巴基斯坦：穆斯林美食大秀场

巴基斯坦的美食充满了穆斯林特色以及南亚的特有香料所带来的奇异口感，蕴涵着阿富汗、土耳其和伊朗的中东风情，杂糅着欧洲、美洲与中国的美食特色，再加上历史上与印度的千丝万缕的联系，又使这里美食风格带着浓郁的印度风味。[编者按]     

川中丘陵区一种新型小流域径流输沙模型的建立与应用

径流输沙模型对定量评价水沙的输出响应具有重要的意义。本研究在已有研究成果的基础上，通过对四川盐亭县林山西沟小流域的径流、泥沙进行现场观测与分析，提出含沙量单位线的定义及其确定方法，建立了适应该小流域的径流输沙模型。并应用实测资料进行比较，表明模型的模拟结果可靠，模拟过程确定性系数达0．8以上，为川中丘陵区小流域径流输沙过程的预测预报提供了一个新方法。     

Tunable circular patch antennas

A method to control the resonant or operating frequencies of circular patch antennas has been investigated experimentally and theoretically. It consists of the placement of passive metallic or tuning posts at approximate locations within the input region of the antenna. Comparison of measured and analytical results seems to establish the validity of a theoretical model proposed to determine the input performance of such circular patch antennas.     

Model concrete beam-column joints subjected to cyclic loading at two rates

Small-scale models of reinforced concrete beam-column joint were subjected to large cyclic displacements at two rates: 2.5×10⁻³ and 1.0 Hz. To assess damage, free-vibration tests were conducted. The reliability of the modelling techniques was established by comparison of the results for the slower rate with those obtained from the full-scale tests on prototype. The higher rate of loading caused a greater damage than that at the lower rate. This was evidenced by the measurements of the energy absorbed in the hysteresis loops, equivalent damping, and the stiffness and damping obtained from the free-vibration test. The relatively greater extent of damage appears to result from the different bond behaviour at different rates of loading.     

Interpretation of scatterometer ocean surface wind vector EOFs over the Northwestern Pacific

Satellite scatterometer winds over the northwestern Pacific were analyzed with the vector empirical orthogonal function (VEOF) method. The Hilbert-Huang transform (HHT), a newly developed non-linear and non-stationary time series data processing method, was also employed in the analysis. A combination of European Remote Sensing Satellite (ERS) −1/2 scatterometer, NASA Scatterometer (NSCAT) and NASA's Quick Scatterometer (QuikSCAT) winds covering the period from January 1992 to April 2000 and the area of 0-50°N, 100-148°E constitutes the baseline for this study. The results indicate that annual cycles dominate the two leading VEOF modes. The first VEOF shows the East Asian monsoon features and the second represents a spring-autumn oscillation. We removed the annual signal from the data set and calculated the interannual VEOFs. The first interannual VEOF represents the interannual variability existing in the spring-autumn oscillation. The temporal mode is correlated with the Southern Oscillation Index (SOI), but has a half-year lag with respect to the SOI. The spatial mode of the first interannual VEOF reflects the response of the tropical and extratropical winds to ENSO events. The second interannual VEOF is another ENSO related mode, and the temporal VEOF mode is correlated with the SOI with a correlation coefficient of 0.78, revealing the wind variability over mid-latitudes, which is associated with ENSO events. Further analysis indicated that the wind variability over the coast of East Asia represents anomalies of a Hadley cell. The quasi-biennial oscillation (QBO) was found in the temporal mode, indicating and verifying that the QBO in the wind fields is related to ENSO events. The third VEOF shows the interannaul variability in the winter-summer mode and displays the interannual variability of the East Asian monsoon. The three leading interannual VEOFs are statistically meaningful as confirmed by a significance test.     

催化裂化技术现状及发展趋势

详述了国内外最新渣油催化裂化、多产柴油催化裂化、低碳烯烃催化裂化、生产清洁燃料催化裂化及催化剂的技术进展，同时根据我国实际情况对今后催化裂化技术的发展提出了建议。     

钛铁矿流态化氧化机理研究

对低品位钛铁矿进行预氧化、预还原等预处理后可满足硫酸法生产钛白粉工艺所需高品位钛铁矿的要求。本试验采用流态化预氧化方法处理风化程度低、含硫较高的钛铁矿。结果表明 :流态化氧化可大幅度地降低钛铁矿中硫含量 ;钛铁矿流态化氧化的适宜温度为 :80 0～ 90 0℃ ,且在此温度范围内 ,随温度的升高 ,钛铁矿的氧化速度增加 ,在 90 0℃时 ,5 0min钛铁矿基本能完成氧化     

Strategies to increase CdTe solar-cell voltage

There is a significant difference in performance between today's highest efficiency of CdTe solar cells and single-crystal cells of comparable band gap. The largest contribution to this difference is the voltage, where the values for the best CdTe cells are about 230 mV below the best GaAs cells when an appropriate adjustment is made for band gap. CdTe voltage and fill-factor are currently compromised by low recombination lifetime (near 1 ns), low hole density (near 10¹⁴ cm^− 3), and in some cases an excessive back-contact barrier. Numerical simulation is used to evaluate how combinations of lifetime, carrier density, back electron reflection, and interfacial properties affect voltage and cell performance. Two different strategies for improving voltage and performance are explored.     

Deposition and Properties of Superconducting MgB2 Thin Films

The recently discovered superconductor MgB₂ with T _c at 39 K has great potential in superconducting electronics. In this paper, we review the deposition techniques used for MgB₂ thin films in the light of a thermodynamic study of the Mg-B system with the calculation of phase diagrams (CALPHAD) modeling technique. This thermodynamic study identifies a growth window in the pressure–temperature phase diagram, in which the magnesium pressure is very high for likely in situ growth temperatures. A Hybrid Physical–Chemical Vapor Deposition (HPCVD) technique that successfully achieves such a high Mg pressure is shown to produce in situ epitaxial MgB₂ thin films with bulk superconducting properties.     

Chemical compositions and optical properties of HfOxNy thin films at different substrate temperatures

High-k HfO_xN_y thin films have been grown by radio frequency (rf) reactive sputtering of metal Hf target in N₂/Ar/O₂ ambient at different substrate temperatures. The chemical compositions of the films have been investigated as a function of substrate temperature by X-ray photoelectron spectroscopy (XPS). XPS measurements showed that nitrogen concentration increases with an increase in substrate temperature. Room-temperature spectroscopic ellipsometry (SE) with photon energy 0.75–6.5 eV was used to investigate the optical properties of the films. SE results demonstrated that refractive index n increases with an increase in substrate temperature. Based on TL parameters which were obtained from the best fit results used in a simulation of the measured spectra, meanwhile, we conclude that the energy band gap (E_g) decreases with an increase in substrate temperature.