The Mechanism of Mechanochemical Interaction between Amorphous Silicon Dioxide and Pyrocatechol

Silicon - The products of solid-phase mechanochemical interaction between pyrocatechol and silicon dioxide yielding a powdered composite were studied using a number of physicochemical methods. This...     

Classification of Reconfigurable Parallel Mechanisms

Russian Engineering Research - The theoretically possible reconfigurable parallel mechanisms are classified, in terms of the layout of guides on the base. Formulas are derived for the...     

Use of radial forces for fault detection in tapping

A model-based method for fault detection in tapping based on torque and radial forces is proposed. The method allows the identification of faults typical of a tapping operation including axial misalignment, tap runout, tooth breakage both singly and together. The validation experiments have been run on aluminum 356 workpieces for different combinations of process faults. Results have shown that the model predictions are in good agreement with the experimental radial force and torque signals under various fault conditions.     

Synthesis of Sialon from Kaolin and Its Phase Formation

The main phase transformations during synthesis of β‐sialon from kaolin of the Prosyanovskii deposit (Ukraine) under test-industrial production conditions have been studied. Sialon was prepared by carbothermal reduction in graphite-tube furnaces in nitrogen. It is shown that the process is characterized by the simultaneous occurrence of several chemical reactions with formation of intermediate phases (Si₂ON₂, X₁‐phase), silicon carbide, and (apart from β‐sialon) sialons based on AlN polytypes. The phase composition of the final product is determined not only by the charge composition but also by the set of production parameters. Results of the work may provide a basis for commercial preparation of sialon powder.     

1/f noise and self-organized criticality in crisis regimes of heat and mass transfer

Thermal fluctuations under the transition from nucleate to film boiling of water on a wire heater and fluctuations of jet form during an outflow of superheated liquid from a pressure vessel were experimentally investigated. It has been found that power spectrum of the fluctuations has got a low frequency component corresponding to a 1/f law (flicker noise).The effect given is connected with the occurrence of nonequilibrium phase transitions in the systems: a crisis of heat transfer under the transition from nucleate to film boiling and a crisis of a flow in boiling-up of superheated liquid jet.     

Helicoseir as Shape of a Rotating String (I): 2D Theory and Simulation Using ANCF

A physically simple but mathematically cumbersome problem of rotating heavy string with one fixed top point was studied. A nonlinear equation of its two-dimensional shapes of relative equilibrium was obtained and solved numerically. A linear case of small displacements was analyzed in terms of Bessel functions. The qualitative and quantitative behavior of the problem is discussed with the help of a bifurcation diagram. Dynamics of the two-dimensional model near the equilibrium positions were studied with the help of a simulation using the absolute nodal coordinate formulation (ANCF); the equilibriums were found to be instable. The reason for instability is explained using a variational principle. The outlines for further full three-dimensional analysis are briefly proposed in this paper, and the full derivation will be explained in the next paper.     

The equilibrium partitioning of titanium between Ti3+ and Ti4+ valency states in CaO-SiO2-TiO x slags

The redox behavior of titanium in CaO-SiO₂-TiO _x melts was investigated using a slag-gas equilibrium technique. Titanium partitioning between Ti³⁺ and Ti⁴⁺ valency states and the ratio of activity coefficients of TiO_1.5 and TiO₂ were determined as functions of oxygen partial pressure, temperature, and slag composition. The equilibrium experiments were carried out at temperatures between 1783 and 1903 K under CO-CO₂-Ar gas atmosphere with oxygen partial pressure ranging from 10⁻¹² to 10⁻⁷ atm (1.01×10⁻¹⁰ kPa to 1.01×10⁻⁵ kPa). The slags had CaO/SiO₂ ratios between 0.55 and 1.35 and total titanium oxide concentrations from 7 to 50 mass pct. Experimental results showed that the Ti³⁺/Ti⁴⁺ ratio in CaO-SiO₂-TiO _x slags, containing up to 50 mass pct TiO _x , increased with decreasing oxygen partial pressure and decreased with increasing CaO/SiO₂ ratio and decreasing temperature. Measured variation of the redox ratio Ti³⁺/Ti⁴⁺ with oxygen partial pressure closely followed the ideal behavior. Increasing the CaO/SiO₂ ratio increased the ratio of activity coefficients of TiO_1.5 and TiO₂. The effect of total titania content on this ratio was more complex and in accord with Raman spectroscopy data.