min, radioactivity was examined in blood, liver, heart, kidneys, and spleen. Free (¹⁴C) 22∶1 disappeared from the blood more rapidly than free (¹⁴C) 18∶1 between 0 and 8 min. Incorporation of label into triglycerides only appeared after 16 min and at 30 min they represented 4% of the injected radioactivity. In this fraction, 63% of¹⁴C radioactivity was present as 18∶1 and not as the original 22∶1, while almost all³H radioactivity was recovered as unchanged 18∶1. At all times studied, the majority of radioactivity was found in the liver, primarily as triglycerides (60% of radioactivity in total lipids) and as phospholipids (20–30%).¹⁴C was present in nearly the same proportion as³H (13% of injected radioactivity after only 2 min, 11% at 30 min).¹⁴C radioactivity was contained in 18∶1 in higher proportion than 22∶1 (45% in triglycerides, 65% in phospholipids). Since labeled triglycerides of blood, rich in (¹⁴C) 18∶1, mainly originate from the liver triglycerides, it appears that 18∶1 is the major form of utilization of 22∶1 in the tissues after its conversion in liver. In the other organs tested, radioactivity was found 10–15 times lower than in liver. In the heart,¹⁴C was 3 to 4 times higher than³H. More than 80% was recovered as 22∶1 in triglycerides. In spleen and kidneys, the¹⁴C:³H ratio was particularly high in free fatty acids and monoglycerides. In kidneys, 60% of¹⁴C was present as nervonic acid (24∶1) in monoglycerides and 40% in phospholipids, suggesting that the mononervonin formed was used for phospholipid biosynthesis. A preliminary report of this work was presented at the 10th International Congress of Nutrition, Kyoto, Japan, August 1975.     

Model selection, identification and validation in anaerobic digestion: a review

Anaerobic digestion enables waste (water) treatment and energy production in the form of biogas. The successful implementation of this process has lead to an increasing interest worldwide. However, anaerobic digestion is a complex biological process, where hundreds of microbial populations are involved, and whose start-up and operation are delicate issues. In order to better understand the process dynamics and to optimize the operating conditions, the availability of dynamic models is of paramount importance. Such models have to be inferred from prior knowledge and experimental data collected from real plants. Modeling and parameter identification are vast subjects, offering a realm of approaches and methods, which can be difficult to fully understand by scientists and engineers dedicated to the plant operation and improvements. This review article discusses existing modeling frameworks and methodologies for parameter estimation and model validation in the field of anaerobic digestion processes. The point of view is pragmatic, intentionally focusing on simple but efficient methods.     

ITER CODAC interface for the visible and infra-red wide angle viewing cameras

The amount of data generated by the infra-red and visible cameras at ITER is expected to be considerably larger than most diagnostics. ITER will have 12 infra-red cameras plus 12 visible cameras in four different equatorial port plugs. Each of the ports will have a Plant System Host (PSH) that will provide a standard image of the plant system to the ITER's Control and Data Access and Communication (CODAC) system.The two key functions of these cameras will be the scientific exploitation with the detection of interesting physics events and the operational protection of the machine, namely the first wall. Already assuming high bandwidth requirements for both audio and video, ITER will provide a separate network for this kind of communication, which will be used to transmit both the experimental and informational data provided by the cameras.This paper presents the current camera plant system design and its interaction with ITER CODAC system and networks. Starting from the camera specifications several alternatives for data collection and compression are discussed. The required inputs from CODAC and a first specification for the internal finite state machine are also presented. Finally, a possible hardware straw man design solution for the plant system hardware is proposed.