Analysis of right ventricular function during bypass of the left side of the heart by afterload alterations in both normal and failing hearts

This study investigated the mechanism of right ventricular failure during bypass of the left side of the heart by precisely assessing right ventricular function with use of a conductance catheter. Bypass of the left side of the heart was established with a centrifugal pump in 10 mongrel dogs weighing 11 to 19 kg. Right ventricular function during left heart bypass was evaluated by two parameters that were both derived from measurement of relative change in right ventricular volume by the conductance catheter technique. One parameter was the right ventricular end-systolic pressure-volume relationship as a load-independent index, and the other was the peak right ventricular pressure-right ventricular stroke volume relationship as a "force-velocity relationship." These parameters were measured in both normal and failing hearts while afterload was increased by bilateral intrapulmonary balloon inflation. Moreover, changes in these relationships were observed by varying assist ratios of left heart bypass from 0% to 100%. Failing heart models were induced by normothermic aortic clamping for 20 minutes. The right ventricular end-systolic pressure-volume relationship in normal hearts did not change, irrespective of the assist ratio of left heart bypass, whereas that in failing hearts decreased from 4.25 +/- 1.41 mm Hg/ml without bypass of the left side of the heart to 3.53 +/- 1.30 mm Hg/ml after 100% assist of left heart bypass (p < 0.05). In the peak right ventricular pressure-right ventricular stroke volume relationship, right ventricular stroke volume was almost constant in normal hearts when afterload was increased regardless of the assist ratio of left heart bypass. Moreover, right ventricular stroke volume was maintained at a higher level during bypass of the left side of the heart compared with that without left heart bypass. However, that slope of the relationship in failing hearts was inversely linear and became significantly steeper after 100% assist of bypass of the left side of the heart compared with that without left heart bypass (-0.131 +/- 0.042 versus -0.051 +/- 0.038, p < 0.005). Therefore ++these two slopes of the relationship intersected at a point that was considered the critical point of afterload during bypass of the left side of the heart. In other words, right ventricular stroke volume was decreased by 100% left heart bypass above the critical point of afterload. In conclusion, this study demonstrates not only that bypass of the left side of the heart results in an increase in right ventricular stroke volume in both normal and failing hearts at the physiologic range of afterload, but also that right ventricular function against higher afterload is impaired by 100% assist of bypass of the left side of the heart in failing hearts.     

Experimental measurement on tangential momentum accommodation coefficient in a single microtube

The tangential momentum accommodation coefficient (TMAC) was investigated experimentally from the mass flow rate through a single microtube under the slip flow and the early part of the transition regime. The measurements were carried out by the constant-volume method under the mean Knudsen number smaller than 0.3, which is based on the mean pressure of the inlet and the outlet of the microtube, to apply the second-order slip boundary condition. To measure TMACs on various materials, quite large microtube was employed, which require the reduction in leakage. TMAC was obtained from the slip coefficient determined by the relation of the mass flow rate to the mean Knudsen number. The obtained mass flow rate was well explained by the theoretical equation. TMACs of deactivated-fused silica with argon, nitrogen, and oxygen were measured, showing the tangential momentum was not accommodated completely to the surface, and the values showed good agreement with previous studies. From the comparison between microtubes with different inner diameter, it is showed that TMAC is determined mainly by gas species and surface material.     

破伤风毒素的提纯及形成离子通道的特性

应用硫酸铵分段沉淀和 Ultrogei AcA_(34)凝胶过滤对破伤风毒进行了提纯,并对形成的离子通道在中毒作用中的功能进行了讨论。提纯的毒素与抗粗制毒素血清形成一条沉淀线,于聚丙烯酰胺凝胶电泳中形成单一的蛋白带,分子量为15万,等电点为5.95,毒力为1～3×10~4MLD/μg 蛋白。给小鼠注射低剂量毒素引起迟发性强直性痉挛;注射高剂量毒素引起快速的类肉毒毒素的松弛性麻痹,直至死亡。应用 Patch clamp 技术,破伤风毒素于人工磷脂膜上形成离子通道。只有当膜两侧存有 pH 梯度时毒素才形成离子通道,因此是 pH 依赖的。通道的电导系数为9 PS。     

Giant neurofibroma of the occipital scalp associated with lambda defect-case report (author's transl)

Calvarial bone defect associated with a hugh neurofibroma in the region of the lambdoid suture was reported in a 42-year-old man with v. Recklinghausen's neurofibromatosis. An enlarging occipital tumor was first noted at age 4 similar to or approximately 5, and an operation was performed at age 12. Lambda defect was noted at that time, but the operative diagnosis was, apparently, "meningocele". Available literature was reviewed, and the significance of calvarial bone defect in the region of the lambdoid suture as a manifestation of v. Recklinghausen's disease was stressed. Lambda defect witn no sclerosing margin, particularly if associated with hypoplasia of the ipsilateral mastoid cells, has been known to represent the primary nature of the bone defect due to mesodermal dysplasia. In the present case, plain radiographs of the skull revealed abnormal sclerotic change around the bone defect. It is suggested that such an osteoblastic change may well indicate the secondary nature of the bone defect due to the presence of overlying neurogenic tumor.     

Hot-water treatment of sol–gel derived SiO2–TiO2 microparticles and application to electrophoretic deposition for thick films

SiO₂–TiO₂ spherical microparticles of about 0.7 μm in diameter were prepared by the sol–gel method. Anatase nanocrystals were formed in the microparticles and their specific surface area was increased after a hot-water treatment at 90 °C. From the changes in the concentration of I₂ photocatalytically generated from KI aqueous solution, the activity of the SiO₂–TiO₂ microparticles was found to increase with increasing the hot-water treatment time. Particulate, thick films were electrophoretically deposited on indium tin oxide (ITO)-coated glass substrates using the anatase nanocrystal-precipitated SiO₂–TiO₂ microparticles. The thickness of the electrophoretically deposited particulate film increased to be approximately 10 μm with an increase in applied voltage. The resultant thick film showed a high photocatalytic activity.     

Radiation damage of SiC Schottky diodes by electron irradiation

The impact of radiation damage on the device performance of 4H-SiC Schottky diodes, which are irradiated at room temperature with 2-MeV electrons is studied. After irradiation the reverse current increases, while the forward current and the capacitance decrease with barrier height and carrier density. The decrease of the barrier height is mainly responsible for the increase of the reverse current, while the decrease of the forward current for a high fluence is caused by the increase of the resistance in the bulk of the crystal. Although no electron capture levels are observed before irradiation, three electron capture levels (E₁, E₂, and E₃) are induced after irradiation. It is noted that the decrease in carrier density is partly caused by the contribution of non-observed electron capture level in the DLT spectrum, which compensates the free carriers.     

Comparative hypocholesterolemic effects of six dietary oils in cholesterol-fed rats after long-term feeding

Rats (8 wk of age) fed a conventional diet were shifted to diets containing 10% Oenothera biennis Linn oil (OBLO, linoleic acid + gamma-linolenic acid) from a wild plant, evening primrose oil (EPO, linoleic acid + gamma-linolenic acid) from a cultivated plant, bio-gamma-linolenic acid oil from mold (BIO, palmitic acid + oleic acid + linoleic acid + gamma-linolenic acid), safflower oil (linoleic acid), palm oil (PLO, palmitic acid + oleic acid + linoleic acid), or soybean oil (linoleic acid + alpha-linolenic acid) with 0.5% cholesterol for 13 wk. Though there were no significant differences in the food intake among the groups, the body weight gain of the OBLO group was significantly lower than that of the other groups except for the BIO and PLO groups, and that of the EPO and SBO groups were the highest among the groups. The liver weight of the OBLO group was significantly lower than that of other groups, and that of the PLO group was the highest among the groups. The serum total cholesterol and very low density lipoprotein (VLDL) + intermediate density lipoprotein (IDL) + low density lipoprotein (LDL) cholesterol concentrations of the OBLO and EPO groups were consistently lower than those in the other groups. However, those of the BIO group were higher than those in the OBLO and EPO groups. The liver cholesterol concentration of the PLO group was the highest among all groups except for the EPO group. The fecal neutral sterol and bile acid extraction of the BIO group tended to increase compared to the other groups. The results of this study demonstrate that OBLO and EPO inhibit the increasing of serum total cholesterol and VLDL + IDL + LDL-cholesterol concentrations in the presence of excess cholesterol in the diet compared with the other dietary oils.     

Sulfidation treatment of copper-containing plating sludge towards copper resource recovery

The present study is concerned with the sulfidation treatment of copper-containing plating sludge towards copper resource recovery by flotation of copper sulfide from treated sludge. The sulfidation treatment was carried out by contacting simulated or real copper plating sludge with Na(2)S solution for a period of 5 min to 24 h. The initial molar ratio of S(2-) to Cu(2+) (S(2-) to Me(2+) in the case of real sludge) was adjusted to 1.00, 1.25 or 1.50, while the solid to liquid ratio was set at 1:50. As a result, it was found that copper compounds were converted to various copper sulfides within the first 5 min. In the case of simulated copper sludge, CuS was identified as the main sulfidation product at the molar ratio of S(2-) to Cu(2+) of 1.00, while Cu(7)S(4) (Roxbyite) was mainly found at the molar ratios of S(2-) to Cu(2+) of 1.50 and 1.25. Based on the measurements of oxidation-reduction potential, the formation of either CuS or Cu(7)S(4) at different S(2-) to Cu(2+) molar ratios was attributed to the changes in the oxidation-reduction potential. By contrast, in the case of sulfidation treatment of real copper sludge, CuS was predominantly formed, irrespective of S(2-) to Me(2+) molar ratio.     

Pseudo-Stokes Vector Correlation From Complex Signal Representation of a Speckle Pattern and Its Applications to Micro-Displacement Measurement

Abstract:  As an improvement of the intensity correlation used widely in conventional electronic speckle photography, we propose a new technique for displacement measurement based on correlating Stokes-like parameters derivatives for transformed speckle patterns. The method is based on a Riesz transform of the intensity speckle pattern, which converts the original real-valued signal into a complex signal. In closest analogy to the polarisation of a vector wave, the Stokes-like vector constructed from the spatial derivative of the generated complex signal has been applied for correlation. Experimental results are presented that demonstrate the validity and advantage of the proposed pseudo-Stokes vector correlation technique over conventional intensity correlation technique.