Several ways to produce porous carbon monoliths by template assisted routes

Several ways to produce microporous and mesoporous carbon monoliths by template assisted synthesis routes are described. Pressed zeolite (HY) and silica powder tablets have been used as templates. Sucrose acts as a carbon precursor and as a binder between the carbon particles as well. In the case of zeolite template, the carbon porosity could be increased by additional loading of the template with ethene. Due to the balance between mechanic stability and porosity of the carbon monolith, an optimal amount of sucrose is required. The final products were characterized by low temperature nitrogen adsorption.     

An integrated 8-12 GHz fractional-N frequency synthesizer in SiGe BiCMOS for satellite communications

We present an integrated fractional-N low-noise frequency synthesizer for satellite applications. By using two integrated VCOs and combining digital and analog tuning techniques, a PLL lock range from 8 to 12 GHz is achieved. Due to a small VCO fine tuning gain and optimized charge pump output biasing, the phase noise is low and almost constant over the tuning range. All 16 sub-bands show a tuning range above 900 MHz each, allowing temperature compensation without sub-band switching. This makes the synthesizer robust against variations of the device parameters with process, supply voltage, temperature and aging. The measured phase noise is ?87 dBc/Hz and ?106 dBc/Hz at 10 kHz and 1 MHz offset, respectively. In integer-N mode, phase noise values down to ?98 dBc/Hz at 10 kHz and ?111 dBc/Hz at 1 MHz offset, respectively, were measured.     

Combination of coating and heat treatment processes

For a proper use of coated tools and components excellent coating properties as well as excellent substrate properties of the coating/substrate composite are necessary. A well known example is the load support of hard steel substrates for thin wear resistant coatings. Therefore coating processes must be combined with heat treatment processes of the substrates, whereby several practical processing constraints like order and compatibility of the applied treatment procedures must be considered. The combination of CVD-coating plus laser beam hardening is an example of a post coating heat treatment. Applications may be possible for large forming tools made of high alloyed tool steels, which nowadays are usually through hardened after CVD-coating. Laser beam hardening offers the possibility, to harden only the highly loaded edges of the tools. The advantages of this combination are short process time, less distortion and compressive residual stresses in the substrate surface. CVD-coatings can endure laser beam hardening with suitable parameters. The influence of CVD TiN-coated steel substrates and laser beam hardening parameters on microstructures and properties of coating/substrate compounds have been investigated. Special attention was paid to overlapping hardening zones, which may occur at the start and end points of a laser hardened track. In summary, the combination of coating and heat treatment processes show a high potential to produce coating/substrate compounds with excellent coating properties as well as excellent substrate properties.     

The effects of behavioral tasks on the in vitro phosphorylation of intermediate filament subunits of rat hippocampus are mediated by CaMKII and PKA

In the homodimeric hemoglobin from Scapharca, HbI, functional communication between the two heme groups is based on their direct structural linkage across the subunit interface through the heme propionates. The heme-protein interactions have been altered in deutero- and meso-HbI by substituting the vinyl groups at positions 2 and 4 of protoheme with hydrogen and ethyl groups, respectively. In meso-HbI the introduction of the ethyl groups in the heme pocket induces significant alterations in the conformation of the heme peripheral substituents, including the propionates, and in the structure of bound CO, as revealed by the resonance Raman spectra. The functional counterpart of these structural changes is the loss of cooperativity in carbon monoxide binding and in the rate of oxygen dissociation. Oxygen pulse and flash photolysis experiments indicate that meso-HbI is locked in the liganded conformation. It is postulated that the ethyl groups, which occupy a larger volume than vinyl ones, impair the ligand-linked movement of the heme relative to its pocket and in turn the expression of cooperativity. In deutero-HbI structural alterations have not been monitored. Functionally, cooperativity in the CO binding kinetics is increased as if hydrogen atoms at positions 2 and 4 permitted more marked movements of the heme than in the native protein.     

Improving metastable impact electron spectroscopy and ultraviolet photoelectron spectroscopy signals by means of a modified time-of-flight separation

The separation of ultraviolet photoelectron spectroscopy (UPS) and metastable impact electron spectroscopy (MIES) is usually performed by a time-of-flight (ToF) separation using pre-set ToF for both types of signal. In this work, we present a new, improved ex situ signal separation method for the separation of MIES and UPS for every single measurement. Signal separation issues due to changes of system parameters can be overcome by changing the ToF separation and therefore allowing for the application of a wider range of measuring conditions. The method also enables to identify and achieve separation of the two signals without any time consuming calibration and the use of any special material for the calibration. Furthermore, changes made to the discharge source are described that enable to operate an existing MIES/UPS source over a broader range of conditions. This allows for tuning of the yield of UV photons and metastable rare gas atoms leading to an improved signal to noise ratio. First results of this improved setup are well in agreement with spectra reported in literature and show increased resolution and higher signal intensities for both MIE and UP spectra compared to the previous, non-optimized setup.     

Synthesis and Biochemical Evaluation of Biotinylated Conjugates of Largazole Analogues: Selective Class I Histone Deacetylase Inhibitors

The synthesis of biotinylated conjugates of synthetic analogues of the potent and selective histone deacetylase (HDAC) inhibitor largazole is reported. The thiazole moiety of the parent compound's cap group was derivatized to allow the chemical conjugation to biotin. The derivatized largazole analogues were assayed across a panel of HDACs 1–9 and retained potent and selective inhibitory activity towards the class I HDAC isoforms. The biotinylated conjugate was further shown to pull down HDACs 1, 2, and 3.     

阿维斯塔波莱瑞特厂炉卷轧机新技术

阿维斯塔波莱瑞特厂正在进行一个现代化改造项目，以提高炉卷轧机的生产能力，达到年产100万吨。但是，由于在阿维斯塔波莱瑞特厂炉卷轧机上的现有技术已达到极限，只有通过对轧机及自动化系统进行现代化的改造才有可能提高和增强轧机的利用率和易维护性。     

Nanoparticle formation in H2O/N2 and H2O/Ar mixtures under irradiation by 20 MeV protons and positive corona discharge

To investigate the contribution of ions to gas nucleation, we have performed experiments on the formation of water droplets in H₂O/N₂ and H₂O/Ar gas mixtures by irradiation with a 20 MeV proton beam and by positive corona discharge. The size of the formed nanoparticles was measured using a differential mobility analyzer equipped with a Faraday cup electrometer. Using the proton beam, droplets around 10 nm in diameter were observed for both positively and negatively charged particles, but none were found when the corona discharge was used. This implies the importance of the presence of both positive and negative ions for the formation of nanosize droplets, which attract each other by Coulomb interactions, enhancing the collision frequency and leading to the formation of the 10 nm droplets.     

Drag reduction by DNA-grafting for single microspheres in a dilute λ-DNA solution

The fluid resistance of single micrometre-sized blank and DNA-grafted polystyrene microspheres under shear flow is compared in purified water and dilute λ-DNA solutions by means of optical tweezers experiments with a high spatial (±4 nm) and temporal (±0.2 ms) resolution. The measurement results show that the drag experienced by a colloid in a dilute λ-DNA solution (molecular weight of 48,502 bp per molecule, radius of gyration of 0.5 μm) is significantly decreased if the microsphere bears a grafted DNA brush. This newly discovered drag reduction effect is studied for different parameters, comprising the molecular weight of the grafted DNA molecules (250 bp, 1000 bp and 4000 bp), the concentration of the λ-DNA solution (11, 17 and 23 μg ml^?1, all being significantly smaller than the critical entanglement concentration c¹), the microsphere core diameter (2 μm, 3 μm and 6 μm) as well as the flow speed of the medium (10–50 μm s^?1). The maximum extent of the drag reduction is found to amount to (60 ± 20)% compared to the λ-DNA-induced contribution on the drag acting on blank colloids. We propose a theoretical explanation of this effect based on the combination of the dynamic density functional theory of Rauscher and co-workers [Rauscher M. J. Phys.: Condens. Matter 2010;22:364109] and the stagnation length theory of polymer brushes, as it was established by Kim, Lobaskin et al. [Kim et al. Macromolecules 2008;42(10):3650–3655]. In particular, the solution of the Stokes equation (i.e., the Navier–Stokes equation for creeping flow) for the studied system yields a numerical prediction that is found to be in full accord with our experimental results within measurement uncertainty.